diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/fb/tridentfb.txt | 70 |
1 files changed, 70 insertions, 0 deletions
diff --git a/Documentation/fb/tridentfb.txt b/Documentation/fb/tridentfb.txt new file mode 100644 index 000000000..45d9de5b1 --- /dev/null +++ b/Documentation/fb/tridentfb.txt @@ -0,0 +1,70 @@ +Tridentfb is a framebuffer driver for some Trident chip based cards. + +The following list of chips is thought to be supported although not all are +tested: + +those from the TGUI series 9440/96XX and with Cyber in their names +those from the Image series and with Cyber in their names +those with Blade in their names (Blade3D,CyberBlade...) +the newer CyberBladeXP family + +All families are accelerated. Only PCI/AGP based cards are supported, +none of the older Tridents. +The driver supports 8, 16 and 32 bits per pixel depths. +The TGUI family requires a line length to be power of 2 if acceleration +is enabled. This means that range of possible resolutions and bpp is +limited comparing to the range if acceleration is disabled (see list +of parameters below). + +Known bugs: +1. The driver randomly locks up on 3DImage975 chip with acceleration + enabled. The same happens in X11 (Xorg). +2. The ramdac speeds require some more fine tuning. It is possible to + switch resolution which the chip does not support at some depths for + older chips. + +How to use it? +============== + +When booting you can pass the video parameter. +video=tridentfb + +The parameters for tridentfb are concatenated with a ':' as in this example. + +video=tridentfb:800x600-16@75,noaccel + +The second level parameters that tridentfb understands are: + +noaccel - turns off acceleration (when it doesn't work for your card) + +fp - use flat panel related stuff +crt - assume monitor is present instead of fp + +center - for flat panels and resolutions smaller than native size center the + image, otherwise use +stretch + +memsize - integer value in KB, use if your card's memory size is misdetected. + look at the driver output to see what it says when initializing. + +memdiff - integer value in KB, should be nonzero if your card reports + more memory than it actually has. For instance mine is 192K less than + detection says in all three BIOS selectable situations 2M, 4M, 8M. + Only use if your video memory is taken from main memory hence of + configurable size. Otherwise use memsize. + If in some modes which barely fit the memory you see garbage + at the bottom this might help by not letting change to that mode + anymore. + +nativex - the width in pixels of the flat panel.If you know it (usually 1024 + 800 or 1280) and it is not what the driver seems to detect use it. + +bpp - bits per pixel (8,16 or 32) +mode - a mode name like 800x600-8@75 as described in + Documentation/fb/modedb.txt + +Using insane values for the above parameters will probably result in driver +misbehaviour so take care(for instance memsize=12345678 or memdiff=23784 or +nativex=93) + +Contact: jani@astechnix.ro |