diff options
Diffstat (limited to 'arch/arm/mach-ixp4xx/ixdp425-setup.c')
-rw-r--r-- | arch/arm/mach-ixp4xx/ixdp425-setup.c | 317 |
1 files changed, 317 insertions, 0 deletions
diff --git a/arch/arm/mach-ixp4xx/ixdp425-setup.c b/arch/arm/mach-ixp4xx/ixdp425-setup.c new file mode 100644 index 000000000..3ec829d52 --- /dev/null +++ b/arch/arm/mach-ixp4xx/ixdp425-setup.c @@ -0,0 +1,317 @@ +// SPDX-License-Identifier: GPL-2.0 +/* + * arch/arm/mach-ixp4xx/ixdp425-setup.c + * + * IXDP425/IXCDP1100 board-setup + * + * Copyright (C) 2003-2005 MontaVista Software, Inc. + * + * Author: Deepak Saxena <dsaxena@plexity.net> + */ + +#include <linux/kernel.h> +#include <linux/init.h> +#include <linux/device.h> +#include <linux/serial.h> +#include <linux/tty.h> +#include <linux/serial_8250.h> +#include <linux/gpio/machine.h> +#include <linux/io.h> +#include <linux/mtd/mtd.h> +#include <linux/mtd/rawnand.h> +#include <linux/mtd/partitions.h> +#include <linux/delay.h> +#include <linux/gpio.h> +#include <asm/types.h> +#include <asm/setup.h> +#include <asm/memory.h> +#include <mach/hardware.h> +#include <asm/mach-types.h> +#include <asm/irq.h> +#include <asm/mach/arch.h> +#include <asm/mach/flash.h> + +#define IXDP425_SDA_PIN 7 +#define IXDP425_SCL_PIN 6 + +/* NAND Flash pins */ +#define IXDP425_NAND_NCE_PIN 12 + +#define IXDP425_NAND_CMD_BYTE 0x01 +#define IXDP425_NAND_ADDR_BYTE 0x02 + +static struct flash_platform_data ixdp425_flash_data = { + .map_name = "cfi_probe", + .width = 2, +}; + +static struct resource ixdp425_flash_resource = { + .flags = IORESOURCE_MEM, +}; + +static struct platform_device ixdp425_flash = { + .name = "IXP4XX-Flash", + .id = 0, + .dev = { + .platform_data = &ixdp425_flash_data, + }, + .num_resources = 1, + .resource = &ixdp425_flash_resource, +}; + +#if defined(CONFIG_MTD_NAND_PLATFORM) || \ + defined(CONFIG_MTD_NAND_PLATFORM_MODULE) + +static struct mtd_partition ixdp425_partitions[] = { + { + .name = "ixp400 NAND FS 0", + .offset = 0, + .size = SZ_8M + }, { + .name = "ixp400 NAND FS 1", + .offset = MTDPART_OFS_APPEND, + .size = MTDPART_SIZ_FULL + }, +}; + +static void +ixdp425_flash_nand_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl) +{ + struct nand_chip *this = mtd_to_nand(mtd); + int offset = (int)nand_get_controller_data(this); + + if (ctrl & NAND_CTRL_CHANGE) { + if (ctrl & NAND_NCE) { + gpio_set_value(IXDP425_NAND_NCE_PIN, 0); + udelay(5); + } else + gpio_set_value(IXDP425_NAND_NCE_PIN, 1); + + offset = (ctrl & NAND_CLE) ? IXDP425_NAND_CMD_BYTE : 0; + offset |= (ctrl & NAND_ALE) ? IXDP425_NAND_ADDR_BYTE : 0; + nand_set_controller_data(this, (void *)offset); + } + + if (cmd != NAND_CMD_NONE) + writeb(cmd, this->IO_ADDR_W + offset); +} + +static struct platform_nand_data ixdp425_flash_nand_data = { + .chip = { + .nr_chips = 1, + .chip_delay = 30, + .partitions = ixdp425_partitions, + .nr_partitions = ARRAY_SIZE(ixdp425_partitions), + }, + .ctrl = { + .cmd_ctrl = ixdp425_flash_nand_cmd_ctrl + } +}; + +static struct resource ixdp425_flash_nand_resource = { + .flags = IORESOURCE_MEM, +}; + +static struct platform_device ixdp425_flash_nand = { + .name = "gen_nand", + .id = -1, + .dev = { + .platform_data = &ixdp425_flash_nand_data, + }, + .num_resources = 1, + .resource = &ixdp425_flash_nand_resource, +}; +#endif /* CONFIG_MTD_NAND_PLATFORM */ + +static struct gpiod_lookup_table ixdp425_i2c_gpiod_table = { + .dev_id = "i2c-gpio.0", + .table = { + GPIO_LOOKUP_IDX("IXP4XX_GPIO_CHIP", IXDP425_SDA_PIN, + NULL, 0, GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN), + GPIO_LOOKUP_IDX("IXP4XX_GPIO_CHIP", IXDP425_SCL_PIN, + NULL, 1, GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN), + }, +}; + +static struct platform_device ixdp425_i2c_gpio = { + .name = "i2c-gpio", + .id = 0, + .dev = { + .platform_data = NULL, + }, +}; + +static struct resource ixdp425_uart_resources[] = { + { + .start = IXP4XX_UART1_BASE_PHYS, + .end = IXP4XX_UART1_BASE_PHYS + 0x0fff, + .flags = IORESOURCE_MEM + }, + { + .start = IXP4XX_UART2_BASE_PHYS, + .end = IXP4XX_UART2_BASE_PHYS + 0x0fff, + .flags = IORESOURCE_MEM + } +}; + +static struct plat_serial8250_port ixdp425_uart_data[] = { + { + .mapbase = IXP4XX_UART1_BASE_PHYS, + .membase = (char *)IXP4XX_UART1_BASE_VIRT + REG_OFFSET, + .irq = IRQ_IXP4XX_UART1, + .flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST, + .iotype = UPIO_MEM, + .regshift = 2, + .uartclk = IXP4XX_UART_XTAL, + }, + { + .mapbase = IXP4XX_UART2_BASE_PHYS, + .membase = (char *)IXP4XX_UART2_BASE_VIRT + REG_OFFSET, + .irq = IRQ_IXP4XX_UART2, + .flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST, + .iotype = UPIO_MEM, + .regshift = 2, + .uartclk = IXP4XX_UART_XTAL, + }, + { }, +}; + +static struct platform_device ixdp425_uart = { + .name = "serial8250", + .id = PLAT8250_DEV_PLATFORM, + .dev.platform_data = ixdp425_uart_data, + .num_resources = 2, + .resource = ixdp425_uart_resources +}; + +/* Built-in 10/100 Ethernet MAC interfaces */ +static struct eth_plat_info ixdp425_plat_eth[] = { + { + .phy = 0, + .rxq = 3, + .txreadyq = 20, + }, { + .phy = 1, + .rxq = 4, + .txreadyq = 21, + } +}; + +static struct platform_device ixdp425_eth[] = { + { + .name = "ixp4xx_eth", + .id = IXP4XX_ETH_NPEB, + .dev.platform_data = ixdp425_plat_eth, + }, { + .name = "ixp4xx_eth", + .id = IXP4XX_ETH_NPEC, + .dev.platform_data = ixdp425_plat_eth + 1, + } +}; + +static struct platform_device *ixdp425_devices[] __initdata = { + &ixdp425_i2c_gpio, + &ixdp425_flash, +#if defined(CONFIG_MTD_NAND_PLATFORM) || \ + defined(CONFIG_MTD_NAND_PLATFORM_MODULE) + &ixdp425_flash_nand, +#endif + &ixdp425_uart, + &ixdp425_eth[0], + &ixdp425_eth[1], +}; + +static void __init ixdp425_init(void) +{ + ixp4xx_sys_init(); + + ixdp425_flash_resource.start = IXP4XX_EXP_BUS_BASE(0); + ixdp425_flash_resource.end = + IXP4XX_EXP_BUS_BASE(0) + ixp4xx_exp_bus_size - 1; + +#if defined(CONFIG_MTD_NAND_PLATFORM) || \ + defined(CONFIG_MTD_NAND_PLATFORM_MODULE) + ixdp425_flash_nand_resource.start = IXP4XX_EXP_BUS_BASE(3), + ixdp425_flash_nand_resource.end = IXP4XX_EXP_BUS_BASE(3) + 0x10 - 1; + + gpio_request(IXDP425_NAND_NCE_PIN, "NAND NCE pin"); + gpio_direction_output(IXDP425_NAND_NCE_PIN, 0); + + /* Configure expansion bus for NAND Flash */ + *IXP4XX_EXP_CS3 = IXP4XX_EXP_BUS_CS_EN | + IXP4XX_EXP_BUS_STROBE_T(1) | /* extend by 1 clock */ + IXP4XX_EXP_BUS_CYCLES(0) | /* Intel cycles */ + IXP4XX_EXP_BUS_SIZE(0) | /* 512bytes addr space*/ + IXP4XX_EXP_BUS_WR_EN | + IXP4XX_EXP_BUS_BYTE_EN; /* 8 bit data bus */ +#endif + + if (cpu_is_ixp43x()) { + ixdp425_uart.num_resources = 1; + ixdp425_uart_data[1].flags = 0; + } + + gpiod_add_lookup_table(&ixdp425_i2c_gpiod_table); + platform_add_devices(ixdp425_devices, ARRAY_SIZE(ixdp425_devices)); +} + +#ifdef CONFIG_ARCH_IXDP425 +MACHINE_START(IXDP425, "Intel IXDP425 Development Platform") + /* Maintainer: MontaVista Software, Inc. */ + .map_io = ixp4xx_map_io, + .init_early = ixp4xx_init_early, + .init_irq = ixp4xx_init_irq, + .init_time = ixp4xx_timer_init, + .atag_offset = 0x100, + .init_machine = ixdp425_init, +#if defined(CONFIG_PCI) + .dma_zone_size = SZ_64M, +#endif + .restart = ixp4xx_restart, +MACHINE_END +#endif + +#ifdef CONFIG_MACH_IXDP465 +MACHINE_START(IXDP465, "Intel IXDP465 Development Platform") + /* Maintainer: MontaVista Software, Inc. */ + .map_io = ixp4xx_map_io, + .init_early = ixp4xx_init_early, + .init_irq = ixp4xx_init_irq, + .init_time = ixp4xx_timer_init, + .atag_offset = 0x100, + .init_machine = ixdp425_init, +#if defined(CONFIG_PCI) + .dma_zone_size = SZ_64M, +#endif +MACHINE_END +#endif + +#ifdef CONFIG_ARCH_PRPMC1100 +MACHINE_START(IXCDP1100, "Intel IXCDP1100 Development Platform") + /* Maintainer: MontaVista Software, Inc. */ + .map_io = ixp4xx_map_io, + .init_early = ixp4xx_init_early, + .init_irq = ixp4xx_init_irq, + .init_time = ixp4xx_timer_init, + .atag_offset = 0x100, + .init_machine = ixdp425_init, +#if defined(CONFIG_PCI) + .dma_zone_size = SZ_64M, +#endif +MACHINE_END +#endif + +#ifdef CONFIG_MACH_KIXRP435 +MACHINE_START(KIXRP435, "Intel KIXRP435 Reference Platform") + /* Maintainer: MontaVista Software, Inc. */ + .map_io = ixp4xx_map_io, + .init_early = ixp4xx_init_early, + .init_irq = ixp4xx_init_irq, + .init_time = ixp4xx_timer_init, + .atag_offset = 0x100, + .init_machine = ixdp425_init, +#if defined(CONFIG_PCI) + .dma_zone_size = SZ_64M, +#endif +MACHINE_END +#endif |