diff options
Diffstat (limited to 'drivers/net/ethernet/8390/8390.h')
| -rw-r--r-- | drivers/net/ethernet/8390/8390.h | 225 |
1 files changed, 225 insertions, 0 deletions
diff --git a/drivers/net/ethernet/8390/8390.h b/drivers/net/ethernet/8390/8390.h new file mode 100644 index 000000000..3e2f2c2e7 --- /dev/null +++ b/drivers/net/ethernet/8390/8390.h @@ -0,0 +1,225 @@ +/* Generic NS8390 register definitions. */ +/* This file is part of Donald Becker's 8390 drivers, and is distributed + under the same license. Auto-loading of 8390.o only in v2.2 - Paul G. + Some of these names and comments originated from the Crynwr + packet drivers, which are distributed under the GPL. */ + +#ifndef _8390_h +#define _8390_h + +#include <linux/if_ether.h> +#include <linux/ioport.h> +#include <linux/irqreturn.h> +#include <linux/skbuff.h> + +#define TX_PAGES 12 /* Two Tx slots */ + +/* The 8390 specific per-packet-header format. */ +struct e8390_pkt_hdr { + unsigned char status; /* status */ + unsigned char next; /* pointer to next packet. */ + unsigned short count; /* header + packet length in bytes */ +}; + +#ifdef CONFIG_NET_POLL_CONTROLLER +void ei_poll(struct net_device *dev); +void eip_poll(struct net_device *dev); +#endif + + +/* Without I/O delay - non ISA or later chips */ +void NS8390_init(struct net_device *dev, int startp); +int ei_open(struct net_device *dev); +int ei_close(struct net_device *dev); +irqreturn_t ei_interrupt(int irq, void *dev_id); +void ei_tx_timeout(struct net_device *dev); +netdev_tx_t ei_start_xmit(struct sk_buff *skb, struct net_device *dev); +void ei_set_multicast_list(struct net_device *dev); +struct net_device_stats *ei_get_stats(struct net_device *dev); + +extern const struct net_device_ops ei_netdev_ops; + +struct net_device *__alloc_ei_netdev(int size); +static inline struct net_device *alloc_ei_netdev(void) +{ + return __alloc_ei_netdev(0); +} + +/* With I/O delay form */ +void NS8390p_init(struct net_device *dev, int startp); +int eip_open(struct net_device *dev); +int eip_close(struct net_device *dev); +irqreturn_t eip_interrupt(int irq, void *dev_id); +void eip_tx_timeout(struct net_device *dev); +netdev_tx_t eip_start_xmit(struct sk_buff *skb, struct net_device *dev); +void eip_set_multicast_list(struct net_device *dev); +struct net_device_stats *eip_get_stats(struct net_device *dev); + +extern const struct net_device_ops eip_netdev_ops; + +struct net_device *__alloc_eip_netdev(int size); +static inline struct net_device *alloc_eip_netdev(void) +{ + return __alloc_eip_netdev(0); +} + +/* You have one of these per-board */ +struct ei_device { + const char *name; + void (*reset_8390)(struct net_device *); + void (*get_8390_hdr)(struct net_device *, struct e8390_pkt_hdr *, int); + void (*block_output)(struct net_device *, int, const unsigned char *, int); + void (*block_input)(struct net_device *, int, struct sk_buff *, int); + unsigned long rmem_start; + unsigned long rmem_end; + void __iomem *mem; + unsigned char mcfilter[8]; + unsigned open:1; + unsigned word16:1; /* We have the 16-bit (vs 8-bit) version of the card. */ + unsigned bigendian:1; /* 16-bit big endian mode. Do NOT */ + /* set this on random 8390 clones! */ + unsigned txing:1; /* Transmit Active */ + unsigned irqlock:1; /* 8390's intrs disabled when '1'. */ + unsigned dmaing:1; /* Remote DMA Active */ + unsigned char tx_start_page, rx_start_page, stop_page; + unsigned char current_page; /* Read pointer in buffer */ + unsigned char interface_num; /* Net port (AUI, 10bT.) to use. */ + unsigned char txqueue; /* Tx Packet buffer queue length. */ + short tx1, tx2; /* Packet lengths for ping-pong tx. */ + short lasttx; /* Alpha version consistency check. */ + unsigned char reg0; /* Register '0' in a WD8013 */ + unsigned char reg5; /* Register '5' in a WD8013 */ + unsigned char saved_irq; /* Original dev->irq value. */ + u32 *reg_offset; /* Register mapping table */ + spinlock_t page_lock; /* Page register locks */ + unsigned long priv; /* Private field to store bus IDs etc. */ + u32 msg_enable; /* debug message level */ +#ifdef AX88796_PLATFORM + unsigned char rxcr_base; /* default value for RXCR */ +#endif +}; + +/* The maximum number of 8390 interrupt service routines called per IRQ. */ +#define MAX_SERVICE 12 + +/* The maximum time waited (in jiffies) before assuming a Tx failed. (20ms) */ +#define TX_TIMEOUT (20*HZ/100) + +#define ei_status (*(struct ei_device *)netdev_priv(dev)) + +/* Some generic ethernet register configurations. */ +#define E8390_TX_IRQ_MASK 0xa /* For register EN0_ISR */ +#define E8390_RX_IRQ_MASK 0x5 + +#ifdef AX88796_PLATFORM +#define E8390_RXCONFIG (ei_status.rxcr_base | 0x04) +#define E8390_RXOFF (ei_status.rxcr_base | 0x20) +#else +#define E8390_RXCONFIG 0x4 /* EN0_RXCR: broadcasts, no multicast,errors */ +#define E8390_RXOFF 0x20 /* EN0_RXCR: Accept no packets */ +#endif + +#define E8390_TXCONFIG 0x00 /* EN0_TXCR: Normal transmit mode */ +#define E8390_TXOFF 0x02 /* EN0_TXCR: Transmitter off */ + + +/* Register accessed at EN_CMD, the 8390 base addr. */ +#define E8390_STOP 0x01 /* Stop and reset the chip */ +#define E8390_START 0x02 /* Start the chip, clear reset */ +#define E8390_TRANS 0x04 /* Transmit a frame */ +#define E8390_RREAD 0x08 /* Remote read */ +#define E8390_RWRITE 0x10 /* Remote write */ +#define E8390_NODMA 0x20 /* Remote DMA */ +#define E8390_PAGE0 0x00 /* Select page chip registers */ +#define E8390_PAGE1 0x40 /* using the two high-order bits */ +#define E8390_PAGE2 0x80 /* Page 3 is invalid. */ + +/* + * Only generate indirect loads given a machine that needs them. + * - removed AMIGA_PCMCIA from this list, handled as ISA io now + * - the _p for generates no delay by default 8390p.c overrides this. + */ + +#ifndef ei_inb +#define ei_inb(_p) inb(_p) +#define ei_outb(_v,_p) outb(_v,_p) +#define ei_inb_p(_p) inb(_p) +#define ei_outb_p(_v,_p) outb(_v,_p) +#endif + +#ifndef EI_SHIFT +#define EI_SHIFT(x) (x) +#endif + +#define E8390_CMD EI_SHIFT(0x00) /* The command register (for all pages) */ +/* Page 0 register offsets. */ +#define EN0_CLDALO EI_SHIFT(0x01) /* Low byte of current local dma addr RD */ +#define EN0_STARTPG EI_SHIFT(0x01) /* Starting page of ring bfr WR */ +#define EN0_CLDAHI EI_SHIFT(0x02) /* High byte of current local dma addr RD */ +#define EN0_STOPPG EI_SHIFT(0x02) /* Ending page +1 of ring bfr WR */ +#define EN0_BOUNDARY EI_SHIFT(0x03) /* Boundary page of ring bfr RD WR */ +#define EN0_TSR EI_SHIFT(0x04) /* Transmit status reg RD */ +#define EN0_TPSR EI_SHIFT(0x04) /* Transmit starting page WR */ +#define EN0_NCR EI_SHIFT(0x05) /* Number of collision reg RD */ +#define EN0_TCNTLO EI_SHIFT(0x05) /* Low byte of tx byte count WR */ +#define EN0_FIFO EI_SHIFT(0x06) /* FIFO RD */ +#define EN0_TCNTHI EI_SHIFT(0x06) /* High byte of tx byte count WR */ +#define EN0_ISR EI_SHIFT(0x07) /* Interrupt status reg RD WR */ +#define EN0_CRDALO EI_SHIFT(0x08) /* low byte of current remote dma address RD */ +#define EN0_RSARLO EI_SHIFT(0x08) /* Remote start address reg 0 */ +#define EN0_CRDAHI EI_SHIFT(0x09) /* high byte, current remote dma address RD */ +#define EN0_RSARHI EI_SHIFT(0x09) /* Remote start address reg 1 */ +#define EN0_RCNTLO EI_SHIFT(0x0a) /* Remote byte count reg WR */ +#define EN0_RCNTHI EI_SHIFT(0x0b) /* Remote byte count reg WR */ +#define EN0_RSR EI_SHIFT(0x0c) /* rx status reg RD */ +#define EN0_RXCR EI_SHIFT(0x0c) /* RX configuration reg WR */ +#define EN0_TXCR EI_SHIFT(0x0d) /* TX configuration reg WR */ +#define EN0_COUNTER0 EI_SHIFT(0x0d) /* Rcv alignment error counter RD */ +#define EN0_DCFG EI_SHIFT(0x0e) /* Data configuration reg WR */ +#define EN0_COUNTER1 EI_SHIFT(0x0e) /* Rcv CRC error counter RD */ +#define EN0_IMR EI_SHIFT(0x0f) /* Interrupt mask reg WR */ +#define EN0_COUNTER2 EI_SHIFT(0x0f) /* Rcv missed frame error counter RD */ + +/* Bits in EN0_ISR - Interrupt status register */ +#define ENISR_RX 0x01 /* Receiver, no error */ +#define ENISR_TX 0x02 /* Transmitter, no error */ +#define ENISR_RX_ERR 0x04 /* Receiver, with error */ +#define ENISR_TX_ERR 0x08 /* Transmitter, with error */ +#define ENISR_OVER 0x10 /* Receiver overwrote the ring */ +#define ENISR_COUNTERS 0x20 /* Counters need emptying */ +#define ENISR_RDC 0x40 /* remote dma complete */ +#define ENISR_RESET 0x80 /* Reset completed */ +#define ENISR_ALL 0x3f /* Interrupts we will enable */ + +/* Bits in EN0_DCFG - Data config register */ +#define ENDCFG_WTS 0x01 /* word transfer mode selection */ +#define ENDCFG_BOS 0x02 /* byte order selection */ + +/* Page 1 register offsets. */ +#define EN1_PHYS EI_SHIFT(0x01) /* This board's physical enet addr RD WR */ +#define EN1_PHYS_SHIFT(i) EI_SHIFT(i+1) /* Get and set mac address */ +#define EN1_CURPAG EI_SHIFT(0x07) /* Current memory page RD WR */ +#define EN1_MULT EI_SHIFT(0x08) /* Multicast filter mask array (8 bytes) RD WR */ +#define EN1_MULT_SHIFT(i) EI_SHIFT(8+i) /* Get and set multicast filter */ + +/* Bits in received packet status byte and EN0_RSR*/ +#define ENRSR_RXOK 0x01 /* Received a good packet */ +#define ENRSR_CRC 0x02 /* CRC error */ +#define ENRSR_FAE 0x04 /* frame alignment error */ +#define ENRSR_FO 0x08 /* FIFO overrun */ +#define ENRSR_MPA 0x10 /* missed pkt */ +#define ENRSR_PHY 0x20 /* physical/multicast address */ +#define ENRSR_DIS 0x40 /* receiver disable. set in monitor mode */ +#define ENRSR_DEF 0x80 /* deferring */ + +/* Transmitted packet status, EN0_TSR. */ +#define ENTSR_PTX 0x01 /* Packet transmitted without error */ +#define ENTSR_ND 0x02 /* The transmit wasn't deferred. */ +#define ENTSR_COL 0x04 /* The transmit collided at least once. */ +#define ENTSR_ABT 0x08 /* The transmit collided 16 times, and was deferred. */ +#define ENTSR_CRS 0x10 /* The carrier sense was lost. */ +#define ENTSR_FU 0x20 /* A "FIFO underrun" occurred during transmit. */ +#define ENTSR_CDH 0x40 /* The collision detect "heartbeat" signal was lost. */ +#define ENTSR_OWC 0x80 /* There was an out-of-window collision. */ + +#endif /* _8390_h */ |