diff options
Diffstat (limited to 'include/scsi/fc/fc_fcp.h')
| -rw-r--r-- | include/scsi/fc/fc_fcp.h | 216 |
1 files changed, 216 insertions, 0 deletions
diff --git a/include/scsi/fc/fc_fcp.h b/include/scsi/fc/fc_fcp.h new file mode 100644 index 000000000..9c8702942 --- /dev/null +++ b/include/scsi/fc/fc_fcp.h @@ -0,0 +1,216 @@ +/* + * Copyright(c) 2007 Intel Corporation. All rights reserved. + * + * This program is free software; you can redistribute it and/or modify it + * under the terms and conditions of the GNU General Public License, + * version 2, as published by the Free Software Foundation. + * + * This program is distributed in the hope it will be useful, but WITHOUT + * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or + * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for + * more details. + * + * You should have received a copy of the GNU General Public License along with + * this program; if not, write to the Free Software Foundation, Inc., + * 51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA. + * + * Maintained at www.Open-FCoE.org + */ + +#ifndef _FC_FCP_H_ +#define _FC_FCP_H_ + +#include <scsi/scsi.h> + +/* + * Fibre Channel Protocol for SCSI. + * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005. + */ + +/* + * fc/fs.h defines FC_TYPE_FCP. + */ + +/* + * Service parameter page parameters (word 3 bits) for Process Login. + */ +#define FCP_SPPF_TASK_RETRY_ID 0x0200 /* task retry ID requested */ +#define FCP_SPPF_RETRY 0x0100 /* retry supported */ +#define FCP_SPPF_CONF_COMPL 0x0080 /* confirmed completion allowed */ +#define FCP_SPPF_OVLY_ALLOW 0x0040 /* data overlay allowed */ +#define FCP_SPPF_INIT_FCN 0x0020 /* initiator function */ +#define FCP_SPPF_TARG_FCN 0x0010 /* target function */ +#define FCP_SPPF_RD_XRDY_DIS 0x0002 /* disable XFER_RDY for reads */ +#define FCP_SPPF_WR_XRDY_DIS 0x0001 /* disable XFER_RDY for writes */ + +/* + * FCP_CMND IU Payload. + */ +struct fcp_cmnd { + struct scsi_lun fc_lun; /* logical unit number */ + __u8 fc_cmdref; /* command reference number */ + __u8 fc_pri_ta; /* priority and task attribute */ + __u8 fc_tm_flags; /* task management flags */ + __u8 fc_flags; /* additional len & flags */ + __u8 fc_cdb[16]; /* base CDB */ + __be32 fc_dl; /* data length (must follow fc_cdb) */ +}; + +#define FCP_CMND_LEN 32 /* expected length of structure */ + +struct fcp_cmnd32 { + struct scsi_lun fc_lun; /* logical unit number */ + __u8 fc_cmdref; /* command reference number */ + __u8 fc_pri_ta; /* priority and task attribute */ + __u8 fc_tm_flags; /* task management flags */ + __u8 fc_flags; /* additional len & flags */ + __u8 fc_cdb[32]; /* base CDB */ + __be32 fc_dl; /* data length (must follow fc_cdb) */ +}; + +#define FCP_CMND32_LEN 48 /* expected length of structure */ +#define FCP_CMND32_ADD_LEN (16 / 4) /* Additional cdb length */ + +/* + * fc_pri_ta. + */ +#define FCP_PTA_SIMPLE 0 /* simple task attribute */ +#define FCP_PTA_HEADQ 1 /* head of queue task attribute */ +#define FCP_PTA_ORDERED 2 /* ordered task attribute */ +#define FCP_PTA_ACA 4 /* auto. contingent allegiance */ +#define FCP_PTA_MASK 7 /* mask for task attribute field */ +#define FCP_PRI_SHIFT 3 /* priority field starts in bit 3 */ +#define FCP_PRI_RESVD_MASK 0x80 /* reserved bits in priority field */ + +/* + * fc_tm_flags - task management flags field. + */ +#define FCP_TMF_CLR_ACA 0x40 /* clear ACA condition */ +#define FCP_TMF_TGT_RESET 0x20 /* target reset task management, + deprecated as of FCP-3 */ +#define FCP_TMF_LUN_RESET 0x10 /* logical unit reset task management */ +#define FCP_TMF_CLR_TASK_SET 0x04 /* clear task set */ +#define FCP_TMF_ABT_TASK_SET 0x02 /* abort task set */ + +/* + * fc_flags. + * Bits 7:2 are the additional FCP_CDB length / 4. + */ +#define FCP_CFL_LEN_MASK 0xfc /* mask for additional length */ +#define FCP_CFL_LEN_SHIFT 2 /* shift bits for additional length */ +#define FCP_CFL_RDDATA 0x02 /* read data */ +#define FCP_CFL_WRDATA 0x01 /* write data */ + +/* + * FCP_TXRDY IU - transfer ready payload. + */ +struct fcp_txrdy { + __be32 ft_data_ro; /* data relative offset */ + __be32 ft_burst_len; /* burst length */ + __u8 _ft_resvd[4]; /* reserved */ +}; + +#define FCP_TXRDY_LEN 12 /* expected length of structure */ + +/* + * FCP_RESP IU - response payload. + * + * The response payload comes in three parts: the flags/status, the + * sense/response lengths and the sense data/response info section. + * + * From FCP3r04, note 6 of section 9.5.13: + * + * Some early implementations presented the FCP_RSP IU without the FCP_RESID, + * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER, + * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This + * non-standard behavior should be tolerated. + * + * All response frames will always contain the fcp_resp template. Some + * will also include the fcp_resp_len template. + * + * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both + * are valid length. + */ +struct fcp_resp { + __u8 _fr_resvd[8]; /* reserved */ + __be16 fr_retry_delay; /* retry delay timer */ + __u8 fr_flags; /* flags */ + __u8 fr_status; /* SCSI status code */ +}; + +#define FCP_RESP_LEN 12 /* expected length of structure */ + +struct fcp_resp_ext { + __be32 fr_resid; /* Residual value */ + __be32 fr_sns_len; /* SCSI Sense length */ + __be32 fr_rsp_len; /* Response Info length */ + + /* + * Optionally followed by RSP info and/or SNS info and/or + * bidirectional read residual length, if any. + */ +}; + +#define FCP_RESP_EXT_LEN 12 /* expected length of the structure */ + +struct fcp_resp_rsp_info { + __u8 _fr_resvd[3]; /* reserved */ + __u8 rsp_code; /* Response Info Code */ + __u8 _fr_resvd2[4]; /* reserved */ +}; + +#define FCP_RESP_RSP_INFO_LEN4 4 /* without reserved field */ +#define FCP_RESP_RSP_INFO_LEN8 8 /* with reserved field */ + +struct fcp_resp_with_ext { + struct fcp_resp resp; + struct fcp_resp_ext ext; +}; + +#define FCP_RESP_WITH_EXT (FCP_RESP_LEN + FCP_RESP_EXT_LEN) + +/* + * fr_flags. + */ +#define FCP_BIDI_RSP 0x80 /* bidirectional read response */ +#define FCP_BIDI_READ_UNDER 0x40 /* bidir. read less than requested */ +#define FCP_BIDI_READ_OVER 0x20 /* DL insufficient for full transfer */ +#define FCP_CONF_REQ 0x10 /* confirmation requested */ +#define FCP_RESID_UNDER 0x08 /* transfer shorter than expected */ +#define FCP_RESID_OVER 0x04 /* DL insufficient for full transfer */ +#define FCP_SNS_LEN_VAL 0x02 /* SNS_LEN field is valid */ +#define FCP_RSP_LEN_VAL 0x01 /* RSP_LEN field is valid */ + +/* + * rsp_codes + */ +enum fcp_resp_rsp_codes { + FCP_TMF_CMPL = 0, + FCP_DATA_LEN_INVALID = 1, + FCP_CMND_FIELDS_INVALID = 2, + FCP_DATA_PARAM_MISMATCH = 3, + FCP_TMF_REJECTED = 4, + FCP_TMF_FAILED = 5, + FCP_TMF_INVALID_LUN = 9, +}; + +/* + * FCP SRR Link Service request - Sequence Retransmission Request. + */ +struct fcp_srr { + __u8 srr_op; /* opcode ELS_SRR */ + __u8 srr_resvd[3]; /* opcode / reserved - must be zero */ + __be16 srr_ox_id; /* OX_ID of failed command */ + __be16 srr_rx_id; /* RX_ID of failed command */ + __be32 srr_rel_off; /* relative offset */ + __u8 srr_r_ctl; /* r_ctl for the information unit */ + __u8 srr_resvd2[3]; /* reserved */ +}; + +/* + * Feature bits in name server FC-4 Features object. + */ +#define FCP_FEAT_TARG (1 << 0) /* target function supported */ +#define FCP_FEAT_INIT (1 << 1) /* initiator function supported */ + +#endif /* _FC_FCP_H_ */ |