diff options
Diffstat (limited to 'Documentation/devicetree/bindings/gpio/gpio-uniphier.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/gpio/gpio-uniphier.txt | 51 |
1 files changed, 51 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-uniphier.txt b/Documentation/devicetree/bindings/gpio/gpio-uniphier.txt new file mode 100644 index 000000000..f281f12da --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/gpio-uniphier.txt @@ -0,0 +1,51 @@ +UniPhier GPIO controller + +Required properties: +- compatible: Should be "socionext,uniphier-gpio". +- reg: Specifies offset and length of the register set for the device. +- gpio-controller: Marks the device node as a GPIO controller. +- #gpio-cells: Should be 2. The first cell is the pin number and the second + cell is used to specify optional parameters. +- interrupt-controller: Marks the device node as an interrupt controller. +- #interrupt-cells: Should be 2. The first cell defines the interrupt number. + The second cell bits[3:0] is used to specify trigger type as follows: + 1 = low-to-high edge triggered + 2 = high-to-low edge triggered + 4 = active high level-sensitive + 8 = active low level-sensitive + Valid combinations are 1, 2, 3, 4, 8. +- ngpios: Specifies the number of GPIO lines. +- gpio-ranges: Mapping to pin controller pins (as described in gpio.txt) +- socionext,interrupt-ranges: Specifies an interrupt number mapping between + this GPIO controller and its interrupt parent, in the form of arbitrary + number of <child-interrupt-base parent-interrupt-base length> triplets. + +Optional properties: +- gpio-ranges-group-names: Used for named gpio ranges (as described in gpio.txt) + +Example: + gpio: gpio@55000000 { + compatible = "socionext,uniphier-gpio"; + reg = <0x55000000 0x200>; + interrupt-parent = <&aidet>; + interrupt-controller; + #interrupt-cells = <2>; + gpio-controller; + #gpio-cells = <2>; + gpio-ranges = <&pinctrl 0 0 0>; + gpio-ranges-group-names = "gpio_range"; + ngpios = <248>; + socionext,interrupt-ranges = <0 48 16>, <16 154 5>, <21 217 3>; + }; + +Consumer Example: + + sdhci0_pwrseq { + compatible = "mmc-pwrseq-emmc"; + reset-gpios = <&gpio UNIPHIER_GPIO_PORT(29, 4) GPIO_ACTIVE_LOW>; + }; + +Please note UNIPHIER_GPIO_PORT(29, 4) represents PORT294 in the SoC document. +Unfortunately, only the one's place is octal in the port numbering. (That is, +PORT 8, 9, 18, 19, 28, 29, ... are missing.) UNIPHIER_GPIO_PORT() is a helper +macro to calculate 29 * 8 + 4. |