diff options
Diffstat (limited to 'Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt')
-rw-r--r-- | Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt | 49 |
1 files changed, 49 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt b/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt new file mode 100644 index 000000000..bedcfd5a5 --- /dev/null +++ b/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt @@ -0,0 +1,49 @@ +* Marvell Armada 370 / Armada XP / Armada 3700 Ethernet Controller (NETA) + +Required properties: +- compatible: could be one of the following: + "marvell,armada-370-neta" + "marvell,armada-xp-neta" + "marvell,armada-3700-neta" +- reg: address and length of the register set for the device. +- interrupts: interrupt for the device +- phy: See ethernet.txt file in the same directory. +- phy-mode: See ethernet.txt file in the same directory +- clocks: List of clocks for this device. At least one clock is + mandatory for the core clock. If several clocks are given, then the + clock-names property must be used to identify them. + +Optional properties: +- tx-csum-limit: maximum mtu supported by port that allow TX checksum. + Value is presented in bytes. If not used, by default 1600B is set for + "marvell,armada-370-neta" and 9800B for others. +- clock-names: List of names corresponding to clocks property; shall be + "core" for core clock and "bus" for the optional bus clock. + + +Optional properties (valid only for Armada XP/38x): + +- buffer-manager: a phandle to a buffer manager node. Please refer to + Documentation/devicetree/bindings/net/marvell-neta-bm.txt +- bm,pool-long: ID of a pool, that will accept all packets of a size + higher than 'short' pool's threshold (if set) and up to MTU value. + Obligatory, when the port is supposed to use hardware + buffer management. +- bm,pool-short: ID of a pool, that will be used for accepting + packets of a size lower than given threshold. If not set, the port + will use a single 'long' pool for all packets, as defined above. + +Example: + +ethernet@70000 { + compatible = "marvell,armada-370-neta"; + reg = <0x70000 0x2500>; + interrupts = <8>; + clocks = <&gate_clk 4>; + tx-csum-limit = <9800> + phy = <&phy0>; + phy-mode = "rgmii-id"; + buffer-manager = <&bm>; + bm,pool-long = <0>; + bm,pool-short = <1>; +}; |