From 76cb841cb886eef6b3bee341a2266c76578724ad Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Mon, 6 May 2024 03:02:30 +0200 Subject: Adding upstream version 4.19.249. Signed-off-by: Daniel Baumann --- .../bindings/iio/potentiostat/lmp91000.txt | 33 ++++++++++++++++++++++ 1 file changed, 33 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/potentiostat/lmp91000.txt (limited to 'Documentation/devicetree/bindings/iio/potentiostat') diff --git a/Documentation/devicetree/bindings/iio/potentiostat/lmp91000.txt b/Documentation/devicetree/bindings/iio/potentiostat/lmp91000.txt new file mode 100644 index 000000000..e6d0c2eb3 --- /dev/null +++ b/Documentation/devicetree/bindings/iio/potentiostat/lmp91000.txt @@ -0,0 +1,33 @@ +* Texas Instruments LMP91000 series of potentiostats + +LMP91000: http://www.ti.com/lit/ds/symlink/lmp91000.pdf +LMP91002: http://www.ti.com/lit/ds/symlink/lmp91002.pdf + +Required properties: + + - compatible: should be one of the following: + "ti,lmp91000" + "ti,lmp91002" + - reg: the I2C address of the device + - io-channels: the phandle of the iio provider + + - ti,external-tia-resistor: if the property ti,tia-gain-ohm is not defined this + needs to be set to signal that an external resistor value is being used. + +Optional properties: + + - ti,tia-gain-ohm: ohm value of the internal resistor for the transimpedance + amplifier. Must be 2750, 3500, 7000, 14000, 35000, 120000, or 350000 ohms. + + - ti,rload-ohm: ohm value of the internal resistor load applied to the gas + sensor. Must be 10, 33, 50, or 100 (default) ohms. + +Example: + +lmp91000@48 { + compatible = "ti,lmp91000"; + reg = <0x48>; + ti,tia-gain-ohm = <7500>; + ti,rload = <100>; + io-channels = <&adc>; +}; -- cgit v1.2.3