From 76cb841cb886eef6b3bee341a2266c76578724ad Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Mon, 6 May 2024 03:02:30 +0200 Subject: Adding upstream version 4.19.249. Signed-off-by: Daniel Baumann --- .../devicetree/bindings/input/atmel,maxtouch.txt | 41 ++++++++++++++++++++++ 1 file changed, 41 insertions(+) create mode 100644 Documentation/devicetree/bindings/input/atmel,maxtouch.txt (limited to 'Documentation/devicetree/bindings/input/atmel,maxtouch.txt') diff --git a/Documentation/devicetree/bindings/input/atmel,maxtouch.txt b/Documentation/devicetree/bindings/input/atmel,maxtouch.txt new file mode 100644 index 000000000..c88919480 --- /dev/null +++ b/Documentation/devicetree/bindings/input/atmel,maxtouch.txt @@ -0,0 +1,41 @@ +Atmel maXTouch touchscreen/touchpad + +Required properties: +- compatible: + atmel,maxtouch + + The following compatibles have been used in various products but are + deprecated: + atmel,qt602240_ts + atmel,atmel_mxt_ts + atmel,atmel_mxt_tp + atmel,mXT224 + +- reg: The I2C address of the device + +- interrupts: The sink for the touchpad's IRQ output + See ../interrupt-controller/interrupts.txt + +Optional properties for main touchpad device: + +- linux,gpio-keymap: When enabled, the SPT_GPIOPWN_T19 object sends messages + on GPIO bit changes. An array of up to 8 entries can be provided + indicating the Linux keycode mapped to each bit of the status byte, + starting at the LSB. Linux keycodes are defined in + . + + Note: the numbering of the GPIOs and the bit they start at varies between + maXTouch devices. You must either refer to the documentation, or + experiment to determine which bit corresponds to which input. Use + KEY_RESERVED for unused padding values. + +- reset-gpios: GPIO specifier for the touchscreen's reset pin (active low) + +Example: + + touch@4b { + compatible = "atmel,maxtouch"; + reg = <0x4b>; + interrupt-parent = <&gpio>; + interrupts = ; + }; -- cgit v1.2.3