Adding upstream version 5.10.209.upstream/5.10.209

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 45 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/gpio/gpio-omap.txt b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
new file mode 100644
index 000000000..e57b2cb28
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
@@ -0,0 +1,45 @@
+OMAP GPIO controller bindings
+
+Required properties:
+- compatible:
+  - "ti,omap2-gpio" for OMAP2 controllers
+  - "ti,omap3-gpio" for OMAP3 controllers
+  - "ti,omap4-gpio" for OMAP4 controllers
+- reg : Physical base address of the controller and length of memory mapped
+  region.
+- gpio-controller : Marks the device node as a GPIO controller.
+- #gpio-cells : Should be two.
+  - first cell is the pin number
+  - second cell is used to specify optional parameters (unused)
+- interrupt-controller: Mark the device node as an interrupt controller.
+- #interrupt-cells : Should be 2.
+  The first cell is the GPIO number.
+  The second cell is used to specify flags:
+    bits[3:0] trigger type and level flags:
+      1 = low-to-high edge triggered.
+      2 = high-to-low edge triggered.
+      4 = active high level-sensitive.
+      8 = active low level-sensitive.
+- interrupts : The interrupt the controller is rising as output when an
+  interrupt occures
+
+OMAP specific properties:
+- ti,hwmods:		Name of the hwmod associated to the GPIO:
+			"gpio<X>", <X> being the 1-based instance number
+			from the HW spec.
+- ti,gpio-always-on: 	Indicates if a GPIO bank is always powered and
+			so will never lose its logic state.
+
+
+Example:
+
+gpio0: gpio@44e07000 {
+    compatible = "ti,omap4-gpio";
+    reg = <0x44e07000 0x1000>;
+    ti,hwmods = "gpio1";
+    gpio-controller;
+    #gpio-cells = <2>;
+    interrupt-controller;
+    #interrupt-cells = <2>;
+    interrupts = <96>;
+};