Adding upstream version 5.10.209.upstream/5.10.209

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 61 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt b/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt
new file mode 100644
index 000000000..676d43ec8
--- /dev/null
+++ b/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt
@@ -0,0 +1,61 @@
+LEDs connected to is31fl319x LED controller chip
+
+Required properties:
+- compatible : Should be any of
+	"issi,is31fl3190"
+	"issi,is31fl3191"
+	"issi,is31fl3193"
+	"issi,is31fl3196"
+	"issi,is31fl3199"
+	"si-en,sn3199".
+- #address-cells: Must be 1.
+- #size-cells: Must be 0.
+- reg: 0x64, 0x65, 0x66, or 0x67.
+
+Optional properties:
+- audio-gain-db : audio gain selection for external analog modulation input.
+	Valid values: 0 - 21, step by 3 (rounded down)
+	Default: 0
+- shutdown-gpios : Specifier of the GPIO connected to SDB pin of the chip.
+
+Each led is represented as a sub-node of the issi,is31fl319x device.
+There can be less leds subnodes than the chip can support but not more.
+
+Required led sub-node properties:
+- reg : number of LED line
+	Valid values: 1 - number of leds supported by the chip variant.
+
+Optional led sub-node properties:
+- label : see Documentation/devicetree/bindings/leds/common.txt.
+- linux,default-trigger :
+	see Documentation/devicetree/bindings/leds/common.txt.
+- led-max-microamp : (optional)
+	Valid values: 5000 - 40000, step by 5000 (rounded down)
+	Default: 20000 (20 mA)
+	Note: a driver will take the lowest of all led limits since the
+	chip has a single global setting. The lowest value will be chosen
+	due to the PWM specificity, where lower brightness is achieved
+	by reducing the dury-cycle of pulses and not the current, which
+	will always have its peak value equal to led-max-microamp.
+
+Examples:
+
+fancy_leds: leds@65 {
+	compatible = "issi,is31fl3196";
+	#address-cells = <1>;
+	#size-cells = <0>;
+	reg = <0x65>;
+	shutdown-gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
+
+	red_aux: led@1 {
+		label = "red:aux";
+		reg = <1>;
+		led-max-microamp = <10000>;
+	};
+
+	green_power: led@5 {
+		label = "green:power";
+		reg = <5>;
+		linux,default-trigger = "default-on";
+	};
+};