Adding upstream version 5.10.209.upstream/5.10.209

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 60 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/power/supply/bq25890.txt b/Documentation/devicetree/bindings/power/supply/bq25890.txt
new file mode 100644
index 000000000..805040c6f
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/supply/bq25890.txt
@@ -0,0 +1,60 @@
+Binding for TI bq25890 Li-Ion Charger
+
+This driver will support the bq25892, the bq25896 and the bq25890. There are
+other ICs in the same family but those have not been tested.
+
+Required properties:
+- compatible: Should contain one of the following:
+    * "ti,bq25890"
+    * "ti,bq25892"
+    * "ti,bq25895"
+    * "ti,bq25896"
+- reg: integer, i2c address of the device.
+- interrupts: interrupt line;
+- ti,battery-regulation-voltage: integer, maximum charging voltage (in uV);
+- ti,charge-current: integer, maximum charging current (in uA);
+- ti,termination-current: integer, charge will be terminated when current in
+    constant-voltage phase drops below this value (in uA);
+- ti,precharge-current: integer, maximum charge current during precharge
+    phase (in uA);
+- ti,minimum-sys-voltage: integer, when battery is charging and it is below
+    minimum system voltage, the system will be regulated above
+    minimum-sys-voltage setting (in uV);
+- ti,boost-voltage: integer, VBUS voltage level in boost mode (in uV);
+- ti,boost-max-current: integer, maximum allowed current draw in boost mode
+    (in uA).
+
+Optional properties:
+- ti,boost-low-freq: boolean, if present boost mode frequency will be 500kHz,
+    otherwise 1.5MHz;
+- ti,use-ilim-pin: boolean, if present the ILIM resistor will be used and the
+    input current will be the lower between the resistor setting and the IINLIM
+    register setting;
+- ti,thermal-regulation-threshold: integer, temperature above which the charge
+    current is lowered, to avoid overheating (in degrees Celsius). If omitted,
+    the default setting will be used (120 degrees);
+- ti,ibatcomp-micro-ohms: integer, value of a resistor in series with
+    the battery;
+- ti,ibatcomp-clamp-microvolt: integer, maximum charging voltage adjustment due
+    to expected voltage drop on in-series resistor;
+
+Example:
+
+bq25890 {
+	compatible = "ti,bq25890";
+	reg = <0x6a>;
+
+	interrupt-parent = <&gpio1>;
+	interrupts = <16 IRQ_TYPE_EDGE_FALLING>;
+
+	ti,battery-regulation-voltage = <4200000>;
+	ti,charge-current = <1000000>;
+	ti,termination-current = <50000>;
+	ti,precharge-current = <128000>;
+	ti,minimum-sys-voltage = <3600000>;
+	ti,boost-voltage = <5000000>;
+	ti,boost-max-current = <1000000>;
+
+	ti,use-ilim-pin;
+	ti,thermal-regulation-threshold = <120>;
+};