Adding upstream version 5.10.209.upstream/5.10.209

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 221 insertions, 0 deletions

diff --git a/drivers/irqchip/irq-aspeed-vic.c b/drivers/irqchip/irq-aspeed-vic.c
new file mode 100644
index 000000000..58717cd44
--- /dev/null
+++ b/drivers/irqchip/irq-aspeed-vic.c
@@ -0,0 +1,221 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+/*
+ *  Copyright (C) 2015 - Ben Herrenschmidt, IBM Corp.
+ *
+ *  Driver for Aspeed "new" VIC as found in SoC generation 3 and later
+ *
+ *  Based on irq-vic.c:
+ *
+ *  Copyright (C) 1999 - 2003 ARM Limited
+ *  Copyright (C) 2000 Deep Blue Solutions Ltd
+ */
+
+#include <linux/export.h>
+#include <linux/init.h>
+#include <linux/list.h>
+#include <linux/io.h>
+#include <linux/irq.h>
+#include <linux/irqchip.h>
+#include <linux/irqchip/chained_irq.h>
+#include <linux/irqdomain.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/of_irq.h>
+#include <linux/syscore_ops.h>
+#include <linux/device.h>
+#include <linux/slab.h>
+
+#include <asm/exception.h>
+#include <asm/irq.h>
+
+/* These definitions correspond to the "new mapping" of the
+ * register set that interleaves "high" and "low". The offsets
+ * below are for the "low" register, add 4 to get to the high one
+ */
+#define AVIC_IRQ_STATUS		0x00
+#define AVIC_FIQ_STATUS		0x08
+#define AVIC_RAW_STATUS		0x10
+#define AVIC_INT_SELECT		0x18
+#define AVIC_INT_ENABLE		0x20
+#define AVIC_INT_ENABLE_CLR	0x28
+#define AVIC_INT_TRIGGER	0x30
+#define AVIC_INT_TRIGGER_CLR	0x38
+#define AVIC_INT_SENSE		0x40
+#define AVIC_INT_DUAL_EDGE	0x48
+#define AVIC_INT_EVENT		0x50
+#define AVIC_EDGE_CLR		0x58
+#define AVIC_EDGE_STATUS	0x60
+
+#define NUM_IRQS		64
+
+struct aspeed_vic {
+	void __iomem		*base;
+	u32			edge_sources[2];
+	struct irq_domain	*dom;
+};
+static struct aspeed_vic *system_avic;
+
+static void vic_init_hw(struct aspeed_vic *vic)
+{
+	u32 sense;
+
+	/* Disable all interrupts */
+	writel(0xffffffff, vic->base + AVIC_INT_ENABLE_CLR);
+	writel(0xffffffff, vic->base + AVIC_INT_ENABLE_CLR + 4);
+
+	/* Make sure no soft trigger is on */
+	writel(0xffffffff, vic->base + AVIC_INT_TRIGGER_CLR);
+	writel(0xffffffff, vic->base + AVIC_INT_TRIGGER_CLR + 4);
+
+	/* Set everything to be IRQ */
+	writel(0, vic->base + AVIC_INT_SELECT);
+	writel(0, vic->base + AVIC_INT_SELECT + 4);
+
+	/* Some interrupts have a programmable high/low level trigger
+	 * (4 GPIO direct inputs), for now we assume this was configured
+	 * by firmware. We read which ones are edge now.
+	 */
+	sense = readl(vic->base + AVIC_INT_SENSE);
+	vic->edge_sources[0] = ~sense;
+	sense = readl(vic->base + AVIC_INT_SENSE + 4);
+	vic->edge_sources[1] = ~sense;
+
+	/* Clear edge detection latches */
+	writel(0xffffffff, vic->base + AVIC_EDGE_CLR);
+	writel(0xffffffff, vic->base + AVIC_EDGE_CLR + 4);
+}
+
+static void __exception_irq_entry avic_handle_irq(struct pt_regs *regs)
+{
+	struct aspeed_vic *vic = system_avic;
+	u32 stat, irq;
+
+	for (;;) {
+		irq = 0;
+		stat = readl_relaxed(vic->base + AVIC_IRQ_STATUS);
+		if (!stat) {
+			stat = readl_relaxed(vic->base + AVIC_IRQ_STATUS + 4);
+			irq = 32;
+		}
+		if (stat == 0)
+			break;
+		irq += ffs(stat) - 1;
+		handle_domain_irq(vic->dom, irq, regs);
+	}
+}
+
+static void avic_ack_irq(struct irq_data *d)
+{
+	struct aspeed_vic *vic = irq_data_get_irq_chip_data(d);
+	unsigned int sidx = d->hwirq >> 5;
+	unsigned int sbit = 1u << (d->hwirq & 0x1f);
+
+	/* Clear edge latch for edge interrupts, nop for level */
+	if (vic->edge_sources[sidx] & sbit)
+		writel(sbit, vic->base + AVIC_EDGE_CLR + sidx * 4);
+}
+
+static void avic_mask_irq(struct irq_data *d)
+{
+	struct aspeed_vic *vic = irq_data_get_irq_chip_data(d);
+	unsigned int sidx = d->hwirq >> 5;
+	unsigned int sbit = 1u << (d->hwirq & 0x1f);
+
+	writel(sbit, vic->base + AVIC_INT_ENABLE_CLR + sidx * 4);
+}
+
+static void avic_unmask_irq(struct irq_data *d)
+{
+	struct aspeed_vic *vic = irq_data_get_irq_chip_data(d);
+	unsigned int sidx = d->hwirq >> 5;
+	unsigned int sbit = 1u << (d->hwirq & 0x1f);
+
+	writel(sbit, vic->base + AVIC_INT_ENABLE + sidx * 4);
+}
+
+/* For level irq, faster than going through a nop "ack" and mask */
+static void avic_mask_ack_irq(struct irq_data *d)
+{
+	struct aspeed_vic *vic = irq_data_get_irq_chip_data(d);
+	unsigned int sidx = d->hwirq >> 5;
+	unsigned int sbit = 1u << (d->hwirq & 0x1f);
+
+	/* First mask */
+	writel(sbit, vic->base + AVIC_INT_ENABLE_CLR + sidx * 4);
+
+	/* Then clear edge latch for edge interrupts */
+	if (vic->edge_sources[sidx] & sbit)
+		writel(sbit, vic->base + AVIC_EDGE_CLR + sidx * 4);
+}
+
+static struct irq_chip avic_chip = {
+	.name		= "AVIC",
+	.irq_ack	= avic_ack_irq,
+	.irq_mask	= avic_mask_irq,
+	.irq_unmask	= avic_unmask_irq,
+	.irq_mask_ack	= avic_mask_ack_irq,
+};
+
+static int avic_map(struct irq_domain *d, unsigned int irq,
+		    irq_hw_number_t hwirq)
+{
+	struct aspeed_vic *vic = d->host_data;
+	unsigned int sidx = hwirq >> 5;
+	unsigned int sbit = 1u << (hwirq & 0x1f);
+
+	/* Check if interrupt exists */
+	if (sidx > 1)
+		return -EPERM;
+
+	if (vic->edge_sources[sidx] & sbit)
+		irq_set_chip_and_handler(irq, &avic_chip, handle_edge_irq);
+	else
+		irq_set_chip_and_handler(irq, &avic_chip, handle_level_irq);
+	irq_set_chip_data(irq, vic);
+	irq_set_probe(irq);
+	return 0;
+}
+
+static const struct irq_domain_ops avic_dom_ops = {
+	.map = avic_map,
+	.xlate = irq_domain_xlate_onetwocell,
+};
+
+static int __init avic_of_init(struct device_node *node,
+			       struct device_node *parent)
+{
+	void __iomem *regs;
+	struct aspeed_vic *vic;
+
+	if (WARN(parent, "non-root Aspeed VIC not supported"))
+		return -EINVAL;
+	if (WARN(system_avic, "duplicate Aspeed VIC not supported"))
+		return -EINVAL;
+
+	regs = of_iomap(node, 0);
+	if (WARN_ON(!regs))
+		return -EIO;
+
+	vic = kzalloc(sizeof(struct aspeed_vic), GFP_KERNEL);
+	if (WARN_ON(!vic)) {
+		iounmap(regs);
+		return -ENOMEM;
+	}
+	vic->base = regs;
+
+	/* Initialize sources, all masked */
+	vic_init_hw(vic);
+
+	/* Ready to receive interrupts */
+	system_avic = vic;
+	set_handle_irq(avic_handle_irq);
+
+	/* Register our domain */
+	vic->dom = irq_domain_add_simple(node, NUM_IRQS, 0,
+					 &avic_dom_ops, vic);
+
+	return 0;
+}
+
+IRQCHIP_DECLARE(ast2400_vic, "aspeed,ast2400-vic", avic_of_init);
+IRQCHIP_DECLARE(ast2500_vic, "aspeed,ast2500-vic", avic_of_init);