diff options
Diffstat (limited to 'Documentation/devicetree/bindings/display/msm/gpu.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/display/msm/gpu.txt | 150 |
1 files changed, 150 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/display/msm/gpu.txt b/Documentation/devicetree/bindings/display/msm/gpu.txt new file mode 100644 index 000000000..1af0ff102 --- /dev/null +++ b/Documentation/devicetree/bindings/display/msm/gpu.txt @@ -0,0 +1,150 @@ +Qualcomm adreno/snapdragon GPU + +Required properties: +- compatible: "qcom,adreno-XYZ.W", "qcom,adreno" or + "amd,imageon-XYZ.W", "amd,imageon" + for example: "qcom,adreno-306.0", "qcom,adreno" + Note that you need to list the less specific "qcom,adreno" (since this + is what the device is matched on), in addition to the more specific + with the chip-id. + If "amd,imageon" is used, there should be no top level msm device. +- reg: Physical base address and length of the controller's registers. +- interrupts: The interrupt signal from the gpu. +- clocks: device clocks (if applicable) + See ../clocks/clock-bindings.txt for details. +- clock-names: the following clocks are required by a3xx, a4xx and a5xx + cores: + * "core" + * "iface" + * "mem_iface" + For GMU attached devices the GPU clocks are not used and are not required. The + following devices should not list clocks: + - qcom,adreno-630.2 +- iommus: optional phandle to an adreno iommu instance +- operating-points-v2: optional phandle to the OPP operating points +- interconnects: optional phandle to an interconnect provider. See + ../interconnect/interconnect.txt for details. Some A3xx and all A4xx platforms + will have two paths; all others will have one path. +- interconnect-names: The names of the interconnect paths that correspond to the + interconnects property. Values must be gfx-mem and ocmem. +- qcom,gmu: For GMU attached devices a phandle to the GMU device that will + control the power for the GPU. Applicable targets: + - qcom,adreno-630.2 +- zap-shader: For a5xx and a6xx devices this node contains a memory-region that + points to reserved memory to store the zap shader that can be used to help + bring the GPU out of secure mode. +- firmware-name: optional property of the 'zap-shader' node, listing the + relative path of the device specific zap firmware. +- sram: phandle to the On Chip Memory (OCMEM) that's present on some a3xx and + a4xx Snapdragon SoCs. See + Documentation/devicetree/bindings/sram/qcom,ocmem.yaml. + +Example 3xx/4xx: + +/ { + ... + + gpu: adreno@fdb00000 { + compatible = "qcom,adreno-330.2", + "qcom,adreno"; + reg = <0xfdb00000 0x10000>; + reg-names = "kgsl_3d0_reg_memory"; + interrupts = <GIC_SPI 33 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "kgsl_3d0_irq"; + clock-names = "core", + "iface", + "mem_iface"; + clocks = <&mmcc OXILI_GFX3D_CLK>, + <&mmcc OXILICX_AHB_CLK>, + <&mmcc OXILICX_AXI_CLK>; + sram = <&gpu_sram>; + power-domains = <&mmcc OXILICX_GDSC>; + operating-points-v2 = <&gpu_opp_table>; + iommus = <&gpu_iommu 0>; + }; + + gpu_sram: ocmem@fdd00000 { + compatible = "qcom,msm8974-ocmem"; + + reg = <0xfdd00000 0x2000>, + <0xfec00000 0x180000>; + reg-names = "ctrl", + "mem"; + + clocks = <&rpmcc RPM_SMD_OCMEMGX_CLK>, + <&mmcc OCMEMCX_OCMEMNOC_CLK>; + clock-names = "core", + "iface"; + + #address-cells = <1>; + #size-cells = <1>; + + gpu_sram: gpu-sram@0 { + reg = <0x0 0x100000>; + ranges = <0 0 0xfec00000 0x100000>; + }; + }; +}; + +Example a6xx (with GMU): + +/ { + ... + + gpu@5000000 { + compatible = "qcom,adreno-630.2", "qcom,adreno"; + #stream-id-cells = <16>; + + reg = <0x5000000 0x40000>, <0x509e000 0x10>; + reg-names = "kgsl_3d0_reg_memory", "cx_mem"; + + /* + * Look ma, no clocks! The GPU clocks and power are + * controlled entirely by the GMU + */ + + interrupts = <GIC_SPI 300 IRQ_TYPE_LEVEL_HIGH>; + + iommus = <&adreno_smmu 0>; + + operating-points-v2 = <&gpu_opp_table>; + + interconnects = <&rsc_hlos MASTER_GFX3D &rsc_hlos SLAVE_EBI1>; + interconnect-names = "gfx-mem"; + + gpu_opp_table: opp-table { + compatible = "operating-points-v2"; + + opp-430000000 { + opp-hz = /bits/ 64 <430000000>; + opp-level = <RPMH_REGULATOR_LEVEL_SVS_L1>; + opp-peak-kBps = <5412000>; + }; + + opp-355000000 { + opp-hz = /bits/ 64 <355000000>; + opp-level = <RPMH_REGULATOR_LEVEL_SVS>; + opp-peak-kBps = <3072000>; + }; + + opp-267000000 { + opp-hz = /bits/ 64 <267000000>; + opp-level = <RPMH_REGULATOR_LEVEL_LOW_SVS>; + opp-peak-kBps = <3072000>; + }; + + opp-180000000 { + opp-hz = /bits/ 64 <180000000>; + opp-level = <RPMH_REGULATOR_LEVEL_MIN_SVS>; + opp-peak-kBps = <1804000>; + }; + }; + + qcom,gmu = <&gmu>; + + zap-shader { + memory-region = <&zap_shader_region>; + firmware-name = "qcom/LENOVO/81JL/qcdxkmsuc850.mbn" + }; + }; +}; |