1 files changed, 231 insertions, 0 deletions
diff --git a/arch/x86/lib/delay.c b/arch/x86/lib/delay.c
new file mode 100644
index 000000000..0e65d00e2
--- /dev/null
+++ b/arch/x86/lib/delay.c
@@ -0,0 +1,231 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ *	Precise Delay Loops for i386
+ *
+ *	Copyright (C) 1993 Linus Torvalds
+ *	Copyright (C) 1997 Martin Mares <mj@atrey.karlin.mff.cuni.cz>
+ *	Copyright (C) 2008 Jiri Hladky <hladky _dot_ jiri _at_ gmail _dot_ com>
+ *
+ *	The __delay function must _NOT_ be inlined as its execution time
+ *	depends wildly on alignment on many x86 processors. The additional
+ *	jump magic is needed to get the timing stable on all the CPU's
+ *	we have to worry about.
+ */
+
+#include <linux/export.h>
+#include <linux/sched.h>
+#include <linux/timex.h>
+#include <linux/preempt.h>
+#include <linux/delay.h>
+
+#include <asm/processor.h>
+#include <asm/delay.h>
+#include <asm/timer.h>
+#include <asm/mwait.h>
+
+#ifdef CONFIG_SMP
+# include <asm/smp.h>
+#endif
+
+static void delay_loop(u64 __loops);
+
+/*
+ * Calibration and selection of the delay mechanism happens only once
+ * during boot.
+ */
+static void (*delay_fn)(u64) __ro_after_init = delay_loop;
+static void (*delay_halt_fn)(u64 start, u64 cycles) __ro_after_init;
+
+/* simple loop based delay: */
+static void delay_loop(u64 __loops)
+{
+	unsigned long loops = (unsigned long)__loops;
+
+	asm volatile(
+		"	test %0,%0	\n"
+		"	jz 3f		\n"
+		"	jmp 1f		\n"
+
+		".align 16		\n"
+		"1:	jmp 2f		\n"
+
+		".align 16		\n"
+		"2:	dec %0		\n"
+		"	jnz 2b		\n"
+		"3:	dec %0		\n"
+
+		: "+a" (loops)
+		:
+	);
+}
+
+/* TSC based delay: */
+static void delay_tsc(u64 cycles)
+{
+	u64 bclock, now;
+	int cpu;
+
+	preempt_disable();
+	cpu = smp_processor_id();
+	bclock = rdtsc_ordered();
+	for (;;) {
+		now = rdtsc_ordered();
+		if ((now - bclock) >= cycles)
+			break;
+
+		/* Allow RT tasks to run */
+		preempt_enable();
+		rep_nop();
+		preempt_disable();
+
+		/*
+		 * It is possible that we moved to another CPU, and
+		 * since TSC's are per-cpu we need to calculate
+		 * that. The delay must guarantee that we wait "at
+		 * least" the amount of time. Being moved to another
+		 * CPU could make the wait longer but we just need to
+		 * make sure we waited long enough. Rebalance the
+		 * counter for this CPU.
+		 */
+		if (unlikely(cpu != smp_processor_id())) {
+			cycles -= (now - bclock);
+			cpu = smp_processor_id();
+			bclock = rdtsc_ordered();
+		}
+	}
+	preempt_enable();
+}
+
+/*
+ * On Intel the TPAUSE instruction waits until any of:
+ * 1) the TSC counter exceeds the value provided in EDX:EAX
+ * 2) global timeout in IA32_UMWAIT_CONTROL is exceeded
+ * 3) an external interrupt occurs
+ */
+static void delay_halt_tpause(u64 start, u64 cycles)
+{
+	u64 until = start + cycles;
+	u32 eax, edx;
+
+	eax = lower_32_bits(until);
+	edx = upper_32_bits(until);
+
+	/*
+	 * Hard code the deeper (C0.2) sleep state because exit latency is
+	 * small compared to the "microseconds" that usleep() will delay.
+	 */
+	__tpause(TPAUSE_C02_STATE, edx, eax);
+}
+
+/*
+ * On some AMD platforms, MWAITX has a configurable 32-bit timer, that
+ * counts with TSC frequency. The input value is the number of TSC cycles
+ * to wait. MWAITX will also exit when the timer expires.
+ */
+static void delay_halt_mwaitx(u64 unused, u64 cycles)
+{
+	u64 delay;
+
+	delay = min_t(u64, MWAITX_MAX_WAIT_CYCLES, cycles);
+	/*
+	 * Use cpu_tss_rw as a cacheline-aligned, seldomly accessed per-cpu
+	 * variable as the monitor target.
+	 */
+	 __monitorx(raw_cpu_ptr(&cpu_tss_rw), 0, 0);
+
+	/*
+	 * AMD, like Intel, supports the EAX hint and EAX=0xf means, do not
+	 * enter any deep C-state and we use it here in delay() to minimize
+	 * wakeup latency.
+	 */
+	__mwaitx(MWAITX_DISABLE_CSTATES, delay, MWAITX_ECX_TIMER_ENABLE);
+}
+
+/*
+ * Call a vendor specific function to delay for a given amount of time. Because
+ * these functions may return earlier than requested, check for actual elapsed
+ * time and call again until done.
+ */
+static void delay_halt(u64 __cycles)
+{
+	u64 start, end, cycles = __cycles;
+
+	/*
+	 * Timer value of 0 causes MWAITX to wait indefinitely, unless there
+	 * is a store on the memory monitored by MONITORX.
+	 */
+	if (!cycles)
+		return;
+
+	start = rdtsc_ordered();
+
+	for (;;) {
+		delay_halt_fn(start, cycles);
+		end = rdtsc_ordered();
+
+		if (cycles <= end - start)
+			break;
+
+		cycles -= end - start;
+		start = end;
+	}
+}
+
+void __init use_tsc_delay(void)
+{
+	if (delay_fn == delay_loop)
+		delay_fn = delay_tsc;
+}
+
+void __init use_tpause_delay(void)
+{
+	delay_halt_fn = delay_halt_tpause;
+	delay_fn = delay_halt;
+}
+
+void use_mwaitx_delay(void)
+{
+	delay_halt_fn = delay_halt_mwaitx;
+	delay_fn = delay_halt;
+}
+
+int read_current_timer(unsigned long *timer_val)
+{
+	if (delay_fn == delay_tsc) {
+		*timer_val = rdtsc();
+		return 0;
+	}
+	return -1;
+}
+
+void __delay(unsigned long loops)
+{
+	delay_fn(loops);
+}
+EXPORT_SYMBOL(__delay);
+
+noinline void __const_udelay(unsigned long xloops)
+{
+	unsigned long lpj = this_cpu_read(cpu_info.loops_per_jiffy) ? : loops_per_jiffy;
+	int d0;
+
+	xloops *= 4;
+	asm("mull %%edx"
+		:"=d" (xloops), "=&a" (d0)
+		:"1" (xloops), "0" (lpj * (HZ / 4)));
+
+	__delay(++xloops);
+}
+EXPORT_SYMBOL(__const_udelay);
+
+void __udelay(unsigned long usecs)
+{
+	__const_udelay(usecs * 0x000010c7); /* 2**32 / 1000000 (rounded up) */
+}
+EXPORT_SYMBOL(__udelay);
+
+void __ndelay(unsigned long nsecs)
+{
+	__const_udelay(nsecs * 0x00005); /* 2**32 / 1000000000 (rounded up) */
+}
+EXPORT_SYMBOL(__ndelay);