1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
|
* Texas Instruments tsc2004 and tsc2005 touchscreen controllers
Required properties:
- compatible : "ti,tsc2004" or "ti,tsc2005"
- reg : Device address
- interrupts : IRQ specifier
- spi-max-frequency : Maximum SPI clocking speed of the device
(for tsc2005)
Optional properties:
- vio-supply : Regulator specifier
- reset-gpios : GPIO specifier for the controller reset line
- ti,x-plate-ohms : integer, resistance of the touchscreen's X plates
in ohm (defaults to 280)
- ti,esd-recovery-timeout-ms : integer, if the touchscreen does not respond after
the configured time (in milli seconds), the driver
will reset it. This is disabled by default.
- properties defined in touchscreen.txt
Example:
&i2c3 {
tsc2004@48 {
compatible = "ti,tsc2004";
reg = <0x48>;
vio-supply = <&vio>;
reset-gpios = <&gpio4 8 GPIO_ACTIVE_HIGH>;
interrupts-extended = <&gpio1 27 IRQ_TYPE_EDGE_RISING>;
touchscreen-fuzz-x = <4>;
touchscreen-fuzz-y = <7>;
touchscreen-fuzz-pressure = <2>;
touchscreen-size-x = <4096>;
touchscreen-size-y = <4096>;
touchscreen-max-pressure = <2048>;
ti,x-plate-ohms = <280>;
ti,esd-recovery-timeout-ms = <8000>;
};
}
&mcspi1 {
tsc2005@0 {
compatible = "ti,tsc2005";
spi-max-frequency = <6000000>;
reg = <0>;
vio-supply = <&vio>;
reset-gpios = <&gpio4 8 GPIO_ACTIVE_HIGH>; /* 104 */
interrupts-extended = <&gpio4 4 IRQ_TYPE_EDGE_RISING>; /* 100 */
touchscreen-fuzz-x = <4>;
touchscreen-fuzz-y = <7>;
touchscreen-fuzz-pressure = <2>;
touchscreen-size-x = <4096>;
touchscreen-size-y = <4096>;
touchscreen-max-pressure = <2048>;
ti,x-plate-ohms = <280>;
ti,esd-recovery-timeout-ms = <8000>;
};
}
|
