Adding upstream version 5.10.209.upstream/5.10.209upstream

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 239 insertions, 0 deletions

diff --git a/drivers/mtd/maps/scb2_flash.c b/drivers/mtd/maps/scb2_flash.c
new file mode 100644
index 000000000..57303f904
--- /dev/null
+++ b/drivers/mtd/maps/scb2_flash.c
@@ -0,0 +1,239 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/*
+ * MTD map driver for BIOS Flash on Intel SCB2 boards
+ * Copyright (C) 2002 Sun Microsystems, Inc.
+ * Tim Hockin <thockin@sun.com>
+ *
+ * A few notes on this MTD map:
+ *
+ * This was developed with a small number of SCB2 boards to test on.
+ * Hopefully, Intel has not introducted too many unaccounted variables in the
+ * making of this board.
+ *
+ * The BIOS marks its own memory region as 'reserved' in the e820 map.  We
+ * try to request it here, but if it fails, we carry on anyway.
+ *
+ * This is how the chip is attached, so said the schematic:
+ * * a 4 MiB (32 Mib) 16 bit chip
+ * * a 1 MiB memory region
+ * * A20 and A21 pulled up
+ * * D8-D15 ignored
+ * What this means is that, while we are addressing bytes linearly, we are
+ * really addressing words, and discarding the other byte.  This means that
+ * the chip MUST BE at least 2 MiB.  This also means that every block is
+ * actually half as big as the chip reports.  It also means that accesses of
+ * logical address 0 hit higher-address sections of the chip, not physical 0.
+ * One can only hope that these 4MiB x16 chips were a lot cheaper than 1MiB x8
+ * chips.
+ *
+ * This driver assumes the chip is not write-protected by an external signal.
+ * As of the this writing, that is true, but may change, just to spite me.
+ *
+ * The actual BIOS layout has been mostly reverse engineered.  Intel BIOS
+ * updates for this board include 10 related (*.bio - &.bi9) binary files and
+ * another separate (*.bbo) binary file.  The 10 files are 64k of data + a
+ * small header.  If the headers are stripped off, the 10 64k files can be
+ * concatenated into a 640k image.  This is your BIOS image, proper.  The
+ * separate .bbo file also has a small header.  It is the 'Boot Block'
+ * recovery BIOS.  Once the header is stripped, no further prep is needed.
+ * As best I can tell, the BIOS is arranged as such:
+ * offset 0x00000 to 0x4ffff (320k):  unknown - SCSI BIOS, etc?
+ * offset 0x50000 to 0xeffff (640k):  BIOS proper
+ * offset 0xf0000 ty 0xfffff (64k):   Boot Block region
+ *
+ * Intel's BIOS update program flashes the BIOS and Boot Block in separate
+ * steps.  Probably a wise thing to do.
+ */
+
+#include <linux/module.h>
+#include <linux/types.h>
+#include <linux/kernel.h>
+#include <asm/io.h>
+#include <linux/mtd/mtd.h>
+#include <linux/mtd/map.h>
+#include <linux/mtd/cfi.h>
+#include <linux/pci.h>
+#include <linux/pci_ids.h>
+
+#define MODNAME		"scb2_flash"
+#define SCB2_ADDR	0xfff00000
+#define SCB2_WINDOW	0x00100000
+
+
+static void __iomem *scb2_ioaddr;
+static struct mtd_info *scb2_mtd;
+static struct map_info scb2_map = {
+	.name =      "SCB2 BIOS Flash",
+	.size =      0,
+	.bankwidth =  1,
+};
+static int region_fail;
+
+static int scb2_fixup_mtd(struct mtd_info *mtd)
+{
+	int i;
+	int done = 0;
+	struct map_info *map = mtd->priv;
+	struct cfi_private *cfi = map->fldrv_priv;
+
+	/* barf if this doesn't look right */
+	if (cfi->cfiq->InterfaceDesc != CFI_INTERFACE_X16_ASYNC) {
+		printk(KERN_ERR MODNAME ": unsupported InterfaceDesc: %#x\n",
+		    cfi->cfiq->InterfaceDesc);
+		return -1;
+	}
+
+	/* I wasn't here. I didn't see. dwmw2. */
+
+	/* the chip is sometimes bigger than the map - what a waste */
+	mtd->size = map->size;
+
+	/*
+	 * We only REALLY get half the chip, due to the way it is
+	 * wired up - D8-D15 are tossed away.  We read linear bytes,
+	 * but in reality we are getting 1/2 of each 16-bit read,
+	 * which LOOKS linear to us.  Because CFI code accounts for
+	 * things like lock/unlock/erase by eraseregions, we need to
+	 * fudge them to reflect this.  Erases go like this:
+	 *   * send an erase to an address
+	 *   * the chip samples the address and erases the block
+	 *   * add the block erasesize to the address and repeat
+	 *   -- the problem is that addresses are 16-bit addressable
+	 *   -- we end up erasing every-other block
+	 */
+	mtd->erasesize /= 2;
+	for (i = 0; i < mtd->numeraseregions; i++) {
+		struct mtd_erase_region_info *region = &mtd->eraseregions[i];
+		region->erasesize /= 2;
+	}
+
+	/*
+	 * If the chip is bigger than the map, it is wired with the high
+	 * address lines pulled up.  This makes us access the top portion of
+	 * the chip, so all our erase-region info is wrong.  Start cutting from
+	 * the bottom.
+	 */
+	for (i = 0; !done && i < mtd->numeraseregions; i++) {
+		struct mtd_erase_region_info *region = &mtd->eraseregions[i];
+
+		if (region->numblocks * region->erasesize > mtd->size) {
+			region->numblocks = ((unsigned long)mtd->size /
+						region->erasesize);
+			done = 1;
+		} else {
+			region->numblocks = 0;
+		}
+		region->offset = 0;
+	}
+
+	return 0;
+}
+
+/* CSB5's 'Function Control Register' has bits for decoding @ >= 0xffc00000 */
+#define CSB5_FCR	0x41
+#define CSB5_FCR_DECODE_ALL 0x0e
+static int scb2_flash_probe(struct pci_dev *dev,
+			    const struct pci_device_id *ent)
+{
+	u8 reg;
+
+	/* enable decoding of the flash region in the south bridge */
+	pci_read_config_byte(dev, CSB5_FCR, &reg);
+	pci_write_config_byte(dev, CSB5_FCR, reg | CSB5_FCR_DECODE_ALL);
+
+	if (!request_mem_region(SCB2_ADDR, SCB2_WINDOW, scb2_map.name)) {
+		/*
+		 * The BIOS seems to mark the flash region as 'reserved'
+		 * in the e820 map.  Warn and go about our business.
+		 */
+		printk(KERN_WARNING MODNAME
+		    ": warning - can't reserve rom window, continuing\n");
+		region_fail = 1;
+	}
+
+	/* remap the IO window (w/o caching) */
+	scb2_ioaddr = ioremap(SCB2_ADDR, SCB2_WINDOW);
+	if (!scb2_ioaddr) {
+		printk(KERN_ERR MODNAME ": Failed to ioremap window!\n");
+		if (!region_fail)
+			release_mem_region(SCB2_ADDR, SCB2_WINDOW);
+		return -ENOMEM;
+	}
+
+	scb2_map.phys = SCB2_ADDR;
+	scb2_map.virt = scb2_ioaddr;
+	scb2_map.size = SCB2_WINDOW;
+
+	simple_map_init(&scb2_map);
+
+	/* try to find a chip */
+	scb2_mtd = do_map_probe("cfi_probe", &scb2_map);
+
+	if (!scb2_mtd) {
+		printk(KERN_ERR MODNAME ": flash probe failed!\n");
+		iounmap(scb2_ioaddr);
+		if (!region_fail)
+			release_mem_region(SCB2_ADDR, SCB2_WINDOW);
+		return -ENODEV;
+	}
+
+	scb2_mtd->owner = THIS_MODULE;
+	if (scb2_fixup_mtd(scb2_mtd) < 0) {
+		mtd_device_unregister(scb2_mtd);
+		map_destroy(scb2_mtd);
+		iounmap(scb2_ioaddr);
+		if (!region_fail)
+			release_mem_region(SCB2_ADDR, SCB2_WINDOW);
+		return -ENODEV;
+	}
+
+	printk(KERN_NOTICE MODNAME ": chip size 0x%llx at offset 0x%llx\n",
+	       (unsigned long long)scb2_mtd->size,
+	       (unsigned long long)(SCB2_WINDOW - scb2_mtd->size));
+
+	mtd_device_register(scb2_mtd, NULL, 0);
+
+	return 0;
+}
+
+static void scb2_flash_remove(struct pci_dev *dev)
+{
+	if (!scb2_mtd)
+		return;
+
+	/* disable flash writes */
+	mtd_lock(scb2_mtd, 0, scb2_mtd->size);
+
+	mtd_device_unregister(scb2_mtd);
+	map_destroy(scb2_mtd);
+
+	iounmap(scb2_ioaddr);
+	scb2_ioaddr = NULL;
+
+	if (!region_fail)
+		release_mem_region(SCB2_ADDR, SCB2_WINDOW);
+}
+
+static struct pci_device_id scb2_flash_pci_ids[] = {
+	{
+	  .vendor = PCI_VENDOR_ID_SERVERWORKS,
+	  .device = PCI_DEVICE_ID_SERVERWORKS_CSB5,
+	  .subvendor = PCI_ANY_ID,
+	  .subdevice = PCI_ANY_ID
+	},
+	{ 0, }
+};
+
+static struct pci_driver scb2_flash_driver = {
+	.name =     "Intel SCB2 BIOS Flash",
+	.id_table = scb2_flash_pci_ids,
+	.probe =    scb2_flash_probe,
+	.remove =   scb2_flash_remove,
+};
+
+module_pci_driver(scb2_flash_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_AUTHOR("Tim Hockin <thockin@sun.com>");
+MODULE_DESCRIPTION("MTD map driver for Intel SCB2 BIOS Flash");
+MODULE_DEVICE_TABLE(pci, scb2_flash_pci_ids);