diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt | 215 |
1 files changed, 215 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt b/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt new file mode 100644 index 000000000..a10d1f6d8 --- /dev/null +++ b/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt @@ -0,0 +1,215 @@ +* Rockchip rk3399 DMC (Dynamic Memory Controller) device + +Required properties: +- compatible: Must be "rockchip,rk3399-dmc". +- devfreq-events: Node to get DDR loading, Refer to + Documentation/devicetree/bindings/devfreq/event/ + rockchip-dfi.txt +- clocks: Phandles for clock specified in "clock-names" property +- clock-names : The name of clock used by the DFI, must be + "pclk_ddr_mon"; +- operating-points-v2: Refer to Documentation/devicetree/bindings/opp/opp.txt + for details. +- center-supply: DMC supply node. +- status: Marks the node enabled/disabled. + +Optional properties: +- interrupts: The CPU interrupt number. The interrupt specifier + format depends on the interrupt controller. + It should be a DCF interrupt. When DDR DVFS finishes + a DCF interrupt is triggered. +- rockchip,pmu: Phandle to the syscon managing the "PMU general register + files". + +Following properties relate to DDR timing: + +- rockchip,dram_speed_bin : Value reference include/dt-bindings/clock/rk3399-ddr.h, + it selects the DDR3 cl-trp-trcd type. It must be + set according to "Speed Bin" in DDR3 datasheet, + DO NOT use a smaller "Speed Bin" than specified + for the DDR3 being used. + +- rockchip,pd_idle : Configure the PD_IDLE value. Defines the + power-down idle period in which memories are + placed into power-down mode if bus is idle + for PD_IDLE DFI clock cycles. + +- rockchip,sr_idle : Configure the SR_IDLE value. Defines the + self-refresh idle period in which memories are + placed into self-refresh mode if bus is idle + for SR_IDLE * 1024 DFI clock cycles (DFI + clocks freq is half of DRAM clock), default + value is "0". + +- rockchip,sr_mc_gate_idle : Defines the memory self-refresh and controller + clock gating idle period. Memories are placed + into self-refresh mode and memory controller + clock arg gating started if bus is idle for + sr_mc_gate_idle*1024 DFI clock cycles. + +- rockchip,srpd_lite_idle : Defines the self-refresh power down idle + period in which memories are placed into + self-refresh power down mode if bus is idle + for srpd_lite_idle * 1024 DFI clock cycles. + This parameter is for LPDDR4 only. + +- rockchip,standby_idle : Defines the standby idle period in which + memories are placed into self-refresh mode. + The controller, pi, PHY and DRAM clock will + be gated if bus is idle for standby_idle * DFI + clock cycles. + +- rockchip,dram_dll_dis_freq : Defines the DDR3 DLL bypass frequency in MHz. + When DDR frequency is less than DRAM_DLL_DISB_FREQ, + DDR3 DLL will be bypassed. Note: if DLL was bypassed, + the odt will also stop working. + +- rockchip,phy_dll_dis_freq : Defines the PHY dll bypass frequency in + MHz (Mega Hz). When DDR frequency is less than + DRAM_DLL_DISB_FREQ, PHY DLL will be bypassed. + Note: PHY DLL and PHY ODT are independent. + +- rockchip,ddr3_odt_dis_freq : When the DRAM type is DDR3, this parameter defines + the ODT disable frequency in MHz (Mega Hz). + when the DDR frequency is less then ddr3_odt_dis_freq, + the ODT on the DRAM side and controller side are + both disabled. + +- rockchip,ddr3_drv : When the DRAM type is DDR3, this parameter defines + the DRAM side driver strength in ohms. Default + value is DDR3_DS_40ohm. + +- rockchip,ddr3_odt : When the DRAM type is DDR3, this parameter defines + the DRAM side ODT strength in ohms. Default value + is DDR3_ODT_120ohm. + +- rockchip,phy_ddr3_ca_drv : When the DRAM type is DDR3, this parameter defines + the phy side CA line (incluing command line, + address line and clock line) driver strength. + Default value is PHY_DRV_ODT_40. + +- rockchip,phy_ddr3_dq_drv : When the DRAM type is DDR3, this parameter defines + the PHY side DQ line (including DQS/DQ/DM line) + driver strength. Default value is PHY_DRV_ODT_40. + +- rockchip,phy_ddr3_odt : When the DRAM type is DDR3, this parameter defines + the PHY side ODT strength. Default value is + PHY_DRV_ODT_240. + +- rockchip,lpddr3_odt_dis_freq : When the DRAM type is LPDDR3, this parameter defines + then ODT disable frequency in MHz (Mega Hz). + When DDR frequency is less then ddr3_odt_dis_freq, + the ODT on the DRAM side and controller side are + both disabled. + +- rockchip,lpddr3_drv : When the DRAM type is LPDDR3, this parameter defines + the DRAM side driver strength in ohms. Default + value is LP3_DS_34ohm. + +- rockchip,lpddr3_odt : When the DRAM type is LPDDR3, this parameter defines + the DRAM side ODT strength in ohms. Default value + is LP3_ODT_240ohm. + +- rockchip,phy_lpddr3_ca_drv : When the DRAM type is LPDDR3, this parameter defines + the PHY side CA line (including command line, + address line and clock line) driver strength. + Default value is PHY_DRV_ODT_40. + +- rockchip,phy_lpddr3_dq_drv : When the DRAM type is LPDDR3, this parameter defines + the PHY side DQ line (including DQS/DQ/DM line) + driver strength. Default value is + PHY_DRV_ODT_40. + +- rockchip,phy_lpddr3_odt : When dram type is LPDDR3, this parameter define + the phy side odt strength, default value is + PHY_DRV_ODT_240. + +- rockchip,lpddr4_odt_dis_freq : When the DRAM type is LPDDR4, this parameter + defines the ODT disable frequency in + MHz (Mega Hz). When the DDR frequency is less then + ddr3_odt_dis_freq, the ODT on the DRAM side and + controller side are both disabled. + +- rockchip,lpddr4_drv : When the DRAM type is LPDDR4, this parameter defines + the DRAM side driver strength in ohms. Default + value is LP4_PDDS_60ohm. + +- rockchip,lpddr4_dq_odt : When the DRAM type is LPDDR4, this parameter defines + the DRAM side ODT on DQS/DQ line strength in ohms. + Default value is LP4_DQ_ODT_40ohm. + +- rockchip,lpddr4_ca_odt : When the DRAM type is LPDDR4, this parameter defines + the DRAM side ODT on CA line strength in ohms. + Default value is LP4_CA_ODT_40ohm. + +- rockchip,phy_lpddr4_ca_drv : When the DRAM type is LPDDR4, this parameter defines + the PHY side CA line (including command address + line) driver strength. Default value is + PHY_DRV_ODT_40. + +- rockchip,phy_lpddr4_ck_cs_drv : When the DRAM type is LPDDR4, this parameter defines + the PHY side clock line and CS line driver + strength. Default value is PHY_DRV_ODT_80. + +- rockchip,phy_lpddr4_dq_drv : When the DRAM type is LPDDR4, this parameter defines + the PHY side DQ line (including DQS/DQ/DM line) + driver strength. Default value is PHY_DRV_ODT_80. + +- rockchip,phy_lpddr4_odt : When the DRAM type is LPDDR4, this parameter defines + the PHY side ODT strength. Default value is + PHY_DRV_ODT_60. + +Example: + dmc_opp_table: dmc_opp_table { + compatible = "operating-points-v2"; + + opp00 { + opp-hz = /bits/ 64 <300000000>; + opp-microvolt = <900000>; + }; + opp01 { + opp-hz = /bits/ 64 <666000000>; + opp-microvolt = <900000>; + }; + }; + + dmc: dmc { + compatible = "rockchip,rk3399-dmc"; + devfreq-events = <&dfi>; + interrupts = <GIC_SPI 1 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&cru SCLK_DDRCLK>; + clock-names = "dmc_clk"; + operating-points-v2 = <&dmc_opp_table>; + center-supply = <&ppvar_centerlogic>; + upthreshold = <15>; + downdifferential = <10>; + rockchip,ddr3_speed_bin = <21>; + rockchip,pd_idle = <0x40>; + rockchip,sr_idle = <0x2>; + rockchip,sr_mc_gate_idle = <0x3>; + rockchip,srpd_lite_idle = <0x4>; + rockchip,standby_idle = <0x2000>; + rockchip,dram_dll_dis_freq = <300>; + rockchip,phy_dll_dis_freq = <125>; + rockchip,auto_pd_dis_freq = <666>; + rockchip,ddr3_odt_dis_freq = <333>; + rockchip,ddr3_drv = <DDR3_DS_40ohm>; + rockchip,ddr3_odt = <DDR3_ODT_120ohm>; + rockchip,phy_ddr3_ca_drv = <PHY_DRV_ODT_40>; + rockchip,phy_ddr3_dq_drv = <PHY_DRV_ODT_40>; + rockchip,phy_ddr3_odt = <PHY_DRV_ODT_240>; + rockchip,lpddr3_odt_dis_freq = <333>; + rockchip,lpddr3_drv = <LP3_DS_34ohm>; + rockchip,lpddr3_odt = <LP3_ODT_240ohm>; + rockchip,phy_lpddr3_ca_drv = <PHY_DRV_ODT_40>; + rockchip,phy_lpddr3_dq_drv = <PHY_DRV_ODT_40>; + rockchip,phy_lpddr3_odt = <PHY_DRV_ODT_240>; + rockchip,lpddr4_odt_dis_freq = <333>; + rockchip,lpddr4_drv = <LP4_PDDS_60ohm>; + rockchip,lpddr4_dq_odt = <LP4_DQ_ODT_40ohm>; + rockchip,lpddr4_ca_odt = <LP4_CA_ODT_40ohm>; + rockchip,phy_lpddr4_ca_drv = <PHY_DRV_ODT_40>; + rockchip,phy_lpddr4_ck_cs_drv = <PHY_DRV_ODT_80>; + rockchip,phy_lpddr4_dq_drv = <PHY_DRV_ODT_80>; + rockchip,phy_lpddr4_odt = <PHY_DRV_ODT_60>; + }; |