1 files changed, 58 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt b/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt
new file mode 100644
index 000000000..651d957d1
--- /dev/null
+++ b/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt
@@ -0,0 +1,58 @@
+* Samsung Exynos 5440 PCIe interface
+
+This PCIe host controller is based on the Synopsys DesignWare PCIe IP
+and thus inherits all the common properties defined in designware-pcie.txt.
+
+Required properties:
+- compatible: "samsung,exynos5440-pcie"
+- reg: base addresses and lengths of the PCIe controller,
+- reg-names : First name should be set to "elbi".
+	And use the "config" instead of getting the configuration address space
+	from "ranges".
+	NOTE: When using the "config" property, reg-names must be set.
+- interrupts: A list of interrupt outputs for level interrupt,
+	pulse interrupt, special interrupt.
+- phys: From PHY binding. Phandle for the generic PHY.
+	Refer to Documentation/devicetree/bindings/phy/samsung-phy.txt
+
+For other common properties, refer to
+	Documentation/devicetree/bindings/pci/designware-pcie.txt
+
+Example:
+
+SoC-specific DT Entry (with using PHY framework):
+
+	pcie_phy0: pcie-phy@270000 {
+		...
+		reg = <0x270000 0x1000>, <0x271000 0x40>;
+		reg-names = "phy", "block";
+		...
+	};
+
+	pcie@290000 {
+		compatible = "samsung,exynos5440-pcie", "snps,dw-pcie";
+		reg = <0x290000 0x1000>, <0x40000000 0x1000>;
+		reg-names = "elbi", "config";
+		clocks = <&clock 28>, <&clock 27>;
+		clock-names = "pcie", "pcie_bus";
+		#address-cells = <3>;
+		#size-cells = <2>;
+		device_type = "pci";
+		phys = <&pcie_phy0>;
+		ranges = <0x81000000 0 0	  0x60001000 0 0x00010000
+			  0x82000000 0 0x60011000 0x60011000 0 0x1ffef000>;
+		#interrupt-cells = <1>;
+		interrupt-map-mask = <0 0 0 0>;
+		interrupt-map = <0 0 0 0 &gic GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
+		num-lanes = <4>;
+	};
+
+Board-specific DT Entry:
+
+	pcie@290000 {
+		reset-gpio = <&pin_ctrl 5 0>;
+	};
+
+	pcie@2a0000 {
+		reset-gpio = <&pin_ctrl 22 0>;
+	};