diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/devicetree/bindings/regulator/max8973-regulator.txt | 52 |
1 files changed, 52 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/regulator/max8973-regulator.txt b/Documentation/devicetree/bindings/regulator/max8973-regulator.txt new file mode 100644 index 000000000..c2c68fcc1 --- /dev/null +++ b/Documentation/devicetree/bindings/regulator/max8973-regulator.txt @@ -0,0 +1,52 @@ +* Maxim MAX8973 Voltage Regulator + +Required properties: + +- compatible: must be one of following: + "maxim,max8973" + "maxim,max77621". +- reg: the i2c slave address of the regulator. It should be 0x1b. + +Any standard regulator properties can be used to configure the single max8973 +DCDC. + +Optional properties: + +-maxim,externally-enable: boolean, externally control the regulator output + enable/disable. +-maxim,enable-gpio: GPIO for enable control. If the valid GPIO is provided + then externally enable control will be considered. +-maxim,dvs-gpio: GPIO which is connected to DVS pin of device. +-maxim,dvs-default-state: Default state of GPIO during initialisation. + 1 for HIGH and 0 for LOW. +-maxim,enable-remote-sense: boolean, enable reote sense. +-maxim,enable-falling-slew-rate: boolean, enable falling slew rate. +-maxim,enable-active-discharge: boolean: enable active discharge. +-maxim,enable-frequency-shift: boolean, enable 9% frequency shift. +-maxim,enable-bias-control: boolean, enable bias control. By enabling this + startup delay can be reduce to 20us from 220us. +-maxim,enable-etr: boolean, enable Enhanced Transient Response. +-maxim,enable-high-etr-sensitivity: boolean, Enhanced transient response + circuit is enabled and set for high sensitivity. If this + property is available then etr will be enable default. + +Enhanced transient response (ETR) will affect the configuration of CKADV. + +-junction-warn-millicelsius: u32, junction warning temperature threshold + in millicelsius. If die temperature crosses this level then + device generates the warning interrupts. + +Please note that thermal functionality is only supported on MAX77621. The +supported threshold warning temperature for MAX77621 are 120 degC and 140 degC. + +Example: + + max8973@1b { + compatible = "maxim,max8973"; + reg = <0x1b>; + + regulator-min-microvolt = <935000>; + regulator-max-microvolt = <1200000>; + regulator-boot-on; + regulator-always-on; + }; |