diff options
Diffstat (limited to 'drivers/pcmcia/ricoh.h')
| -rw-r--r-- | drivers/pcmcia/ricoh.h | 241 |
1 files changed, 241 insertions, 0 deletions
diff --git a/drivers/pcmcia/ricoh.h b/drivers/pcmcia/ricoh.h new file mode 100644 index 000000000..8ac7b138c --- /dev/null +++ b/drivers/pcmcia/ricoh.h @@ -0,0 +1,241 @@ +/* + * ricoh.h 1.9 1999/10/25 20:03:34 + * + * The contents of this file are subject to the Mozilla Public License + * Version 1.1 (the "License"); you may not use this file except in + * compliance with the License. You may obtain a copy of the License + * at http://www.mozilla.org/MPL/ + * + * Software distributed under the License is distributed on an "AS IS" + * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See + * the License for the specific language governing rights and + * limitations under the License. + * + * The initial developer of the original code is David A. Hinds + * <dahinds@users.sourceforge.net>. Portions created by David A. Hinds + * are Copyright (C) 1999 David A. Hinds. All Rights Reserved. + * + * Alternatively, the contents of this file may be used under the + * terms of the GNU General Public License version 2 (the "GPL"), in which + * case the provisions of the GPL are applicable instead of the + * above. If you wish to allow the use of your version of this file + * only under the terms of the GPL and not to allow others to use + * your version of this file under the MPL, indicate your decision by + * deleting the provisions above and replace them with the notice and + * other provisions required by the GPL. If you do not delete the + * provisions above, a recipient may use your version of this file + * under either the MPL or the GPL. + */ + +#ifndef _LINUX_RICOH_H +#define _LINUX_RICOH_H + + +#define RF5C_MODE_CTL 0x1f /* Mode control */ +#define RF5C_PWR_CTL 0x2f /* Mixed voltage control */ +#define RF5C_CHIP_ID 0x3a /* Chip identification */ +#define RF5C_MODE_CTL_3 0x3b /* Mode control 3 */ + +/* I/O window address offset */ +#define RF5C_IO_OFF(w) (0x36+((w)<<1)) + +/* Flags for RF5C_MODE_CTL */ +#define RF5C_MODE_ATA 0x01 /* ATA mode */ +#define RF5C_MODE_LED_ENA 0x02 /* IRQ 12 is LED */ +#define RF5C_MODE_CA21 0x04 +#define RF5C_MODE_CA22 0x08 +#define RF5C_MODE_CA23 0x10 +#define RF5C_MODE_CA24 0x20 +#define RF5C_MODE_CA25 0x40 +#define RF5C_MODE_3STATE_BIT7 0x80 + +/* Flags for RF5C_PWR_CTL */ +#define RF5C_PWR_VCC_3V 0x01 +#define RF5C_PWR_IREQ_HIGH 0x02 +#define RF5C_PWR_INPACK_ENA 0x04 +#define RF5C_PWR_5V_DET 0x08 +#define RF5C_PWR_TC_SEL 0x10 /* Terminal Count: irq 11 or 15 */ +#define RF5C_PWR_DREQ_LOW 0x20 +#define RF5C_PWR_DREQ_OFF 0x00 /* DREQ steering control */ +#define RF5C_PWR_DREQ_INPACK 0x40 +#define RF5C_PWR_DREQ_SPKR 0x80 +#define RF5C_PWR_DREQ_IOIS16 0xc0 + +/* Values for RF5C_CHIP_ID */ +#define RF5C_CHIP_RF5C296 0x32 +#define RF5C_CHIP_RF5C396 0xb2 + +/* Flags for RF5C_MODE_CTL_3 */ +#define RF5C_MCTL3_DISABLE 0x01 /* Disable PCMCIA interface */ +#define RF5C_MCTL3_DMA_ENA 0x02 + +/* Register definitions for Ricoh PCI-to-CardBus bridges */ + +/* Extra bits in CB_BRIDGE_CONTROL */ +#define RL5C46X_BCR_3E0_ENA 0x0800 +#define RL5C46X_BCR_3E2_ENA 0x1000 + +/* Bridge Configuration Register */ +#define RL5C4XX_CONFIG 0x80 /* 16 bit */ +#define RL5C4XX_CONFIG_IO_1_MODE 0x0200 +#define RL5C4XX_CONFIG_IO_0_MODE 0x0100 +#define RL5C4XX_CONFIG_PREFETCH 0x0001 + +/* Misc Control Register */ +#define RL5C4XX_MISC 0x0082 /* 16 bit */ +#define RL5C4XX_MISC_HW_SUSPEND_ENA 0x0002 +#define RL5C4XX_MISC_VCCEN_POL 0x0100 +#define RL5C4XX_MISC_VPPEN_POL 0x0200 +#define RL5C46X_MISC_SUSPEND 0x0001 +#define RL5C46X_MISC_PWR_SAVE_2 0x0004 +#define RL5C46X_MISC_IFACE_BUSY 0x0008 +#define RL5C46X_MISC_B_LOCK 0x0010 +#define RL5C46X_MISC_A_LOCK 0x0020 +#define RL5C46X_MISC_PCI_LOCK 0x0040 +#define RL5C47X_MISC_IFACE_BUSY 0x0004 +#define RL5C47X_MISC_PCI_INT_MASK 0x0018 +#define RL5C47X_MISC_PCI_INT_DIS 0x0020 +#define RL5C47X_MISC_SUBSYS_WR 0x0040 +#define RL5C47X_MISC_SRIRQ_ENA 0x0080 +#define RL5C47X_MISC_5V_DISABLE 0x0400 +#define RL5C47X_MISC_LED_POL 0x0800 + +/* 16-bit Interface Control Register */ +#define RL5C4XX_16BIT_CTL 0x0084 /* 16 bit */ +#define RL5C4XX_16CTL_IO_TIMING 0x0100 +#define RL5C4XX_16CTL_MEM_TIMING 0x0200 +#define RL5C46X_16CTL_LEVEL_1 0x0010 +#define RL5C46X_16CTL_LEVEL_2 0x0020 + +/* 16-bit IO and memory timing registers */ +#define RL5C4XX_16BIT_IO_0 0x0088 /* 16 bit */ +#define RL5C4XX_16BIT_MEM_0 0x008a /* 16 bit */ +#define RL5C4XX_SETUP_MASK 0x0007 +#define RL5C4XX_SETUP_SHIFT 0 +#define RL5C4XX_CMD_MASK 0x01f0 +#define RL5C4XX_CMD_SHIFT 4 +#define RL5C4XX_HOLD_MASK 0x1c00 +#define RL5C4XX_HOLD_SHIFT 10 +#define RL5C4XX_MISC_CONTROL 0x2F /* 8 bit */ +#define RL5C4XX_ZV_ENABLE 0x08 + +/* Misc Control 3 Register */ +#define RL5C4XX_MISC3 0x00A2 /* 16 bit */ +#define RL5C47X_MISC3_CB_CLKRUN_DIS BIT(1) + +#ifdef __YENTA_H + +#define rl_misc(socket) ((socket)->private[0]) +#define rl_ctl(socket) ((socket)->private[1]) +#define rl_io(socket) ((socket)->private[2]) +#define rl_mem(socket) ((socket)->private[3]) +#define rl_config(socket) ((socket)->private[4]) + +static void ricoh_zoom_video(struct pcmcia_socket *sock, int onoff) +{ + u8 reg; + struct yenta_socket *socket = container_of(sock, struct yenta_socket, socket); + + reg = config_readb(socket, RL5C4XX_MISC_CONTROL); + if (onoff) + /* Zoom zoom, we will all go together, zoom zoom, zoom zoom */ + reg |= RL5C4XX_ZV_ENABLE; + else + reg &= ~RL5C4XX_ZV_ENABLE; + + config_writeb(socket, RL5C4XX_MISC_CONTROL, reg); +} + +static void ricoh_set_zv(struct yenta_socket *socket) +{ + if(socket->dev->vendor == PCI_VENDOR_ID_RICOH) + { + switch(socket->dev->device) + { + /* There may be more .. */ + case PCI_DEVICE_ID_RICOH_RL5C478: + socket->socket.zoom_video = ricoh_zoom_video; + break; + } + } +} + +static void ricoh_set_clkrun(struct yenta_socket *socket, bool quiet) +{ + u16 misc3; + + /* + * RL5C475II likely has this setting, too, however no datasheet + * is publicly available for this chip + */ + if (socket->dev->device != PCI_DEVICE_ID_RICOH_RL5C476 && + socket->dev->device != PCI_DEVICE_ID_RICOH_RL5C478) + return; + + if (socket->dev->revision < 0x80) + return; + + misc3 = config_readw(socket, RL5C4XX_MISC3); + if (misc3 & RL5C47X_MISC3_CB_CLKRUN_DIS) { + if (!quiet) + dev_dbg(&socket->dev->dev, + "CLKRUN feature already disabled\n"); + } else if (disable_clkrun) { + if (!quiet) + dev_info(&socket->dev->dev, + "Disabling CLKRUN feature\n"); + misc3 |= RL5C47X_MISC3_CB_CLKRUN_DIS; + config_writew(socket, RL5C4XX_MISC3, misc3); + } +} + +static void ricoh_save_state(struct yenta_socket *socket) +{ + rl_misc(socket) = config_readw(socket, RL5C4XX_MISC); + rl_ctl(socket) = config_readw(socket, RL5C4XX_16BIT_CTL); + rl_io(socket) = config_readw(socket, RL5C4XX_16BIT_IO_0); + rl_mem(socket) = config_readw(socket, RL5C4XX_16BIT_MEM_0); + rl_config(socket) = config_readw(socket, RL5C4XX_CONFIG); +} + +static void ricoh_restore_state(struct yenta_socket *socket) +{ + config_writew(socket, RL5C4XX_MISC, rl_misc(socket)); + config_writew(socket, RL5C4XX_16BIT_CTL, rl_ctl(socket)); + config_writew(socket, RL5C4XX_16BIT_IO_0, rl_io(socket)); + config_writew(socket, RL5C4XX_16BIT_MEM_0, rl_mem(socket)); + config_writew(socket, RL5C4XX_CONFIG, rl_config(socket)); + ricoh_set_clkrun(socket, true); +} + + +/* + * Magic Ricoh initialization code.. + */ +static int ricoh_override(struct yenta_socket *socket) +{ + u16 config, ctl; + + config = config_readw(socket, RL5C4XX_CONFIG); + + /* Set the default timings, don't trust the original values */ + ctl = RL5C4XX_16CTL_IO_TIMING | RL5C4XX_16CTL_MEM_TIMING; + + if(socket->dev->device < PCI_DEVICE_ID_RICOH_RL5C475) { + ctl |= RL5C46X_16CTL_LEVEL_1 | RL5C46X_16CTL_LEVEL_2; + } else { + config |= RL5C4XX_CONFIG_PREFETCH; + } + + config_writew(socket, RL5C4XX_16BIT_CTL, ctl); + config_writew(socket, RL5C4XX_CONFIG, config); + + ricoh_set_zv(socket); + ricoh_set_clkrun(socket, false); + + return 0; +} + +#endif /* CONFIG_CARDBUS */ + +#endif /* _LINUX_RICOH_H */ |