From 5d1646d90e1f2cceb9f0828f4b28318cd0ec7744 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sat, 27 Apr 2024 12:05:51 +0200 Subject: Adding upstream version 5.10.209. Signed-off-by: Daniel Baumann --- .../bindings/power/supply/lt3651-charger.txt | 29 ++++++++++++++++++++++ 1 file changed, 29 insertions(+) create mode 100644 Documentation/devicetree/bindings/power/supply/lt3651-charger.txt (limited to 'Documentation/devicetree/bindings/power/supply/lt3651-charger.txt') diff --git a/Documentation/devicetree/bindings/power/supply/lt3651-charger.txt b/Documentation/devicetree/bindings/power/supply/lt3651-charger.txt new file mode 100644 index 000000000..40811ff8d --- /dev/null +++ b/Documentation/devicetree/bindings/power/supply/lt3651-charger.txt @@ -0,0 +1,29 @@ +Analog Devices LT3651 Charger Power Supply bindings: lt3651-charger + +Required properties: +- compatible: Should contain one of the following: + * "lltc,ltc3651-charger", (DEPRECATED: Use "lltc,lt3651-charger") + * "lltc,lt3651-charger" + - lltc,acpr-gpios: Connect to ACPR output. See remark below. + +Optional properties: + - lltc,fault-gpios: Connect to FAULT output. See remark below. + - lltc,chrg-gpios: Connect to CHRG output. See remark below. + +The lt3651 outputs are open-drain type and active low. The driver assumes the +GPIO reports "active" when the output is asserted, so if the pins have been +connected directly, the GPIO flags should be set to active low also. + +The driver will attempt to aquire interrupts for all GPIOs to detect changes in +line state. If the system is not capabale of providing interrupts, the driver +cannot report changes and userspace will need to periodically read the sysfs +attributes to detect changes. + +Example: + + charger: battery-charger { + compatible = "lltc,lt3651-charger"; + lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>; + lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>; + lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>; + }; -- cgit v1.2.3