From 5d1646d90e1f2cceb9f0828f4b28318cd0ec7744 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sat, 27 Apr 2024 12:05:51 +0200 Subject: Adding upstream version 5.10.209. Signed-off-by: Daniel Baumann --- drivers/ata/pata_cs5520.c | 297 ++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 297 insertions(+) create mode 100644 drivers/ata/pata_cs5520.c (limited to 'drivers/ata/pata_cs5520.c') diff --git a/drivers/ata/pata_cs5520.c b/drivers/ata/pata_cs5520.c new file mode 100644 index 000000000..9052148b3 --- /dev/null +++ b/drivers/ata/pata_cs5520.c @@ -0,0 +1,297 @@ +// SPDX-License-Identifier: GPL-2.0-or-later +/* + * IDE tuning and bus mastering support for the CS5510/CS5520 + * chipsets + * + * The CS5510/CS5520 are slightly unusual devices. Unlike the + * typical IDE controllers they do bus mastering with the drive in + * PIO mode and smarter silicon. + * + * The practical upshot of this is that we must always tune the + * drive for the right PIO mode. We must also ignore all the blacklists + * and the drive bus mastering DMA information. Also to confuse matters + * further we can do DMA on PIO only drives. + * + * DMA on the 5510 also requires we disable_hlt() during DMA on early + * revisions. + * + * *** This driver is strictly experimental *** + * + * (c) Copyright Red Hat Inc 2002 + * + * Documentation: + * Not publicly available. + */ +#include +#include +#include +#include +#include +#include +#include + +#define DRV_NAME "pata_cs5520" +#define DRV_VERSION "0.6.6" + +struct pio_clocks +{ + int address; + int assert; + int recovery; +}; + +static const struct pio_clocks cs5520_pio_clocks[]={ + {3, 6, 11}, + {2, 5, 6}, + {1, 4, 3}, + {1, 3, 2}, + {1, 2, 1} +}; + +/** + * cs5520_set_timings - program PIO timings + * @ap: ATA port + * @adev: ATA device + * + * Program the PIO mode timings for the controller according to the pio + * clocking table. + */ + +static void cs5520_set_timings(struct ata_port *ap, struct ata_device *adev, int pio) +{ + struct pci_dev *pdev = to_pci_dev(ap->host->dev); + int slave = adev->devno; + + pio -= XFER_PIO_0; + + /* Channel command timing */ + pci_write_config_byte(pdev, 0x62 + ap->port_no, + (cs5520_pio_clocks[pio].recovery << 4) | + (cs5520_pio_clocks[pio].assert)); + /* FIXME: should these use address ? */ + /* Read command timing */ + pci_write_config_byte(pdev, 0x64 + 4*ap->port_no + slave, + (cs5520_pio_clocks[pio].recovery << 4) | + (cs5520_pio_clocks[pio].assert)); + /* Write command timing */ + pci_write_config_byte(pdev, 0x66 + 4*ap->port_no + slave, + (cs5520_pio_clocks[pio].recovery << 4) | + (cs5520_pio_clocks[pio].assert)); +} + +/** + * cs5520_set_piomode - program PIO timings + * @ap: ATA port + * @adev: ATA device + * + * Program the PIO mode timings for the controller according to the pio + * clocking table. + */ + +static void cs5520_set_piomode(struct ata_port *ap, struct ata_device *adev) +{ + cs5520_set_timings(ap, adev, adev->pio_mode); +} + +static struct scsi_host_template cs5520_sht = { + ATA_BMDMA_SHT(DRV_NAME), + .sg_tablesize = LIBATA_DUMB_MAX_PRD, +}; + +static struct ata_port_operations cs5520_port_ops = { + .inherits = &ata_bmdma_port_ops, + .qc_prep = ata_bmdma_dumb_qc_prep, + .cable_detect = ata_cable_40wire, + .set_piomode = cs5520_set_piomode, +}; + +static int cs5520_init_one(struct pci_dev *pdev, const struct pci_device_id *id) +{ + static const unsigned int cmd_port[] = { 0x1F0, 0x170 }; + static const unsigned int ctl_port[] = { 0x3F6, 0x376 }; + struct ata_port_info pi = { + .flags = ATA_FLAG_SLAVE_POSS, + .pio_mask = ATA_PIO4, + .port_ops = &cs5520_port_ops, + }; + const struct ata_port_info *ppi[2]; + u8 pcicfg; + void __iomem *iomap[5]; + struct ata_host *host; + struct ata_ioports *ioaddr; + int i, rc; + + rc = pcim_enable_device(pdev); + if (rc) + return rc; + + /* IDE port enable bits */ + pci_read_config_byte(pdev, 0x60, &pcicfg); + + /* Check if the ATA ports are enabled */ + if ((pcicfg & 3) == 0) + return -ENODEV; + + ppi[0] = ppi[1] = &ata_dummy_port_info; + if (pcicfg & 1) + ppi[0] = π + if (pcicfg & 2) + ppi[1] = π + + if ((pcicfg & 0x40) == 0) { + dev_warn(&pdev->dev, "DMA mode disabled. Enabling.\n"); + pci_write_config_byte(pdev, 0x60, pcicfg | 0x40); + } + + pi.mwdma_mask = id->driver_data; + + host = ata_host_alloc_pinfo(&pdev->dev, ppi, 2); + if (!host) + return -ENOMEM; + + /* Perform set up for DMA */ + if (pci_enable_device_io(pdev)) { + printk(KERN_ERR DRV_NAME ": unable to configure BAR2.\n"); + return -ENODEV; + } + + if (dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32))) { + printk(KERN_ERR DRV_NAME ": unable to configure DMA mask.\n"); + return -ENODEV; + } + + /* Map IO ports and initialize host accordingly */ + iomap[0] = devm_ioport_map(&pdev->dev, cmd_port[0], 8); + iomap[1] = devm_ioport_map(&pdev->dev, ctl_port[0], 1); + iomap[2] = devm_ioport_map(&pdev->dev, cmd_port[1], 8); + iomap[3] = devm_ioport_map(&pdev->dev, ctl_port[1], 1); + iomap[4] = pcim_iomap(pdev, 2, 0); + + if (!iomap[0] || !iomap[1] || !iomap[2] || !iomap[3] || !iomap[4]) + return -ENOMEM; + + ioaddr = &host->ports[0]->ioaddr; + ioaddr->cmd_addr = iomap[0]; + ioaddr->ctl_addr = iomap[1]; + ioaddr->altstatus_addr = iomap[1]; + ioaddr->bmdma_addr = iomap[4]; + ata_sff_std_ports(ioaddr); + + ata_port_desc(host->ports[0], + "cmd 0x%x ctl 0x%x", cmd_port[0], ctl_port[0]); + ata_port_pbar_desc(host->ports[0], 4, 0, "bmdma"); + + ioaddr = &host->ports[1]->ioaddr; + ioaddr->cmd_addr = iomap[2]; + ioaddr->ctl_addr = iomap[3]; + ioaddr->altstatus_addr = iomap[3]; + ioaddr->bmdma_addr = iomap[4] + 8; + ata_sff_std_ports(ioaddr); + + ata_port_desc(host->ports[1], + "cmd 0x%x ctl 0x%x", cmd_port[1], ctl_port[1]); + ata_port_pbar_desc(host->ports[1], 4, 8, "bmdma"); + + /* activate the host */ + pci_set_master(pdev); + rc = ata_host_start(host); + if (rc) + return rc; + + for (i = 0; i < 2; i++) { + static const int irq[] = { 14, 15 }; + struct ata_port *ap = host->ports[i]; + + if (ata_port_is_dummy(ap)) + continue; + + rc = devm_request_irq(&pdev->dev, irq[ap->port_no], + ata_bmdma_interrupt, 0, DRV_NAME, host); + if (rc) + return rc; + + ata_port_desc(ap, "irq %d", irq[i]); + } + + return ata_host_register(host, &cs5520_sht); +} + +#ifdef CONFIG_PM_SLEEP +/** + * cs5520_reinit_one - device resume + * @pdev: PCI device + * + * Do any reconfiguration work needed by a resume from RAM. We need + * to restore DMA mode support on BIOSen which disabled it + */ + +static int cs5520_reinit_one(struct pci_dev *pdev) +{ + struct ata_host *host = pci_get_drvdata(pdev); + u8 pcicfg; + int rc; + + rc = ata_pci_device_do_resume(pdev); + if (rc) + return rc; + + pci_read_config_byte(pdev, 0x60, &pcicfg); + if ((pcicfg & 0x40) == 0) + pci_write_config_byte(pdev, 0x60, pcicfg | 0x40); + + ata_host_resume(host); + return 0; +} + +/** + * cs5520_pci_device_suspend - device suspend + * @pdev: PCI device + * + * We have to cut and waste bits from the standard method because + * the 5520 is a bit odd and not just a pure ATA device. As a result + * we must not disable it. The needed code is short and this avoids + * chip specific mess in the core code. + */ + +static int cs5520_pci_device_suspend(struct pci_dev *pdev, pm_message_t mesg) +{ + struct ata_host *host = pci_get_drvdata(pdev); + int rc = 0; + + rc = ata_host_suspend(host, mesg); + if (rc) + return rc; + + pci_save_state(pdev); + return 0; +} +#endif /* CONFIG_PM_SLEEP */ + +/* For now keep DMA off. We can set it for all but A rev CS5510 once the + core ATA code can handle it */ + +static const struct pci_device_id pata_cs5520[] = { + { PCI_VDEVICE(CYRIX, PCI_DEVICE_ID_CYRIX_5510), }, + { PCI_VDEVICE(CYRIX, PCI_DEVICE_ID_CYRIX_5520), }, + + { }, +}; + +static struct pci_driver cs5520_pci_driver = { + .name = DRV_NAME, + .id_table = pata_cs5520, + .probe = cs5520_init_one, + .remove = ata_pci_remove_one, +#ifdef CONFIG_PM_SLEEP + .suspend = cs5520_pci_device_suspend, + .resume = cs5520_reinit_one, +#endif +}; + +module_pci_driver(cs5520_pci_driver); + +MODULE_AUTHOR("Alan Cox"); +MODULE_DESCRIPTION("low-level driver for Cyrix CS5510/5520"); +MODULE_LICENSE("GPL"); +MODULE_DEVICE_TABLE(pci, pata_cs5520); +MODULE_VERSION(DRV_VERSION); -- cgit v1.2.3