diff options
Diffstat (limited to '')
| -rw-r--r-- | doc/cephadm/client-setup.rst | 36 |
1 files changed, 20 insertions, 16 deletions
diff --git a/doc/cephadm/client-setup.rst b/doc/cephadm/client-setup.rst index f98ba798b..0f38773b1 100644 --- a/doc/cephadm/client-setup.rst +++ b/doc/cephadm/client-setup.rst @@ -1,36 +1,36 @@ ======================= Basic Ceph Client Setup ======================= -Client machines require some basic configuration to interact with -Ceph clusters. This section describes how to configure a client machine -so that it can interact with a Ceph cluster. +Client hosts require basic configuration to interact with +Ceph clusters. This section describes how to perform this configuration. .. note:: - Most client machines need to install only the `ceph-common` package - and its dependencies. Such a setup supplies the basic `ceph` and - `rados` commands, as well as other commands including `mount.ceph` - and `rbd`. + Most client hosts need to install only the ``ceph-common`` package + and its dependencies. Such an installation supplies the basic ``ceph`` and + ``rados`` commands, as well as other commands including ``mount.ceph`` + and ``rbd``. Config File Setup ================= -Client machines usually require smaller configuration files (here -sometimes called "config files") than do full-fledged cluster members. +Client hosts usually require smaller configuration files (here +sometimes called "config files") than do back-end cluster hosts. To generate a minimal config file, log into a host that has been -configured as a client or that is running a cluster daemon, and then run the following command: +configured as a client or that is running a cluster daemon, then +run the following command: .. prompt:: bash # ceph config generate-minimal-conf This command generates a minimal config file that tells the client how -to reach the Ceph monitors. The contents of this file should usually -be installed in ``/etc/ceph/ceph.conf``. +to reach the Ceph Monitors. This file should usually +be copied to ``/etc/ceph/ceph.conf`` on each client host. Keyring Setup ============= Most Ceph clusters run with authentication enabled. This means that -the client needs keys in order to communicate with the machines in the -cluster. To generate a keyring file with credentials for `client.fs`, +the client needs keys in order to communicate with Ceph daemons. +To generate a keyring file with credentials for ``client.fs``, log into an running cluster member and run the following command: .. prompt:: bash $ @@ -40,6 +40,10 @@ log into an running cluster member and run the following command: The resulting output is directed into a keyring file, typically ``/etc/ceph/ceph.keyring``. -To gain a broader understanding of client keyring distribution and administration, you should read :ref:`client_keyrings_and_configs`. +To gain a broader understanding of client keyring distribution and administration, +you should read :ref:`client_keyrings_and_configs`. -To see an example that explains how to distribute ``ceph.conf`` configuration files to hosts that are tagged with the ``bare_config`` label, you should read the section called "Distributing ceph.conf to hosts tagged with bare_config" in the section called :ref:`etc_ceph_conf_distribution`. +To see an example that explains how to distribute ``ceph.conf`` configuration +files to hosts that are tagged with the ``bare_config`` label, you should read +the subsection named "Distributing ceph.conf to hosts tagged with bare_config" +under the heading :ref:`etc_ceph_conf_distribution`. |