1 files changed, 63 insertions, 0 deletions
diff --git a/doc/examples/kea6/simple.json b/doc/examples/kea6/simple.json
new file mode 100644
index 0000000..3b6d3d5
--- /dev/null
+++ b/doc/examples/kea6/simple.json
@@ -0,0 +1,63 @@
+// This is an example configuration file for DHCPv6 server in Kea.
+// It's a basic scenario with one IPv6 subnet configured. It is
+// assumed that one subnet (2001:db8:1::/64 is available directly
+// over eth0 interface.
+
+{ "Dhcp6":
+
+{
+// Kea is told to listen on eth0 interface only.
+  "interfaces-config": {
+    "interfaces": [ "eth0" ]
+  },
+
+// We need to specify the database used to store leases. As of
+// June 2022, three database backends are supported: MySQL,
+// PostgreSQL and the in-memory database, Memfile.
+// We'll use memfile because it doesn't require any prior set up.
+  "lease-database": {
+      "type": "memfile",
+      "lfc-interval": 3600
+  },
+
+// Addresses will be assigned with preferred and valid lifetimes
+// being 3000 and 4000, respectively. Client is told to start
+// renewing after 1000 seconds. If the server does not respond
+// after 2000 seconds since the lease was granted, client is supposed
+// to start REBIND procedure (emergency renewal that allows switching
+// to a different server).
+  "preferred-lifetime": 3000,
+  "valid-lifetime": 4000,
+  "renew-timer": 1000,
+  "rebind-timer": 2000,
+
+// The following list defines subnets. Each subnet consists of at
+// least subnet and pool entries.
+  "subnet6": [
+    {
+      "id": 1,
+      "pools": [ { "pool": "2001:db8:1::/80" } ],
+      "subnet": "2001:db8:1::/64",
+      "interface": "eth0"
+    }
+  ],
+
+// The following configures logging. It assumes that messages with at
+// least informational level (info, warn, error and fatal) should be
+// logged to stdout. Alternatively, you can specify stderr here, a filename
+// or 'syslog', which will store output messages via syslog.
+    "loggers": [
+        {
+            "name": "kea-dhcp6",
+            "output-options": [
+                {
+                    "output": "stdout"
+                }
+            ],
+            "debuglevel": 0,
+            "severity": "INFO"
+        }
+    ]
+}
+
+}