Adding upstream version 6.6.15.upstream/6.6.15

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 74 insertions, 0 deletions

diff --git a/Documentation/hwmon/ina3221.rst b/Documentation/hwmon/ina3221.rst
new file mode 100644
index 0000000000..8c12c54d2c
--- /dev/null
+++ b/Documentation/hwmon/ina3221.rst
@@ -0,0 +1,74 @@
+Kernel driver ina3221
+=====================
+
+Supported chips:
+
+  * Texas Instruments INA3221
+
+    Prefix: 'ina3221'
+
+    Addresses: I2C 0x40 - 0x43
+
+    Datasheet: Publicly available at the Texas Instruments website
+
+	       https://www.ti.com/
+
+Author: Andrew F. Davis <afd@ti.com>
+
+Description
+-----------
+
+The Texas Instruments INA3221 monitors voltage, current, and power on the high
+side of up to three D.C. power supplies. The INA3221 monitors both shunt drop
+and supply voltage, with programmable conversion times and averaging, current
+and power are calculated host-side from these.
+
+Sysfs entries
+-------------
+
+======================= =======================================================
+in[123]_label           Voltage channel labels
+in[123]_enable          Voltage channel enable controls
+in[123]_input           Bus voltage(mV) channels
+curr[123]_input         Current(mA) measurement channels
+shunt[123]_resistor     Shunt resistance(uOhm) channels
+curr[123]_crit          Critical alert current(mA) setting, activates the
+			corresponding alarm when the respective current
+			is above this value
+curr[123]_crit_alarm    Critical alert current limit exceeded
+curr[123]_max           Warning alert current(mA) setting, activates the
+			corresponding alarm when the respective current
+			average is above this value.
+curr[123]_max_alarm     Warning alert current limit exceeded
+in[456]_input           Shunt voltage(uV) for channels 1, 2, and 3 respectively
+in7_input               Sum of shunt voltage(uV) channels
+in7_label               Channel label for sum of shunt voltage
+curr4_input             Sum of current(mA) measurement channels,
+                        (only available when all channels use the same resistor
+                        value for their shunt resistors)
+curr4_crit              Critical alert current(mA) setting for sum of current
+                        measurements, activates the corresponding alarm
+                        when the respective current is above this value
+                        (only effective when all channels use the same resistor
+                        value for their shunt resistors)
+curr4_crit_alarm        Critical alert current limit exceeded for sum of
+                        current measurements.
+samples                 Number of samples using in the averaging mode.
+
+                        Supports the list of number of samples:
+
+                          1, 4, 16, 64, 128, 256, 512, 1024
+
+update_interval         Data conversion time in millisecond, following:
+
+                          update_interval = C x S x (BC + SC)
+
+                          * C:	number of enabled channels
+                          * S:	number of samples
+                          * BC:	bus-voltage conversion time in millisecond
+                          * SC:	shunt-voltage conversion time in millisecond
+
+                        Affects both Bus- and Shunt-voltage conversion time.
+                        Note that setting update_interval to 0ms sets both BC
+                        and SC to 140 us (minimum conversion time).
+======================= =======================================================