Adding upstream version 6.6.15.upstream/6.6.15

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 292 insertions, 0 deletions

diff --git a/drivers/net/phy/bcm-cygnus.c b/drivers/net/phy/bcm-cygnus.c
new file mode 100644
index 0000000000..da8f7cb41b
--- /dev/null
+++ b/drivers/net/phy/bcm-cygnus.c
@@ -0,0 +1,292 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (C) 2015 Broadcom Corporation
+ */
+
+/* Broadcom Cygnus SoC internal transceivers support. */
+#include "bcm-phy-lib.h"
+#include <linux/brcmphy.h>
+#include <linux/module.h>
+#include <linux/netdevice.h>
+#include <linux/phy.h>
+
+struct bcm_omega_phy_priv {
+	u64	*stats;
+};
+
+/* Broadcom Cygnus Phy specific registers */
+#define MII_BCM_CYGNUS_AFE_VDAC_ICTRL_0  0x91E5 /* VDAL Control register */
+
+static int bcm_cygnus_afe_config(struct phy_device *phydev)
+{
+	int rc;
+
+	/* ensure smdspclk is enabled */
+	rc = phy_write(phydev, MII_BCM54XX_AUX_CTL, 0x0c30);
+	if (rc < 0)
+		return rc;
+
+	/* AFE_VDAC_ICTRL_0 bit 7:4 Iq=1100 for 1g 10bt, normal modes */
+	rc = bcm_phy_write_misc(phydev, 0x39, 0x01, 0xA7C8);
+	if (rc < 0)
+		return rc;
+
+	/* AFE_HPF_TRIM_OTHERS bit11=1, short cascode enable for all modes*/
+	rc = bcm_phy_write_misc(phydev, 0x3A, 0x00, 0x0803);
+	if (rc < 0)
+		return rc;
+
+	/* AFE_TX_CONFIG_1 bit 7:4 Iq=1100 for test modes */
+	rc = bcm_phy_write_misc(phydev, 0x3A, 0x01, 0xA740);
+	if (rc < 0)
+		return rc;
+
+	/* AFE TEMPSEN_OTHERS rcal_HT, rcal_LT 10000 */
+	rc = bcm_phy_write_misc(phydev, 0x3A, 0x03, 0x8400);
+	if (rc < 0)
+		return rc;
+
+	/* AFE_FUTURE_RSV bit 2:0 rccal <2:0>=100 */
+	rc = bcm_phy_write_misc(phydev, 0x3B, 0x00, 0x0004);
+	if (rc < 0)
+		return rc;
+
+	/* Adjust bias current trim to overcome digital offSet */
+	rc = phy_write(phydev, MII_BRCM_CORE_BASE1E, 0x02);
+	if (rc < 0)
+		return rc;
+
+	/* make rcal=100, since rdb default is 000 */
+	rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB1, 0x10);
+	if (rc < 0)
+		return rc;
+
+	/* CORE_EXPB0, Reset R_CAL/RC_CAL Engine */
+	rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB0, 0x10);
+	if (rc < 0)
+		return rc;
+
+	/* CORE_EXPB0, Disable Reset R_CAL/RC_CAL Engine */
+	rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB0, 0x00);
+
+	return 0;
+}
+
+static int bcm_cygnus_config_init(struct phy_device *phydev)
+{
+	int reg, rc;
+
+	reg = phy_read(phydev, MII_BCM54XX_ECR);
+	if (reg < 0)
+		return reg;
+
+	/* Mask interrupts globally. */
+	reg |= MII_BCM54XX_ECR_IM;
+	rc = phy_write(phydev, MII_BCM54XX_ECR, reg);
+	if (rc)
+		return rc;
+
+	/* Unmask events of interest */
+	reg = ~(MII_BCM54XX_INT_DUPLEX |
+		MII_BCM54XX_INT_SPEED |
+		MII_BCM54XX_INT_LINK);
+	rc = phy_write(phydev, MII_BCM54XX_IMR, reg);
+	if (rc)
+		return rc;
+
+	/* Apply AFE settings for the PHY */
+	rc = bcm_cygnus_afe_config(phydev);
+	if (rc)
+		return rc;
+
+	/* Advertise EEE */
+	rc = bcm_phy_set_eee(phydev, true);
+	if (rc)
+		return rc;
+
+	/* Enable APD */
+	return bcm_phy_enable_apd(phydev, false);
+}
+
+static int bcm_cygnus_resume(struct phy_device *phydev)
+{
+	int rc;
+
+	genphy_resume(phydev);
+
+	/* Re-initialize the PHY to apply AFE work-arounds and
+	 * configurations when coming out of suspend.
+	 */
+	rc = bcm_cygnus_config_init(phydev);
+	if (rc)
+		return rc;
+
+	/* restart auto negotiation with the new settings */
+	return genphy_config_aneg(phydev);
+}
+
+static int bcm_omega_config_init(struct phy_device *phydev)
+{
+	u8 count, rev;
+	int ret = 0;
+
+	rev = phydev->phy_id & ~phydev->drv->phy_id_mask;
+
+	pr_info_once("%s: %s PHY revision: 0x%02x\n",
+		     phydev_name(phydev), phydev->drv->name, rev);
+
+	/* Dummy read to a register to workaround an issue upon reset where the
+	 * internal inverter may not allow the first MDIO transaction to pass
+	 * the MDIO management controller and make us return 0xffff for such
+	 * reads.
+	 */
+	phy_read(phydev, MII_BMSR);
+
+	switch (rev) {
+	case 0x00:
+		ret = bcm_phy_28nm_a0b0_afe_config_init(phydev);
+		break;
+	default:
+		break;
+	}
+
+	if (ret)
+		return ret;
+
+	ret = bcm_phy_downshift_get(phydev, &count);
+	if (ret)
+		return ret;
+
+	/* Only enable EEE if Wirespeed/downshift is disabled */
+	ret = bcm_phy_set_eee(phydev, count == DOWNSHIFT_DEV_DISABLE);
+	if (ret)
+		return ret;
+
+	return bcm_phy_enable_apd(phydev, true);
+}
+
+static int bcm_omega_resume(struct phy_device *phydev)
+{
+	int ret;
+
+	/* Re-apply workarounds coming out suspend/resume */
+	ret = bcm_omega_config_init(phydev);
+	if (ret)
+		return ret;
+
+	/* 28nm Gigabit PHYs come out of reset without any half-duplex
+	 * or "hub" compliant advertised mode, fix that. This does not
+	 * cause any problems with the PHY library since genphy_config_aneg()
+	 * gracefully handles auto-negotiated and forced modes.
+	 */
+	return genphy_config_aneg(phydev);
+}
+
+static int bcm_omega_get_tunable(struct phy_device *phydev,
+				 struct ethtool_tunable *tuna, void *data)
+{
+	switch (tuna->id) {
+	case ETHTOOL_PHY_DOWNSHIFT:
+		return bcm_phy_downshift_get(phydev, (u8 *)data);
+	default:
+		return -EOPNOTSUPP;
+	}
+}
+
+static int bcm_omega_set_tunable(struct phy_device *phydev,
+				 struct ethtool_tunable *tuna,
+				 const void *data)
+{
+	u8 count = *(u8 *)data;
+	int ret;
+
+	switch (tuna->id) {
+	case ETHTOOL_PHY_DOWNSHIFT:
+		ret = bcm_phy_downshift_set(phydev, count);
+		break;
+	default:
+		return -EOPNOTSUPP;
+	}
+
+	if (ret)
+		return ret;
+
+	/* Disable EEE advertisement since this prevents the PHY
+	 * from successfully linking up, trigger auto-negotiation restart
+	 * to let the MAC decide what to do.
+	 */
+	ret = bcm_phy_set_eee(phydev, count == DOWNSHIFT_DEV_DISABLE);
+	if (ret)
+		return ret;
+
+	return genphy_restart_aneg(phydev);
+}
+
+static void bcm_omega_get_phy_stats(struct phy_device *phydev,
+				    struct ethtool_stats *stats, u64 *data)
+{
+	struct bcm_omega_phy_priv *priv = phydev->priv;
+
+	bcm_phy_get_stats(phydev, priv->stats, stats, data);
+}
+
+static int bcm_omega_probe(struct phy_device *phydev)
+{
+	struct bcm_omega_phy_priv *priv;
+
+	priv = devm_kzalloc(&phydev->mdio.dev, sizeof(*priv), GFP_KERNEL);
+	if (!priv)
+		return -ENOMEM;
+
+	phydev->priv = priv;
+
+	priv->stats = devm_kcalloc(&phydev->mdio.dev,
+				   bcm_phy_get_sset_count(phydev), sizeof(u64),
+				   GFP_KERNEL);
+	if (!priv->stats)
+		return -ENOMEM;
+
+	return 0;
+}
+
+static struct phy_driver bcm_cygnus_phy_driver[] = {
+{
+	.phy_id        = PHY_ID_BCM_CYGNUS,
+	.phy_id_mask   = 0xfffffff0,
+	.name          = "Broadcom Cygnus PHY",
+	/* PHY_GBIT_FEATURES */
+	.config_init   = bcm_cygnus_config_init,
+	.config_intr   = bcm_phy_config_intr,
+	.handle_interrupt = bcm_phy_handle_interrupt,
+	.suspend       = genphy_suspend,
+	.resume        = bcm_cygnus_resume,
+}, {
+	.phy_id		= PHY_ID_BCM_OMEGA,
+	.phy_id_mask	= 0xfffffff0,
+	.name		= "Broadcom Omega Combo GPHY",
+	/* PHY_GBIT_FEATURES */
+	.flags		= PHY_IS_INTERNAL,
+	.config_init	= bcm_omega_config_init,
+	.suspend	= genphy_suspend,
+	.resume		= bcm_omega_resume,
+	.get_tunable	= bcm_omega_get_tunable,
+	.set_tunable	= bcm_omega_set_tunable,
+	.get_sset_count	= bcm_phy_get_sset_count,
+	.get_strings	= bcm_phy_get_strings,
+	.get_stats	= bcm_omega_get_phy_stats,
+	.probe		= bcm_omega_probe,
+}
+};
+
+static struct mdio_device_id __maybe_unused bcm_cygnus_phy_tbl[] = {
+	{ PHY_ID_BCM_CYGNUS, 0xfffffff0, },
+	{ PHY_ID_BCM_OMEGA, 0xfffffff0, },
+	{ }
+};
+MODULE_DEVICE_TABLE(mdio, bcm_cygnus_phy_tbl);
+
+module_phy_driver(bcm_cygnus_phy_driver);
+
+MODULE_DESCRIPTION("Broadcom Cygnus internal PHY driver");
+MODULE_LICENSE("GPL v2");
+MODULE_AUTHOR("Broadcom Corporation");