1 files changed, 73 insertions, 0 deletions
diff --git a/Documentation/ABI/testing/sysfs-driver-zynqmp-fpga b/Documentation/ABI/testing/sysfs-driver-zynqmp-fpga
new file mode 100644
index 0000000000..8f93d27b6d
--- /dev/null
+++ b/Documentation/ABI/testing/sysfs-driver-zynqmp-fpga
@@ -0,0 +1,73 @@
+What:		/sys/bus/platform/drivers/zynqmp_fpga_manager/firmware:zynqmp-firmware:pcap/status
+Date:		February 2023
+KernelVersion:	6.4
+Contact:	Nava kishore Manne <nava.kishore.manne@amd.com>
+Description:	(RO) Read fpga status.
+		Read returns a hexadecimal value that tells the current status
+		of the FPGA device. Each bit position in the status value is
+		described Below(see ug570 chapter 9).
+		https://docs.xilinx.com/v/u/en-US/ug570-ultrascale-configuration
+
+		======================  ==============================================
+		BIT(0)			0: No CRC error
+					1: CRC error
+
+		BIT(1)			0: Decryptor security not set
+					1: Decryptor security set
+
+		BIT(2)			0: MMCMs/PLLs are not locked
+					1: MMCMs/PLLs are locked
+
+		BIT(3)			0: DCI not matched
+					1: DCI matched
+
+		BIT(4)			0: Start-up sequence has not finished
+					1: Start-up sequence has finished
+
+		BIT(5)			0: All I/Os are placed in High-Z state
+					1: All I/Os behave as configured
+
+		BIT(6)			0: Flip-flops and block RAM are write disabled
+					1: Flip-flops and block RAM are write enabled
+
+		BIT(7)			0: GHIGH_B_STATUS asserted
+					1: GHIGH_B_STATUS deasserted
+
+		BIT(8) to BIT(10)	Status of the mode pins
+
+		BIT(11)			0: Initialization has not finished
+					1: Initialization finished
+
+		BIT(12)			Value on INIT_B_PIN pin
+
+		BIT(13)			0: Signal not released
+					1: Signal released
+
+		BIT(14)			Value on DONE_PIN pin.
+
+		BIT(15)			0: No IDCODE_ERROR
+					1: IDCODE_ERROR
+
+		BIT(16)			0: No SECURITY_ERROR
+					1: SECURITY_ERROR
+
+		BIT(17)			System Monitor over-temperature if set
+
+		BIT(18) to BIT(20)	Start-up state machine (0 to 7)
+					Phase 0 = 000
+					Phase 1 = 001
+					Phase 2 = 011
+					Phase 3 = 010
+					Phase 4 = 110
+					Phase 5 = 111
+					Phase 6 = 101
+					Phase 7 = 100
+
+		BIT(25) to BIT(26)	Indicates the detected bus width
+					00 = x1
+					01 = x8
+					10 = x16
+					11 = x32
+		======================  ==============================================
+
+		The other bits are reserved.