summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/regulator/tps65132-regulator.txt')
-rw-r--r--Documentation/devicetree/bindings/regulator/tps65132-regulator.txt46
1 files changed, 0 insertions, 46 deletions
diff --git a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
deleted file mode 100644
index 3a3505520c..0000000000
--- a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
+++ /dev/null
@@ -1,46 +0,0 @@
-TPS65132 regulators
-
-Required properties:
-- compatible: "ti,tps65132"
-- reg: I2C slave address
-
-Optional Subnode:
-Device supports two regulators OUTP and OUTN. A sub node within the
- device node describe the properties of these regulators. The sub-node
- names must be as follows:
- -For regulator outp, the sub node name should be "outp".
- -For regulator outn, the sub node name should be "outn".
-
--enable-gpios:(active high, output) Regulators are controlled by the input pins.
- If it is connected to GPIO through host system then provide the
- gpio number as per gpio.txt.
--active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
- on the enable pin, to keep the regulator enabled for some time after
- the enable signal goes low. This GPIO is used to actively discharge
- the delay mechanism. Requires specification of ti,active-discharge-time-us
--ti,active-discharge-time-us: how long the active discharge gpio should be
- asserted for during active discharge, in microseconds.
-
-Each regulator is defined using the standard binding for regulators.
-
-Example:
-
- tps65132@3e {
- compatible = "ti,tps65132";
- reg = <0x3e>;
-
- outp {
- regulator-name = "outp";
- regulator-boot-on;
- regulator-always-on;
- enable-gpios = <&gpio 23 0>;
- };
-
- outn {
- regulator-name = "outn";
- regulator-boot-on;
- regulator-always-on;
- regulator-active-discharge = <0>;
- enable-gpios = <&gpio 40 0>;
- };
- };