diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/hwmon/ina3221.rst | 74 |
1 files changed, 74 insertions, 0 deletions
diff --git a/Documentation/hwmon/ina3221.rst b/Documentation/hwmon/ina3221.rst new file mode 100644 index 0000000000..8c12c54d2c --- /dev/null +++ b/Documentation/hwmon/ina3221.rst @@ -0,0 +1,74 @@ +Kernel driver ina3221 +===================== + +Supported chips: + + * Texas Instruments INA3221 + + Prefix: 'ina3221' + + Addresses: I2C 0x40 - 0x43 + + Datasheet: Publicly available at the Texas Instruments website + + https://www.ti.com/ + +Author: Andrew F. Davis <afd@ti.com> + +Description +----------- + +The Texas Instruments INA3221 monitors voltage, current, and power on the high +side of up to three D.C. power supplies. The INA3221 monitors both shunt drop +and supply voltage, with programmable conversion times and averaging, current +and power are calculated host-side from these. + +Sysfs entries +------------- + +======================= ======================================================= +in[123]_label Voltage channel labels +in[123]_enable Voltage channel enable controls +in[123]_input Bus voltage(mV) channels +curr[123]_input Current(mA) measurement channels +shunt[123]_resistor Shunt resistance(uOhm) channels +curr[123]_crit Critical alert current(mA) setting, activates the + corresponding alarm when the respective current + is above this value +curr[123]_crit_alarm Critical alert current limit exceeded +curr[123]_max Warning alert current(mA) setting, activates the + corresponding alarm when the respective current + average is above this value. +curr[123]_max_alarm Warning alert current limit exceeded +in[456]_input Shunt voltage(uV) for channels 1, 2, and 3 respectively +in7_input Sum of shunt voltage(uV) channels +in7_label Channel label for sum of shunt voltage +curr4_input Sum of current(mA) measurement channels, + (only available when all channels use the same resistor + value for their shunt resistors) +curr4_crit Critical alert current(mA) setting for sum of current + measurements, activates the corresponding alarm + when the respective current is above this value + (only effective when all channels use the same resistor + value for their shunt resistors) +curr4_crit_alarm Critical alert current limit exceeded for sum of + current measurements. +samples Number of samples using in the averaging mode. + + Supports the list of number of samples: + + 1, 4, 16, 64, 128, 256, 512, 1024 + +update_interval Data conversion time in millisecond, following: + + update_interval = C x S x (BC + SC) + + * C: number of enabled channels + * S: number of samples + * BC: bus-voltage conversion time in millisecond + * SC: shunt-voltage conversion time in millisecond + + Affects both Bus- and Shunt-voltage conversion time. + Note that setting update_interval to 0ms sets both BC + and SC to 140 us (minimum conversion time). +======================= ======================================================= |