diff options
Diffstat (limited to 'arch/x86/boot/compressed/efi_mixed.S')
-rw-r--r-- | arch/x86/boot/compressed/efi_mixed.S | 322 |
1 files changed, 322 insertions, 0 deletions
diff --git a/arch/x86/boot/compressed/efi_mixed.S b/arch/x86/boot/compressed/efi_mixed.S new file mode 100644 index 0000000000..f4e22ef774 --- /dev/null +++ b/arch/x86/boot/compressed/efi_mixed.S @@ -0,0 +1,322 @@ +/* SPDX-License-Identifier: GPL-2.0 */ +/* + * Copyright (C) 2014, 2015 Intel Corporation; author Matt Fleming + * + * Early support for invoking 32-bit EFI services from a 64-bit kernel. + * + * Because this thunking occurs before ExitBootServices() we have to + * restore the firmware's 32-bit GDT and IDT before we make EFI service + * calls. + * + * On the plus side, we don't have to worry about mangling 64-bit + * addresses into 32-bits because we're executing with an identity + * mapped pagetable and haven't transitioned to 64-bit virtual addresses + * yet. + */ + +#include <linux/linkage.h> +#include <asm/msr.h> +#include <asm/page_types.h> +#include <asm/processor-flags.h> +#include <asm/segment.h> + + .code64 + .text +/* + * When booting in 64-bit mode on 32-bit EFI firmware, startup_64_mixed_mode() + * is the first thing that runs after switching to long mode. Depending on + * whether the EFI handover protocol or the compat entry point was used to + * enter the kernel, it will either branch to the common 64-bit EFI stub + * entrypoint efi_stub_entry() directly, or via the 64-bit EFI PE/COFF + * entrypoint efi_pe_entry(). In the former case, the bootloader must provide a + * struct bootparams pointer as the third argument, so the presence of such a + * pointer is used to disambiguate. + * + * +--------------+ + * +------------------+ +------------+ +------>| efi_pe_entry | + * | efi32_pe_entry |---->| | | +-----------+--+ + * +------------------+ | | +------+----------------+ | + * | startup_32 |---->| startup_64_mixed_mode | | + * +------------------+ | | +------+----------------+ | + * | efi32_stub_entry |---->| | | | + * +------------------+ +------------+ | | + * V | + * +------------+ +----------------+ | + * | startup_64 |<----| efi_stub_entry |<--------+ + * +------------+ +----------------+ + */ +SYM_FUNC_START(startup_64_mixed_mode) + lea efi32_boot_args(%rip), %rdx + mov 0(%rdx), %edi + mov 4(%rdx), %esi +#ifdef CONFIG_EFI_HANDOVER_PROTOCOL + mov 8(%rdx), %edx // saved bootparams pointer + test %edx, %edx + jnz efi_stub_entry +#endif + /* + * efi_pe_entry uses MS calling convention, which requires 32 bytes of + * shadow space on the stack even if all arguments are passed in + * registers. We also need an additional 8 bytes for the space that + * would be occupied by the return address, and this also results in + * the correct stack alignment for entry. + */ + sub $40, %rsp + mov %rdi, %rcx // MS calling convention + mov %rsi, %rdx + jmp efi_pe_entry +SYM_FUNC_END(startup_64_mixed_mode) + +SYM_FUNC_START(__efi64_thunk) + push %rbp + push %rbx + + movl %ds, %eax + push %rax + movl %es, %eax + push %rax + movl %ss, %eax + push %rax + + /* Copy args passed on stack */ + movq 0x30(%rsp), %rbp + movq 0x38(%rsp), %rbx + movq 0x40(%rsp), %rax + + /* + * Convert x86-64 ABI params to i386 ABI + */ + subq $64, %rsp + movl %esi, 0x0(%rsp) + movl %edx, 0x4(%rsp) + movl %ecx, 0x8(%rsp) + movl %r8d, 0xc(%rsp) + movl %r9d, 0x10(%rsp) + movl %ebp, 0x14(%rsp) + movl %ebx, 0x18(%rsp) + movl %eax, 0x1c(%rsp) + + leaq 0x20(%rsp), %rbx + sgdt (%rbx) + sidt 16(%rbx) + + leaq 1f(%rip), %rbp + + /* + * Switch to IDT and GDT with 32-bit segments. These are the firmware + * GDT and IDT that were installed when the kernel started executing. + * The pointers were saved by the efi32_entry() routine below. + * + * Pass the saved DS selector to the 32-bit code, and use far return to + * restore the saved CS selector. + */ + lidt efi32_boot_idt(%rip) + lgdt efi32_boot_gdt(%rip) + + movzwl efi32_boot_ds(%rip), %edx + movzwq efi32_boot_cs(%rip), %rax + pushq %rax + leaq efi_enter32(%rip), %rax + pushq %rax + lretq + +1: addq $64, %rsp + movq %rdi, %rax + + pop %rbx + movl %ebx, %ss + pop %rbx + movl %ebx, %es + pop %rbx + movl %ebx, %ds + /* Clear out 32-bit selector from FS and GS */ + xorl %ebx, %ebx + movl %ebx, %fs + movl %ebx, %gs + + pop %rbx + pop %rbp + RET +SYM_FUNC_END(__efi64_thunk) + + .code32 +#ifdef CONFIG_EFI_HANDOVER_PROTOCOL +SYM_FUNC_START(efi32_stub_entry) + call 1f +1: popl %ecx + + /* Clear BSS */ + xorl %eax, %eax + leal (_bss - 1b)(%ecx), %edi + leal (_ebss - 1b)(%ecx), %ecx + subl %edi, %ecx + shrl $2, %ecx + cld + rep stosl + + add $0x4, %esp /* Discard return address */ + popl %ecx + popl %edx + popl %esi + jmp efi32_entry +SYM_FUNC_END(efi32_stub_entry) +#endif + +/* + * EFI service pointer must be in %edi. + * + * The stack should represent the 32-bit calling convention. + */ +SYM_FUNC_START_LOCAL(efi_enter32) + /* Load firmware selector into data and stack segment registers */ + movl %edx, %ds + movl %edx, %es + movl %edx, %fs + movl %edx, %gs + movl %edx, %ss + + /* Reload pgtables */ + movl %cr3, %eax + movl %eax, %cr3 + + /* Disable paging */ + movl %cr0, %eax + btrl $X86_CR0_PG_BIT, %eax + movl %eax, %cr0 + + /* Disable long mode via EFER */ + movl $MSR_EFER, %ecx + rdmsr + btrl $_EFER_LME, %eax + wrmsr + + call *%edi + + /* We must preserve return value */ + movl %eax, %edi + + /* + * Some firmware will return with interrupts enabled. Be sure to + * disable them before we switch GDTs and IDTs. + */ + cli + + lidtl 16(%ebx) + lgdtl (%ebx) + + movl %cr4, %eax + btsl $(X86_CR4_PAE_BIT), %eax + movl %eax, %cr4 + + movl %cr3, %eax + movl %eax, %cr3 + + movl $MSR_EFER, %ecx + rdmsr + btsl $_EFER_LME, %eax + wrmsr + + xorl %eax, %eax + lldt %ax + + pushl $__KERNEL_CS + pushl %ebp + + /* Enable paging */ + movl %cr0, %eax + btsl $X86_CR0_PG_BIT, %eax + movl %eax, %cr0 + lret +SYM_FUNC_END(efi_enter32) + +/* + * This is the common EFI stub entry point for mixed mode. + * + * Arguments: %ecx image handle + * %edx EFI system table pointer + * %esi struct bootparams pointer (or NULL when not using + * the EFI handover protocol) + * + * Since this is the point of no return for ordinary execution, no registers + * are considered live except for the function parameters. [Note that the EFI + * stub may still exit and return to the firmware using the Exit() EFI boot + * service.] + */ +SYM_FUNC_START_LOCAL(efi32_entry) + call 1f +1: pop %ebx + + /* Save firmware GDTR and code/data selectors */ + sgdtl (efi32_boot_gdt - 1b)(%ebx) + movw %cs, (efi32_boot_cs - 1b)(%ebx) + movw %ds, (efi32_boot_ds - 1b)(%ebx) + + /* Store firmware IDT descriptor */ + sidtl (efi32_boot_idt - 1b)(%ebx) + + /* Store boot arguments */ + leal (efi32_boot_args - 1b)(%ebx), %ebx + movl %ecx, 0(%ebx) + movl %edx, 4(%ebx) + movl %esi, 8(%ebx) + movb $0x0, 12(%ebx) // efi_is64 + + /* Disable paging */ + movl %cr0, %eax + btrl $X86_CR0_PG_BIT, %eax + movl %eax, %cr0 + + jmp startup_32 +SYM_FUNC_END(efi32_entry) + +/* + * efi_status_t efi32_pe_entry(efi_handle_t image_handle, + * efi_system_table_32_t *sys_table) + */ +SYM_FUNC_START(efi32_pe_entry) + pushl %ebp + movl %esp, %ebp + pushl %ebx // save callee-save registers + pushl %edi + + call verify_cpu // check for long mode support + testl %eax, %eax + movl $0x80000003, %eax // EFI_UNSUPPORTED + jnz 2f + + movl 8(%ebp), %ecx // image_handle + movl 12(%ebp), %edx // sys_table + xorl %esi, %esi + jmp efi32_entry // pass %ecx, %edx, %esi + // no other registers remain live + +2: popl %edi // restore callee-save registers + popl %ebx + leave + RET +SYM_FUNC_END(efi32_pe_entry) + +#ifdef CONFIG_EFI_HANDOVER_PROTOCOL + .org efi32_stub_entry + 0x200 + .code64 +SYM_FUNC_START_NOALIGN(efi64_stub_entry) + jmp efi_handover_entry +SYM_FUNC_END(efi64_stub_entry) +#endif + + .data + .balign 8 +SYM_DATA_START_LOCAL(efi32_boot_gdt) + .word 0 + .quad 0 +SYM_DATA_END(efi32_boot_gdt) + +SYM_DATA_START_LOCAL(efi32_boot_idt) + .word 0 + .quad 0 +SYM_DATA_END(efi32_boot_idt) + +SYM_DATA_LOCAL(efi32_boot_cs, .word 0) +SYM_DATA_LOCAL(efi32_boot_ds, .word 0) +SYM_DATA_LOCAL(efi32_boot_args, .long 0, 0, 0) +SYM_DATA(efi_is64, .byte 1) |