1 files changed, 155 insertions, 0 deletions
diff --git a/drivers/devfreq/Kconfig b/drivers/devfreq/Kconfig
new file mode 100644
index 000000000..3c4862a75
--- /dev/null
+++ b/drivers/devfreq/Kconfig
@@ -0,0 +1,155 @@
+# SPDX-License-Identifier: GPL-2.0-only
+menuconfig PM_DEVFREQ
+	bool "Generic Dynamic Voltage and Frequency Scaling (DVFS) support"
+	select PM_OPP
+	help
+	  A device may have a list of frequencies and voltages available.
+	  devfreq, a generic DVFS framework can be registered for a device
+	  in order to let the governor provided to devfreq choose an
+	  operating frequency based on the device driver's policy.
+
+	  Each device may have its own governor and policy. Devfreq can
+	  reevaluate the device state periodically and/or based on the
+	  notification to "nb", a notifier block, of devfreq.
+
+	  Like some CPUs with CPUfreq, a device may have multiple clocks.
+	  However, because the clock frequencies of a single device are
+	  determined by the single device's state, an instance of devfreq
+	  is attached to a single device and returns a "representative"
+	  clock frequency of the device, which is also attached
+	  to a device by 1-to-1. The device registering devfreq takes the
+	  responsibility to "interpret" the representative frequency and
+	  to set its every clock accordingly with the "target" callback
+	  given to devfreq.
+
+	  When OPP is used with the devfreq device, it is recommended to
+	  register devfreq's nb to the OPP's notifier head.  If OPP is
+	  used with the devfreq device, you may use OPP helper
+	  functions defined in devfreq.h.
+
+if PM_DEVFREQ
+
+comment "DEVFREQ Governors"
+
+config DEVFREQ_GOV_SIMPLE_ONDEMAND
+	tristate "Simple Ondemand"
+	help
+	  Chooses frequency based on the recent load on the device. Works
+	  similar as ONDEMAND governor of CPUFREQ does. A device with
+	  Simple-Ondemand should be able to provide busy/total counter
+	  values that imply the usage rate. A device may provide tuned
+	  values to the governor with data field at devfreq_add_device().
+
+config DEVFREQ_GOV_PERFORMANCE
+	tristate "Performance"
+	help
+	  Sets the frequency at the maximum available frequency.
+	  This governor always returns UINT_MAX as frequency so that
+	  the DEVFREQ framework returns the highest frequency available
+	  at any time.
+
+config DEVFREQ_GOV_POWERSAVE
+	tristate "Powersave"
+	help
+	  Sets the frequency at the minimum available frequency.
+	  This governor always returns 0 as frequency so that
+	  the DEVFREQ framework returns the lowest frequency available
+	  at any time.
+
+config DEVFREQ_GOV_USERSPACE
+	tristate "Userspace"
+	help
+	  Sets the frequency at the user specified one.
+	  This governor returns the user configured frequency if there
+	  has been an input to /sys/devices/.../userspace/set_freq.
+	  Otherwise, the governor does not change the frequency
+	  given at the initialization.
+
+config DEVFREQ_GOV_PASSIVE
+	tristate "Passive"
+	help
+	  Sets the frequency based on the frequency of its parent devfreq
+	  device. This governor does not change the frequency by itself
+	  through sysfs entries. The passive governor recommends that
+	  devfreq device uses the OPP table to get the frequency/voltage.
+
+comment "DEVFREQ Drivers"
+
+config ARM_EXYNOS_BUS_DEVFREQ
+	tristate "ARM Exynos Generic Memory Bus DEVFREQ Driver"
+	depends on ARCH_EXYNOS || COMPILE_TEST
+	select DEVFREQ_GOV_SIMPLE_ONDEMAND
+	select DEVFREQ_GOV_PASSIVE
+	select DEVFREQ_EVENT_EXYNOS_PPMU
+	select PM_DEVFREQ_EVENT
+	help
+	  This adds the common DEVFREQ driver for Exynos Memory bus. Exynos
+	  Memory bus has one more group of memory bus (e.g, MIF and INT block).
+	  Each memory bus group could contain many memoby bus block. It reads
+	  PPMU counters of memory controllers by using DEVFREQ-event device
+	  and adjusts the operating frequencies and voltages with OPP support.
+	  This does not yet operate with optimal voltages.
+
+config ARM_IMX_BUS_DEVFREQ
+	tristate "i.MX Generic Bus DEVFREQ Driver"
+	depends on ARCH_MXC || COMPILE_TEST
+	select DEVFREQ_GOV_USERSPACE
+	help
+	  This adds the generic DEVFREQ driver for i.MX interconnects. It
+	  allows adjusting NIC/NOC frequency.
+
+config ARM_IMX8M_DDRC_DEVFREQ
+	tristate "i.MX8M DDRC DEVFREQ Driver"
+	depends on (ARCH_MXC && HAVE_ARM_SMCCC) || \
+		(COMPILE_TEST && HAVE_ARM_SMCCC)
+	select DEVFREQ_GOV_USERSPACE
+	help
+	  This adds the DEVFREQ driver for the i.MX8M DDR Controller. It allows
+	  adjusting DRAM frequency.
+
+config ARM_TEGRA_DEVFREQ
+	tristate "NVIDIA Tegra30/114/124/210 DEVFREQ Driver"
+	depends on ARCH_TEGRA_3x_SOC || ARCH_TEGRA_114_SOC || \
+		ARCH_TEGRA_132_SOC || ARCH_TEGRA_124_SOC || \
+		ARCH_TEGRA_210_SOC || \
+		COMPILE_TEST
+	depends on COMMON_CLK
+	help
+	  This adds the DEVFREQ driver for the Tegra family of SoCs.
+	  It reads ACTMON counters of memory controllers and adjusts the
+	  operating frequencies and voltages with OPP support.
+
+config ARM_MEDIATEK_CCI_DEVFREQ
+	tristate "MEDIATEK CCI DEVFREQ Driver"
+	depends on ARM_MEDIATEK_CPUFREQ || COMPILE_TEST
+	select DEVFREQ_GOV_PASSIVE
+	help
+	  This adds a devfreq driver for MediaTek Cache Coherent Interconnect
+	  which is shared the same regulators with the cpu cluster. It can track
+	  buck voltages and update a proper CCI frequency. Use the notification
+	  to get the regulator status.
+
+config ARM_RK3399_DMC_DEVFREQ
+	tristate "ARM RK3399 DMC DEVFREQ Driver"
+	depends on (ARCH_ROCKCHIP && HAVE_ARM_SMCCC) || \
+		(COMPILE_TEST && HAVE_ARM_SMCCC)
+	select DEVFREQ_EVENT_ROCKCHIP_DFI
+	select DEVFREQ_GOV_SIMPLE_ONDEMAND
+	select PM_DEVFREQ_EVENT
+	help
+	  This adds the DEVFREQ driver for the RK3399 DMC(Dynamic Memory Controller).
+	  It sets the frequency for the memory controller and reads the usage counts
+	  from hardware.
+
+config ARM_SUN8I_A33_MBUS_DEVFREQ
+	tristate "sun8i/sun50i MBUS DEVFREQ Driver"
+	depends on ARCH_SUNXI || COMPILE_TEST
+	depends on COMMON_CLK
+	select DEVFREQ_GOV_SIMPLE_ONDEMAND
+	help
+	  This adds the DEVFREQ driver for the MBUS controller in some
+	  Allwinner sun8i (A33 through H3) and sun50i (A64 and H5) SoCs.
+
+source "drivers/devfreq/event/Kconfig"
+
+endif # PM_DEVFREQ