diff options
Diffstat (limited to 'drivers/pci/controller/pcie-brcmstb.c')
| -rw-r--r-- | drivers/pci/controller/pcie-brcmstb.c | 96 |
1 files changed, 86 insertions, 10 deletions
diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c index e47a77f943..c08683febd 100644 --- a/drivers/pci/controller/pcie-brcmstb.c +++ b/drivers/pci/controller/pcie-brcmstb.c @@ -48,6 +48,9 @@ #define PCIE_RC_CFG_PRIV1_LINK_CAPABILITY 0x04dc #define PCIE_RC_CFG_PRIV1_LINK_CAPABILITY_ASPM_SUPPORT_MASK 0xc00 +#define PCIE_RC_CFG_PRIV1_ROOT_CAP 0x4f8 +#define PCIE_RC_CFG_PRIV1_ROOT_CAP_L1SS_MODE_MASK 0xf8 + #define PCIE_RC_DL_MDIO_ADDR 0x1100 #define PCIE_RC_DL_MDIO_WR_DATA 0x1104 #define PCIE_RC_DL_MDIO_RD_DATA 0x1108 @@ -121,9 +124,12 @@ #define PCIE_MISC_HARD_PCIE_HARD_DEBUG 0x4204 #define PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK 0x2 +#define PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK 0x200000 #define PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK 0x08000000 #define PCIE_BMIPS_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK 0x00800000 - +#define PCIE_CLKREQ_MASK \ + (PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK | \ + PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK) #define PCIE_INTR2_CPU_BASE 0x4300 #define PCIE_MSI_INTR2_BASE 0x4500 @@ -1028,13 +1034,89 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie) return 0; } +/* + * This extends the timeout period for an access to an internal bus. This + * access timeout may occur during L1SS sleep periods, even without the + * presence of a PCIe access. + */ +static void brcm_extend_rbus_timeout(struct brcm_pcie *pcie) +{ + /* TIMEOUT register is two registers before RGR1_SW_INIT_1 */ + const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8; + u32 timeout_us = 4000000; /* 4 seconds, our setting for L1SS */ + + /* Each unit in timeout register is 1/216,000,000 seconds */ + writel(216 * timeout_us, pcie->base + REG_OFFSET); +} + +static void brcm_config_clkreq(struct brcm_pcie *pcie) +{ + static const char err_msg[] = "invalid 'brcm,clkreq-mode' DT string\n"; + const char *mode = "default"; + u32 clkreq_cntl; + int ret, tmp; + + ret = of_property_read_string(pcie->np, "brcm,clkreq-mode", &mode); + if (ret && ret != -EINVAL) { + dev_err(pcie->dev, err_msg); + mode = "safe"; + } + + /* Start out assuming safe mode (both mode bits cleared) */ + clkreq_cntl = readl(pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG); + clkreq_cntl &= ~PCIE_CLKREQ_MASK; + + if (strcmp(mode, "no-l1ss") == 0) { + /* + * "no-l1ss" -- Provides Clock Power Management, L0s, and + * L1, but cannot provide L1 substate (L1SS) power + * savings. If the downstream device connected to the RC is + * L1SS capable AND the OS enables L1SS, all PCIe traffic + * may abruptly halt, potentially hanging the system. + */ + clkreq_cntl |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK; + /* + * We want to un-advertise L1 substates because if the OS + * tries to configure the controller into using L1 substate + * power savings it may fail or hang when the RC HW is in + * "no-l1ss" mode. + */ + tmp = readl(pcie->base + PCIE_RC_CFG_PRIV1_ROOT_CAP); + u32p_replace_bits(&tmp, 2, PCIE_RC_CFG_PRIV1_ROOT_CAP_L1SS_MODE_MASK); + writel(tmp, pcie->base + PCIE_RC_CFG_PRIV1_ROOT_CAP); + + } else if (strcmp(mode, "default") == 0) { + /* + * "default" -- Provides L0s, L1, and L1SS, but not + * compliant to provide Clock Power Management; + * specifically, may not be able to meet the Tclron max + * timing of 400ns as specified in "Dynamic Clock Control", + * section 3.2.5.2.2 of the PCIe spec. This situation is + * atypical and should happen only with older devices. + */ + clkreq_cntl |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK; + brcm_extend_rbus_timeout(pcie); + + } else { + /* + * "safe" -- No power savings; refclk is driven by RC + * unconditionally. + */ + if (strcmp(mode, "safe") != 0) + dev_err(pcie->dev, err_msg); + mode = "safe"; + } + writel(clkreq_cntl, pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG); + + dev_info(pcie->dev, "clkreq-mode set to %s\n", mode); +} + static int brcm_pcie_start_link(struct brcm_pcie *pcie) { struct device *dev = pcie->dev; void __iomem *base = pcie->base; u16 nlw, cls, lnksta; bool ssc_good = false; - u32 tmp; int ret, i; /* Unassert the fundamental reset */ @@ -1059,6 +1141,8 @@ static int brcm_pcie_start_link(struct brcm_pcie *pcie) return -ENODEV; } + brcm_config_clkreq(pcie); + if (pcie->gen) brcm_pcie_set_gen(pcie, pcie->gen); @@ -1077,14 +1161,6 @@ static int brcm_pcie_start_link(struct brcm_pcie *pcie) pci_speed_string(pcie_link_speed[cls]), nlw, ssc_good ? "(SSC)" : "(!SSC)"); - /* - * Refclk from RC should be gated with CLKREQ# input when ASPM L0s,L1 - * is enabled => setting the CLKREQ_DEBUG_ENABLE field to 1. - */ - tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG); - tmp |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK; - writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG); - return 0; } |