diff options
Diffstat (limited to 'drivers/spi/spi-stm32-qspi.c')
| -rw-r--r-- | drivers/spi/spi-stm32-qspi.c | 14 |
1 files changed, 6 insertions, 8 deletions
diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c index 385832030..955c920c4 100644 --- a/drivers/spi/spi-stm32-qspi.c +++ b/drivers/spi/spi-stm32-qspi.c @@ -8,13 +8,13 @@ #include <linux/dmaengine.h> #include <linux/dma-mapping.h> #include <linux/errno.h> +#include <linux/gpio/consumer.h> #include <linux/io.h> #include <linux/iopoll.h> #include <linux/interrupt.h> #include <linux/module.h> #include <linux/mutex.h> #include <linux/of.h> -#include <linux/of_gpio.h> #include <linux/pinctrl/consumer.h> #include <linux/pm_runtime.h> #include <linux/platform_device.h> @@ -349,7 +349,7 @@ static int stm32_qspi_wait_poll_status(struct stm32_qspi *qspi) static int stm32_qspi_get_mode(u8 buswidth) { - if (buswidth == 4) + if (buswidth >= 4) return CCR_BUSWIDTH_4; return buswidth; @@ -653,9 +653,7 @@ static int stm32_qspi_setup(struct spi_device *spi) return -EINVAL; mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL); - if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) || - ((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) && - gpiod_count(qspi->dev, "cs") == -ENOENT)) { + if (mode && gpiod_count(qspi->dev, "cs") == -ENOENT) { dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n"); dev_err(qspi->dev, "configuration not supported\n"); @@ -676,10 +674,10 @@ static int stm32_qspi_setup(struct spi_device *spi) qspi->cr_reg = CR_APMS | 3 << CR_FTHRES_SHIFT | CR_SSHIFT | CR_EN; /* - * Dual flash mode is only enable in case SPI_TX_OCTAL and SPI_TX_OCTAL - * are both set in spi->mode and "cs-gpios" properties is found in DT + * Dual flash mode is only enable in case SPI_TX_OCTAL or SPI_RX_OCTAL + * is set in spi->mode and "cs-gpios" properties is found in DT */ - if (mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) { + if (mode) { qspi->cr_reg |= CR_DFM; dev_dbg(qspi->dev, "Dual flash mode enable"); } |