1 files changed, 301 insertions, 0 deletions

diff --git a/drivers/usb/host/ehci-omap.c b/drivers/usb/host/ehci-omap.c
new file mode 100644
index 0000000000..b24f371a46
--- /dev/null
+++ b/drivers/usb/host/ehci-omap.c
@@ -0,0 +1,301 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * ehci-omap.c - driver for USBHOST on OMAP3/4 processors
+ *
+ * Bus Glue for the EHCI controllers in OMAP3/4
+ * Tested on several OMAP3 boards, and OMAP4 Pandaboard
+ *
+ * Copyright (C) 2007-2013 Texas Instruments, Inc.
+ *	Author: Vikram Pandita <vikram.pandita@ti.com>
+ *	Author: Anand Gadiyar <gadiyar@ti.com>
+ *	Author: Keshava Munegowda <keshava_mgowda@ti.com>
+ *	Author: Roger Quadros <rogerq@ti.com>
+ *
+ * Copyright (C) 2009 Nokia Corporation
+ *	Contact: Felipe Balbi <felipe.balbi@nokia.com>
+ *
+ * Based on "ehci-fsl.c" and "ehci-au1xxx.c" ehci glue layers
+ */
+
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/io.h>
+#include <linux/platform_device.h>
+#include <linux/slab.h>
+#include <linux/usb/ulpi.h>
+#include <linux/pm_runtime.h>
+#include <linux/clk.h>
+#include <linux/usb.h>
+#include <linux/usb/hcd.h>
+#include <linux/of.h>
+#include <linux/dma-mapping.h>
+
+#include "ehci.h"
+
+#include <linux/platform_data/usb-omap.h>
+
+/* EHCI Register Set */
+#define EHCI_INSNREG04					(0xA0)
+#define EHCI_INSNREG04_DISABLE_UNSUSPEND		(1 << 5)
+#define	EHCI_INSNREG05_ULPI				(0xA4)
+#define	EHCI_INSNREG05_ULPI_CONTROL_SHIFT		31
+#define	EHCI_INSNREG05_ULPI_PORTSEL_SHIFT		24
+#define	EHCI_INSNREG05_ULPI_OPSEL_SHIFT			22
+#define	EHCI_INSNREG05_ULPI_REGADD_SHIFT		16
+#define	EHCI_INSNREG05_ULPI_EXTREGADD_SHIFT		8
+#define	EHCI_INSNREG05_ULPI_WRDATA_SHIFT		0
+
+#define DRIVER_DESC "OMAP-EHCI Host Controller driver"
+
+static const char hcd_name[] = "ehci-omap";
+
+/*-------------------------------------------------------------------------*/
+
+struct omap_hcd {
+	struct usb_phy *phy[OMAP3_HS_USB_PORTS]; /* one PHY for each port */
+	int nports;
+};
+
+static inline void ehci_write(void __iomem *base, u32 reg, u32 val)
+{
+	__raw_writel(val, base + reg);
+}
+
+/* configure so an HC device and id are always provided */
+/* always called with process context; sleeping is OK */
+
+static struct hc_driver __read_mostly ehci_omap_hc_driver;
+
+static const struct ehci_driver_overrides ehci_omap_overrides __initconst = {
+	.extra_priv_size = sizeof(struct omap_hcd),
+};
+
+/**
+ * ehci_hcd_omap_probe - initialize TI-based HCDs
+ * @pdev: Pointer to this platform device's information
+ *
+ * Allocates basic resources for this USB host controller, and
+ * then invokes the start() method for the HCD associated with it
+ * through the hotplug entry's driver_data.
+ */
+static int ehci_hcd_omap_probe(struct platform_device *pdev)
+{
+	struct device *dev = &pdev->dev;
+	struct usbhs_omap_platform_data *pdata = dev_get_platdata(dev);
+	struct resource	*res;
+	struct usb_hcd	*hcd;
+	void __iomem *regs;
+	int ret;
+	int irq;
+	int i;
+	struct omap_hcd	*omap;
+
+	if (usb_disabled())
+		return -ENODEV;
+
+	if (!dev->parent) {
+		dev_err(dev, "Missing parent device\n");
+		return -ENODEV;
+	}
+
+	/* For DT boot, get platform data from parent. i.e. usbhshost */
+	if (dev->of_node) {
+		pdata = dev_get_platdata(dev->parent);
+		dev->platform_data = pdata;
+	}
+
+	if (!pdata) {
+		dev_err(dev, "Missing platform data\n");
+		return -ENODEV;
+	}
+
+	irq = platform_get_irq(pdev, 0);
+	if (irq < 0)
+		return irq;
+
+	regs = devm_platform_get_and_ioremap_resource(pdev, 0, &res);
+	if (IS_ERR(regs))
+		return PTR_ERR(regs);
+
+	/*
+	 * Right now device-tree probed devices don't get dma_mask set.
+	 * Since shared usb code relies on it, set it here for now.
+	 * Once we have dma capability bindings this can go away.
+	 */
+	ret = dma_coerce_mask_and_coherent(dev, DMA_BIT_MASK(32));
+	if (ret)
+		return ret;
+
+	ret = -ENODEV;
+	hcd = usb_create_hcd(&ehci_omap_hc_driver, dev,
+			dev_name(dev));
+	if (!hcd) {
+		dev_err(dev, "Failed to create HCD\n");
+		return -ENOMEM;
+	}
+
+	hcd->rsrc_start = res->start;
+	hcd->rsrc_len = resource_size(res);
+	hcd->regs = regs;
+	hcd_to_ehci(hcd)->caps = regs;
+
+	omap = (struct omap_hcd *)hcd_to_ehci(hcd)->priv;
+	omap->nports = pdata->nports;
+
+	platform_set_drvdata(pdev, hcd);
+
+	/* get the PHY devices if needed */
+	for (i = 0 ; i < omap->nports ; i++) {
+		struct usb_phy *phy;
+
+		/* get the PHY device */
+		phy = devm_usb_get_phy_by_phandle(dev, "phys", i);
+		if (IS_ERR(phy)) {
+			ret = PTR_ERR(phy);
+			if (ret == -ENODEV) { /* no PHY */
+				phy = NULL;
+				continue;
+			}
+
+			if (ret != -EPROBE_DEFER)
+				dev_err(dev, "Can't get PHY for port %d: %d\n",
+					i, ret);
+			goto err_phy;
+		}
+
+		omap->phy[i] = phy;
+
+		if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) {
+			usb_phy_init(omap->phy[i]);
+			/* bring PHY out of suspend */
+			usb_phy_set_suspend(omap->phy[i], 0);
+		}
+	}
+
+	pm_runtime_enable(dev);
+	pm_runtime_get_sync(dev);
+
+	/*
+	 * An undocumented "feature" in the OMAP3 EHCI controller,
+	 * causes suspended ports to be taken out of suspend when
+	 * the USBCMD.Run/Stop bit is cleared (for example when
+	 * we do ehci_bus_suspend).
+	 * This breaks suspend-resume if the root-hub is allowed
+	 * to suspend. Writing 1 to this undocumented register bit
+	 * disables this feature and restores normal behavior.
+	 */
+	ehci_write(regs, EHCI_INSNREG04,
+				EHCI_INSNREG04_DISABLE_UNSUSPEND);
+
+	ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
+	if (ret) {
+		dev_err(dev, "failed to add hcd with err %d\n", ret);
+		goto err_pm_runtime;
+	}
+	device_wakeup_enable(hcd->self.controller);
+
+	/*
+	 * Bring PHYs out of reset for non PHY modes.
+	 * Even though HSIC mode is a PHY-less mode, the reset
+	 * line exists between the chips and can be modelled
+	 * as a PHY device for reset control.
+	 */
+	for (i = 0; i < omap->nports; i++) {
+		if (!omap->phy[i] ||
+		     pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY)
+			continue;
+
+		usb_phy_init(omap->phy[i]);
+		/* bring PHY out of suspend */
+		usb_phy_set_suspend(omap->phy[i], 0);
+	}
+
+	return 0;
+
+err_pm_runtime:
+	pm_runtime_put_sync(dev);
+	pm_runtime_disable(dev);
+
+err_phy:
+	for (i = 0; i < omap->nports; i++) {
+		if (omap->phy[i])
+			usb_phy_shutdown(omap->phy[i]);
+	}
+
+	usb_put_hcd(hcd);
+
+	return ret;
+}
+
+
+/**
+ * ehci_hcd_omap_remove - shutdown processing for EHCI HCDs
+ * @pdev: USB Host Controller being removed
+ *
+ * Reverses the effect of usb_ehci_hcd_omap_probe(), first invoking
+ * the HCD's stop() method.  It is always called from a thread
+ * context, normally "rmmod", "apmd", or something similar.
+ */
+static void ehci_hcd_omap_remove(struct platform_device *pdev)
+{
+	struct device *dev = &pdev->dev;
+	struct usb_hcd *hcd = dev_get_drvdata(dev);
+	struct omap_hcd *omap = (struct omap_hcd *)hcd_to_ehci(hcd)->priv;
+	int i;
+
+	usb_remove_hcd(hcd);
+
+	for (i = 0; i < omap->nports; i++) {
+		if (omap->phy[i])
+			usb_phy_shutdown(omap->phy[i]);
+	}
+
+	usb_put_hcd(hcd);
+	pm_runtime_put_sync(dev);
+	pm_runtime_disable(dev);
+}
+
+static const struct of_device_id omap_ehci_dt_ids[] = {
+	{ .compatible = "ti,ehci-omap" },
+	{ }
+};
+
+MODULE_DEVICE_TABLE(of, omap_ehci_dt_ids);
+
+static struct platform_driver ehci_hcd_omap_driver = {
+	.probe			= ehci_hcd_omap_probe,
+	.remove_new		= ehci_hcd_omap_remove,
+	.shutdown		= usb_hcd_platform_shutdown,
+	/*.suspend		= ehci_hcd_omap_suspend, */
+	/*.resume		= ehci_hcd_omap_resume, */
+	.driver = {
+		.name		= hcd_name,
+		.of_match_table = omap_ehci_dt_ids,
+	}
+};
+
+/*-------------------------------------------------------------------------*/
+
+static int __init ehci_omap_init(void)
+{
+	if (usb_disabled())
+		return -ENODEV;
+
+	ehci_init_driver(&ehci_omap_hc_driver, &ehci_omap_overrides);
+	return platform_driver_register(&ehci_hcd_omap_driver);
+}
+module_init(ehci_omap_init);
+
+static void __exit ehci_omap_cleanup(void)
+{
+	platform_driver_unregister(&ehci_hcd_omap_driver);
+}
+module_exit(ehci_omap_cleanup);
+
+MODULE_ALIAS("platform:ehci-omap");
+MODULE_AUTHOR("Texas Instruments, Inc.");
+MODULE_AUTHOR("Felipe Balbi <felipe.balbi@nokia.com>");
+MODULE_AUTHOR("Roger Quadros <rogerq@ti.com>");
+
+MODULE_DESCRIPTION(DRIVER_DESC);
+MODULE_LICENSE("GPL");