diff options
Diffstat (limited to 'net/can/Kconfig')
| -rw-r--r-- | net/can/Kconfig | 73 |
1 files changed, 73 insertions, 0 deletions
diff --git a/net/can/Kconfig b/net/can/Kconfig new file mode 100644 index 000000000..cb56be8e3 --- /dev/null +++ b/net/can/Kconfig @@ -0,0 +1,73 @@ +# SPDX-License-Identifier: GPL-2.0-only +# +# Controller Area Network (CAN) network layer core configuration +# + +menuconfig CAN + tristate "CAN bus subsystem support" + help + Controller Area Network (CAN) is a slow (up to 1Mbit/s) serial + communications protocol. Development of the CAN bus started in + 1983 at Robert Bosch GmbH, and the protocol was officially + released in 1986. The CAN bus was originally mainly for automotive, + but is now widely used in marine (NMEA2000), industrial, and medical + applications. More information on the CAN network protocol family + PF_CAN is contained in <Documentation/networking/can.rst>. + + If you want CAN support you should say Y here and also to the + specific driver for your controller(s) under the Network device + support section. + +if CAN + +config CAN_RAW + tristate "Raw CAN Protocol (raw access with CAN-ID filtering)" + default y + help + The raw CAN protocol option offers access to the CAN bus via + the BSD socket API. You probably want to use the raw socket in + most cases where no higher level protocol is being used. The raw + socket has several filter options e.g. ID masking / error frames. + To receive/send raw CAN messages, use AF_CAN with protocol CAN_RAW. + +config CAN_BCM + tristate "Broadcast Manager CAN Protocol (with content filtering)" + default y + help + The Broadcast Manager offers content filtering, timeout monitoring, + sending of RTR frames, and cyclic CAN messages without permanent user + interaction. The BCM can be 'programmed' via the BSD socket API and + informs you on demand e.g. only on content updates / timeouts. + You probably want to use the bcm socket in most cases where cyclic + CAN messages are used on the bus (e.g. in automotive environments). + To use the Broadcast Manager, use AF_CAN with protocol CAN_BCM. + +config CAN_GW + tristate "CAN Gateway/Router (with netlink configuration)" + default y + help + The CAN Gateway/Router is used to route (and modify) CAN frames. + It is based on the PF_CAN core infrastructure for msg filtering and + msg sending and can optionally modify routed CAN frames on the fly. + CAN frames can be routed between CAN network interfaces (one hop). + They can be modified with AND/OR/XOR/SET operations as configured + by the netlink configuration interface known e.g. from iptables. + +source "net/can/j1939/Kconfig" + +config CAN_ISOTP + tristate "ISO 15765-2:2016 CAN transport protocol" + help + CAN Transport Protocols offer support for segmented Point-to-Point + communication between CAN nodes via two defined CAN Identifiers. + As CAN frames can only transport a small amount of data bytes + (max. 8 bytes for 'classic' CAN and max. 64 bytes for CAN FD) this + segmentation is needed to transport longer Protocol Data Units (PDU) + as needed e.g. for vehicle diagnosis (UDS, ISO 14229) or IP-over-CAN + traffic. + This protocol driver implements data transfers according to + ISO 15765-2:2016 for 'classic' CAN and CAN FD frame types. + If you want to perform automotive vehicle diagnostic services (UDS), + say 'y'. + +endif |