From 01a69402cf9d38ff180345d55c2ee51c7e89fbc7 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sat, 18 May 2024 20:50:03 +0200 Subject: Adding upstream version 6.8.9. Signed-off-by: Daniel Baumann --- .../devicetree/bindings/hwmon/gpio-fan.txt | 41 ---------------------- 1 file changed, 41 deletions(-) delete mode 100644 Documentation/devicetree/bindings/hwmon/gpio-fan.txt (limited to 'Documentation/devicetree/bindings/hwmon/gpio-fan.txt') diff --git a/Documentation/devicetree/bindings/hwmon/gpio-fan.txt b/Documentation/devicetree/bindings/hwmon/gpio-fan.txt deleted file mode 100644 index f4cfa350f6..0000000000 --- a/Documentation/devicetree/bindings/hwmon/gpio-fan.txt +++ /dev/null @@ -1,41 +0,0 @@ -Bindings for fan connected to GPIO lines - -Required properties: -- compatible : "gpio-fan" - -Optional properties: -- gpios: Specifies the pins that map to bits in the control value, - ordered MSB-->LSB. -- gpio-fan,speed-map: A mapping of possible fan RPM speeds and the - control value that should be set to achieve them. This array - must have the RPM values in ascending order. -- alarm-gpios: This pin going active indicates something is wrong with - the fan, and a udev event will be fired. -- #cooling-cells: If used as a cooling device, must be <2> - Also see: - Documentation/devicetree/bindings/thermal/thermal-cooling-devices.yaml - min and max states are derived from the speed-map of the fan. - -Note: At least one the "gpios" or "alarm-gpios" properties must be set. - -Examples: - - gpio_fan { - compatible = "gpio-fan"; - gpios = <&gpio1 14 1 - &gpio1 13 1>; - gpio-fan,speed-map = <0 0 - 3000 1 - 6000 2>; - alarm-gpios = <&gpio1 15 1>; - }; - gpio_fan_cool: gpio_fan { - compatible = "gpio-fan"; - gpios = <&gpio2 14 1 - &gpio2 13 1>; - gpio-fan,speed-map = <0 0>, - <3000 1>, - <6000 2>; - alarm-gpios = <&gpio2 15 1>; - #cooling-cells = <2>; /* min followed by max */ - }; -- cgit v1.2.3