From dcfb98cf8931dc6bce38eff8e1c82972e1adf484 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Wed, 7 Aug 2024 15:14:23 +0200 Subject: Adding upstream version 6.9.9. Signed-off-by: Daniel Baumann --- drivers/mtd/nand/raw/nand_base.c | 66 +++++++++++++++---------- drivers/mtd/nand/raw/rockchip-nand-controller.c | 6 +-- 2 files changed, 43 insertions(+), 29 deletions(-) (limited to 'drivers/mtd/nand') diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c index d7dbbd469b..53e16d39af 100644 --- a/drivers/mtd/nand/raw/nand_base.c +++ b/drivers/mtd/nand/raw/nand_base.c @@ -1093,28 +1093,32 @@ static int nand_fill_column_cycles(struct nand_chip *chip, u8 *addrs, unsigned int offset_in_page) { struct mtd_info *mtd = nand_to_mtd(chip); + bool ident_stage = !mtd->writesize; - /* Make sure the offset is less than the actual page size. */ - if (offset_in_page > mtd->writesize + mtd->oobsize) - return -EINVAL; + /* Bypass all checks during NAND identification */ + if (likely(!ident_stage)) { + /* Make sure the offset is less than the actual page size. */ + if (offset_in_page > mtd->writesize + mtd->oobsize) + return -EINVAL; - /* - * On small page NANDs, there's a dedicated command to access the OOB - * area, and the column address is relative to the start of the OOB - * area, not the start of the page. Asjust the address accordingly. - */ - if (mtd->writesize <= 512 && offset_in_page >= mtd->writesize) - offset_in_page -= mtd->writesize; + /* + * On small page NANDs, there's a dedicated command to access the OOB + * area, and the column address is relative to the start of the OOB + * area, not the start of the page. Asjust the address accordingly. + */ + if (mtd->writesize <= 512 && offset_in_page >= mtd->writesize) + offset_in_page -= mtd->writesize; - /* - * The offset in page is expressed in bytes, if the NAND bus is 16-bit - * wide, then it must be divided by 2. - */ - if (chip->options & NAND_BUSWIDTH_16) { - if (WARN_ON(offset_in_page % 2)) - return -EINVAL; + /* + * The offset in page is expressed in bytes, if the NAND bus is 16-bit + * wide, then it must be divided by 2. + */ + if (chip->options & NAND_BUSWIDTH_16) { + if (WARN_ON(offset_in_page % 2)) + return -EINVAL; - offset_in_page /= 2; + offset_in_page /= 2; + } } addrs[0] = offset_in_page; @@ -1123,7 +1127,7 @@ static int nand_fill_column_cycles(struct nand_chip *chip, u8 *addrs, * Small page NANDs use 1 cycle for the columns, while large page NANDs * need 2 */ - if (mtd->writesize <= 512) + if (!ident_stage && mtd->writesize <= 512) return 1; addrs[1] = offset_in_page >> 8; @@ -1436,16 +1440,19 @@ int nand_change_read_column_op(struct nand_chip *chip, unsigned int len, bool force_8bit) { struct mtd_info *mtd = nand_to_mtd(chip); + bool ident_stage = !mtd->writesize; if (len && !buf) return -EINVAL; - if (offset_in_page + len > mtd->writesize + mtd->oobsize) - return -EINVAL; + if (!ident_stage) { + if (offset_in_page + len > mtd->writesize + mtd->oobsize) + return -EINVAL; - /* Small page NANDs do not support column change. */ - if (mtd->writesize <= 512) - return -ENOTSUPP; + /* Small page NANDs do not support column change. */ + if (mtd->writesize <= 512) + return -ENOTSUPP; + } if (nand_has_exec_op(chip)) { const struct nand_interface_config *conf = @@ -2173,7 +2180,7 @@ EXPORT_SYMBOL_GPL(nand_reset_op); int nand_read_data_op(struct nand_chip *chip, void *buf, unsigned int len, bool force_8bit, bool check_only) { - if (!len || !buf) + if (!len || (!check_only && !buf)) return -EINVAL; if (nand_has_exec_op(chip)) { @@ -6301,6 +6308,7 @@ static const struct nand_ops rawnand_ops = { static int nand_scan_tail(struct nand_chip *chip) { struct mtd_info *mtd = nand_to_mtd(chip); + struct nand_device *base = &chip->base; struct nand_ecc_ctrl *ecc = &chip->ecc; int ret, i; @@ -6445,9 +6453,13 @@ static int nand_scan_tail(struct nand_chip *chip) if (!ecc->write_oob_raw) ecc->write_oob_raw = ecc->write_oob; - /* propagate ecc info to mtd_info */ + /* Propagate ECC info to the generic NAND and MTD layers */ mtd->ecc_strength = ecc->strength; + if (!base->ecc.ctx.conf.strength) + base->ecc.ctx.conf.strength = ecc->strength; mtd->ecc_step_size = ecc->size; + if (!base->ecc.ctx.conf.step_size) + base->ecc.ctx.conf.step_size = ecc->size; /* * Set the number of read / write steps for one page depending on ECC @@ -6455,6 +6467,8 @@ static int nand_scan_tail(struct nand_chip *chip) */ if (!ecc->steps) ecc->steps = mtd->writesize / ecc->size; + if (!base->ecc.ctx.nsteps) + base->ecc.ctx.nsteps = ecc->steps; if (ecc->steps * ecc->size != mtd->writesize) { WARN(1, "Invalid ECC parameters\n"); ret = -EINVAL; diff --git a/drivers/mtd/nand/raw/rockchip-nand-controller.c b/drivers/mtd/nand/raw/rockchip-nand-controller.c index 7baaef69d7..5558044763 100644 --- a/drivers/mtd/nand/raw/rockchip-nand-controller.c +++ b/drivers/mtd/nand/raw/rockchip-nand-controller.c @@ -420,13 +420,13 @@ static int rk_nfc_setup_interface(struct nand_chip *chip, int target, u32 rate, tc2rw, trwpw, trw2c; u32 temp; - if (target < 0) - return 0; - timings = nand_get_sdr_timings(conf); if (IS_ERR(timings)) return -EOPNOTSUPP; + if (target < 0) + return 0; + if (IS_ERR(nfc->nfc_clk)) rate = clk_get_rate(nfc->ahb_clk); else -- cgit v1.2.3