[target.thumbv6m-none-eabi]
# FIXME: Should be Cortex-M0, but Qemu used by CI is too old
runner = "qemu-system-arm -cpu cortex-m3 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.thumbv7m-none-eabi]
runner = "qemu-system-arm -cpu cortex-m3 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.thumbv7em-none-eabi]
runner = "qemu-system-arm -cpu cortex-m4 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.thumbv7em-none-eabihf]
runner = "qemu-system-arm -cpu cortex-m4 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.thumbv8m.base-none-eabi]
# FIXME: Should be the Cortex-M23, bt Qemu does not currently support it
runner = "qemu-system-arm -cpu cortex-m33 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.thumbv8m.main-none-eabi]
runner = "qemu-system-arm -cpu cortex-m33 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.thumbv8m.main-none-eabihf]
runner = "qemu-system-arm -cpu cortex-m33 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"

[target.'cfg(all(target_arch = "arm", target_os = "none"))']
# uncomment ONE of these three option to make `cargo run` start a GDB session
# which option to pick depends on your system
# runner = "arm-none-eabi-gdb -q -x openocd.gdb"
# runner = "gdb-multiarch -q -x openocd.gdb"
# runner = "gdb -q -x openocd.gdb"

rustflags = [
  # LLD (shipped with the Rust toolchain) is used as the default linker
  "-C", "link-arg=-Tlink.x",

  # if you run into problems with LLD switch to the GNU linker by commenting out
  # this line
  # "-C", "linker=arm-none-eabi-ld",

  # if you need to link to pre-compiled C libraries provided by a C toolchain
  # use GCC as the linker by commenting out both lines above and then
  # uncommenting the three lines below
  # "-C", "linker=arm-none-eabi-gcc",
  # "-C", "link-arg=-Wl,-Tlink.x",
  # "-C", "link-arg=-nostartfiles",
]