systemd sd_bus_set_close_on_exit 3 sd_bus_set_close_on_exit sd_bus_get_close_on_exit Control whether to close the bus connection during the event loop exit phase #include <systemd/sd-bus.h> int sd_bus_set_close_on_exit sd_bus *bus int b int sd_bus_get_close_on_exit sd_bus *bus sd_bus_set_close_on_exit() may be used to enable or disable whether the bus connection is automatically flushed (as in sd_bus_flush3) and closed (as in sd_bus_close3) during the exit phase of the event loop. This logic only applies to bus connections that are attached to an sd-event3 event loop, see sd_bus_attach_event3. By default this mechanism is enabled and makes sure that any pending messages that have not been written to the bus connection are written out when the event loop is shutting down. In some cases this behaviour is not desirable, for example when the bus connection shall remain usable until after the event loop exited. If b is true, the feature is enabled (which is the default), otherwise disabled. sd_bus_get_close_on_exit() may be used to query the current setting of this feature. It returns zero when the feature is disabled, and positive if enabled. On success, sd_bus_set_close_on_exit() returns a non-negative integer. On failure, it returns a negative errno-style error code. sd_bus_get_close_on_exit() returns 0 if the feature is currently disabled or a positive integer if it is enabled. On failure, it returns a negative errno-style error code. Returned errors may indicate the following problems: -ECHILD The bus connection was created in a different process, library or module instance. sd_bus_set_close_on_exit() and sd_bus_get_close_on_exit() were added in version 240. systemd1 sd-bus3 sd_bus_flush3 sd_bus_attach_event3 sd-event3 sd_event_add_exit3