#!gmake
# -*- Mode: Makefile -*-
# 
# ***** BEGIN LICENSE BLOCK *****
# Version: MPL 1.1/GPL 2.0/LGPL 2.1
#
# The contents of this file are subject to the Mozilla Public License Version
# 1.1 (the "License"); you may not use this file except in compliance with
# the License. You may obtain a copy of the License at
# http://www.mozilla.org/MPL/
#
# Software distributed under the License is distributed on an "AS IS" basis,
# WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
# for the specific language governing rights and limitations under the
# License.
#
# The Original Code is the Netscape Portable Runtime (NSPR).
#
# The Initial Developer of the Original Code is
# Netscape Communications Corporation.
# Portions created by the Initial Developer are Copyright (C) 2001
# the Initial Developer. All Rights Reserved.
#
# Contributor(s):
#
# Alternatively, the contents of this file may be used under the terms of
# either the GNU General Public License Version 2 or later (the "GPL"), or
# the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
# in which case the provisions of the GPL or the LGPL are applicable instead
# of those above. If you wish to allow use of your version of this file only
# under the terms of either the GPL or the LGPL, and not to allow others to
# use your version of this file under the terms of the MPL, indicate your
# decision by deleting the provisions above and replace them with the notice
# and other provisions required by the GPL or the LGPL. If you do not delete
# the provisions above, a recipient may use your version of this file under
# the terms of any one of the MPL, the GPL or the LGPL.
#
# ***** END LICENSE BLOCK *****


ifndef MOZ_SRC_FLIPPED
$(error MOZ_SRC_FLIPPED is not set)
endif

ifndef MOZ_TOP
MOZ_TOP=mozilla
endif

MOZ_DIST_FLIPPED = $(MOZ_SRC_FLIPPED)/mozilla/dist

ifdef MOZ_DEBUG
MOZ_OBJDIR = WIN32_D.OBJ
else
MOZ_OBJDIR = WIN32_O.OBJ
endif

NSPR_CONFIGURE := ../configure \
		--with-mozilla \
		--with-dist-prefix=$(MOZ_DIST_FLIPPED) \
		--with-dist-bindir=$(MOZ_DIST_FLIPPED)/$(MOZ_OBJDIR)/bin \
		--with-dist-libdir=$(MOZ_DIST_FLIPPED)/$(MOZ_OBJDIR)/lib

ifeq (,$(MOZ_DEBUG)$(MOZ_TRACE_MALLOC))
NSPR_CONFIGURE := $(NSPR_CONFIGURE) --enable-optimize --disable-debug
endif

define MAKE_OBJDIR
if test ! -d $(@D) ; then rm -rf $(@D) ; nsinstall -D $(@D) ; fi
endef


all:: build_all

# Argh.  nmake keeps the cwd from cmd to cmd and gmake does not
# Furthermore, shmsdos doesn't support '&&' so there's a chance the
# 'cd' could fail and configure would be run in the wrong dir
#
$(MOZ_OBJDIR)/config.status: configure configure.in
	@$(MAKE_OBJDIR) 
	cd $(MOZ_OBJDIR)/ ; \
		sh $(NSPR_CONFIGURE)

build_all: $(MOZ_OBJDIR)/config.status check_old
	gmake -C $(MOZ_OBJDIR)

clobber_all: $(MOZ_OBJDIR)/config.status check_old
	gmake -C $(MOZ_OBJDIR) clobber_all

distclean: check_old
	rm -rf WIN32_D.OBJ WIN32_O.OBJ

check_old:
	@if test -f Makefile; then gmake distclean; fi