Adding upstream version 6.1.76.upstream/6.1.76

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 204 insertions, 0 deletions

diff --git a/include/scsi/fc/fc_fcp.h b/include/scsi/fc/fc_fcp.h
new file mode 100644
index 000000000..4b968448f
--- /dev/null
+++ b/include/scsi/fc/fc_fcp.h
@@ -0,0 +1,204 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+/*
+ * Copyright(c) 2007 Intel Corporation. All rights reserved.
+ *
+ * Maintained at www.Open-FCoE.org
+ */
+
+#ifndef _FC_FCP_H_
+#define	_FC_FCP_H_
+
+#include <scsi/scsi.h>
+
+/*
+ * Fibre Channel Protocol for SCSI.
+ * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
+ */
+
+/*
+ * fc/fs.h defines FC_TYPE_FCP.
+ */
+
+/*
+ * Service parameter page parameters (word 3 bits) for Process Login.
+ */
+#define	FCP_SPPF_TASK_RETRY_ID	0x0200	/* task retry ID requested */
+#define	FCP_SPPF_RETRY		0x0100	/* retry supported */
+#define	FCP_SPPF_CONF_COMPL	0x0080	/* confirmed completion allowed */
+#define	FCP_SPPF_OVLY_ALLOW	0x0040	/* data overlay allowed */
+#define	FCP_SPPF_INIT_FCN	0x0020	/* initiator function */
+#define	FCP_SPPF_TARG_FCN	0x0010	/* target function */
+#define	FCP_SPPF_RD_XRDY_DIS	0x0002	/* disable XFER_RDY for reads */
+#define	FCP_SPPF_WR_XRDY_DIS	0x0001	/* disable XFER_RDY for writes */
+
+/*
+ * FCP_CMND IU Payload.
+ */
+struct fcp_cmnd {
+	struct scsi_lun	fc_lun;		/* logical unit number */
+	__u8		fc_cmdref;	/* command reference number */
+	__u8		fc_pri_ta;	/* priority and task attribute */
+	__u8		fc_tm_flags;	/* task management flags */
+	__u8		fc_flags;	/* additional len & flags */
+	__u8		fc_cdb[16];	/* base CDB */
+	__be32		fc_dl;		/* data length (must follow fc_cdb) */
+};
+
+#define	FCP_CMND_LEN	32	/* expected length of structure */
+
+struct fcp_cmnd32 {
+	struct scsi_lun	fc_lun;		/* logical unit number */
+	__u8		fc_cmdref;	/* command reference number */
+	__u8		fc_pri_ta;	/* priority and task attribute */
+	__u8		fc_tm_flags;	/* task management flags */
+	__u8		fc_flags;	/* additional len & flags */
+	__u8		fc_cdb[32];	/* base CDB */
+	__be32		fc_dl;		/* data length (must follow fc_cdb) */
+};
+
+#define	FCP_CMND32_LEN	    48	/* expected length of structure */
+#define	FCP_CMND32_ADD_LEN  (16 / 4)	/* Additional cdb length */
+
+/*
+ * fc_pri_ta.
+ */
+#define	FCP_PTA_SIMPLE	    0	/* simple task attribute */
+#define	FCP_PTA_HEADQ	    1	/* head of queue task attribute */
+#define	FCP_PTA_ORDERED     2	/* ordered task attribute */
+#define	FCP_PTA_ACA	    4	/* auto. contingent allegiance */
+#define	FCP_PTA_MASK	    7	/* mask for task attribute field */
+#define	FCP_PRI_SHIFT	    3	/* priority field starts in bit 3 */
+#define	FCP_PRI_RESVD_MASK  0x80	/* reserved bits in priority field */
+
+/*
+ * fc_tm_flags - task management flags field.
+ */
+#define	FCP_TMF_CLR_ACA		0x40	/* clear ACA condition */
+#define	FCP_TMF_TGT_RESET	0x20	/* target reset task management,
+					   deprecated as of FCP-3 */
+#define	FCP_TMF_LUN_RESET	0x10	/* logical unit reset task management */
+#define	FCP_TMF_CLR_TASK_SET	0x04	/* clear task set */
+#define	FCP_TMF_ABT_TASK_SET	0x02	/* abort task set */
+
+/*
+ * fc_flags.
+ *  Bits 7:2 are the additional FCP_CDB length / 4.
+ */
+#define	FCP_CFL_LEN_MASK	0xfc	/* mask for additional length */
+#define	FCP_CFL_LEN_SHIFT	2	/* shift bits for additional length */
+#define	FCP_CFL_RDDATA		0x02	/* read data */
+#define	FCP_CFL_WRDATA		0x01	/* write data */
+
+/*
+ * FCP_TXRDY IU - transfer ready payload.
+ */
+struct fcp_txrdy {
+	__be32		ft_data_ro;	/* data relative offset */
+	__be32		ft_burst_len;	/* burst length */
+	__u8		_ft_resvd[4];	/* reserved */
+};
+
+#define	FCP_TXRDY_LEN	12	/* expected length of structure */
+
+/*
+ * FCP_RESP IU - response payload.
+ *
+ * The response payload comes in three parts: the flags/status, the
+ * sense/response lengths and the sense data/response info section.
+ *
+ * From FCP3r04, note 6 of section 9.5.13:
+ *
+ * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
+ * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
+ * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
+ * non-standard behavior should be tolerated.
+ *
+ * All response frames will always contain the fcp_resp template.  Some
+ * will also include the fcp_resp_len template.
+ *
+ * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
+ * are valid length.
+ */
+struct fcp_resp {
+	__u8		_fr_resvd[8];	/* reserved */
+	__be16		fr_retry_delay;	/* retry delay timer */
+	__u8		fr_flags;	/* flags */
+	__u8		fr_status;	/* SCSI status code */
+};
+
+#define	FCP_RESP_LEN	12	/* expected length of structure */
+
+struct fcp_resp_ext {
+	__be32		fr_resid;	/* Residual value */
+	__be32		fr_sns_len;	/* SCSI Sense length */
+	__be32		fr_rsp_len;	/* Response Info length */
+
+	/*
+	 * Optionally followed by RSP info and/or SNS info and/or
+	 * bidirectional read residual length, if any.
+	 */
+};
+
+#define FCP_RESP_EXT_LEN    12  /* expected length of the structure */
+
+struct fcp_resp_rsp_info {
+    __u8      _fr_resvd[3];       /* reserved */
+    __u8      rsp_code;           /* Response Info Code */
+    __u8      _fr_resvd2[4];      /* reserved */
+};
+
+#define FCP_RESP_RSP_INFO_LEN4    4 /* without reserved field */
+#define FCP_RESP_RSP_INFO_LEN8    8 /* with reserved field */
+
+struct fcp_resp_with_ext {
+	struct fcp_resp resp;
+	struct fcp_resp_ext ext;
+};
+
+#define	FCP_RESP_WITH_EXT   (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
+
+/*
+ * fr_flags.
+ */
+#define	FCP_BIDI_RSP	    0x80	/* bidirectional read response */
+#define	FCP_BIDI_READ_UNDER 0x40	/* bidir. read less than requested */
+#define	FCP_BIDI_READ_OVER  0x20	/* DL insufficient for full transfer */
+#define	FCP_CONF_REQ	    0x10	/* confirmation requested */
+#define	FCP_RESID_UNDER     0x08	/* transfer shorter than expected */
+#define	FCP_RESID_OVER	    0x04	/* DL insufficient for full transfer */
+#define	FCP_SNS_LEN_VAL     0x02	/* SNS_LEN field is valid */
+#define	FCP_RSP_LEN_VAL     0x01	/* RSP_LEN field is valid */
+
+/*
+ * rsp_codes
+ */
+enum fcp_resp_rsp_codes {
+	FCP_TMF_CMPL = 0,
+	FCP_DATA_LEN_INVALID = 1,
+	FCP_CMND_FIELDS_INVALID = 2,
+	FCP_DATA_PARAM_MISMATCH = 3,
+	FCP_TMF_REJECTED = 4,
+	FCP_TMF_FAILED = 5,
+	FCP_TMF_INVALID_LUN = 9,
+};
+
+/*
+ * FCP SRR Link Service request - Sequence Retransmission Request.
+ */
+struct fcp_srr {
+	__u8		srr_op;		/* opcode ELS_SRR */
+	__u8		srr_resvd[3];	/* opcode / reserved - must be zero */
+	__be16		srr_ox_id;	/* OX_ID of failed command */
+	__be16		srr_rx_id;	/* RX_ID of failed command */
+	__be32		srr_rel_off;	/* relative offset */
+	__u8		srr_r_ctl;	/* r_ctl for the information unit */
+	__u8		srr_resvd2[3];	/* reserved */
+};
+
+/*
+ * Feature bits in name server FC-4 Features object.
+ */
+#define	FCP_FEAT_TARG	(1 << 0)	/* target function supported */
+#define	FCP_FEAT_INIT	(1 << 1)	/* initiator function supported */
+
+#endif /* _FC_FCP_H_ */