From 2c3c1048746a4622d8c89a29670120dc8fab93c4 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sun, 7 Apr 2024 20:49:45 +0200 Subject: Adding upstream version 6.1.76. Signed-off-by: Daniel Baumann --- .../devicetree/bindings/pinctrl/pinctrl-sirf.txt | 47 ++++++++++++++++++++++ 1 file changed, 47 insertions(+) create mode 100644 Documentation/devicetree/bindings/pinctrl/pinctrl-sirf.txt (limited to 'Documentation/devicetree/bindings/pinctrl/pinctrl-sirf.txt') diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-sirf.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-sirf.txt new file mode 100644 index 000000000..f8420520e --- /dev/null +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-sirf.txt @@ -0,0 +1,47 @@ +CSR SiRFprimaII pinmux controller + +Required properties: +- compatible : "sirf,prima2-pinctrl" +- reg : Address range of the pinctrl registers +- interrupts : Interrupts used by every GPIO group +- gpio-controller : Indicates this device is a GPIO controller +- interrupt-controller : Marks the device node as an interrupt controller +Optional properties: +- sirf,pullups : if n-th bit of m-th bank is set, set a pullup on GPIO-n of bank m +- sirf,pulldowns : if n-th bit of m-th bank is set, set a pulldown on GPIO-n of bank m + +Please refer to pinctrl-bindings.txt in this directory for details of the common +pinctrl bindings used by client devices. + +SiRFprimaII's pinmux nodes act as a container for an arbitrary number of subnodes. +Each of these subnodes represents some desired configuration for a group of pins. + +Required subnode-properties: +- sirf,pins : An array of strings. Each string contains the name of a group. +- sirf,function: A string containing the name of the function to mux to the + group. + + Valid values for group and function names can be found from looking at the + group and function arrays in driver files: + drivers/pinctrl/pinctrl-sirf.c + +For example, pinctrl might have subnodes like the following: + uart2_pins_a: uart2@0 { + uart { + sirf,pins = "uart2grp"; + sirf,function = "uart2"; + }; + }; + uart2_noflow_pins_a: uart2@1 { + uart { + sirf,pins = "uart2_nostreamctrlgrp"; + sirf,function = "uart2_nostreamctrl"; + }; + }; + +For a specific board, if it wants to use uart2 without hardware flow control, +it can add the following to its board-specific .dts file. +uart2: uart@b0070000 { + pinctrl-names = "default"; + pinctrl-0 = <&uart2_noflow_pins_a>; +} -- cgit v1.2.3