/* -*- Mode: C++; tab-width: 4; indent-tabs-mode: nil; c-basic-offset: 4 -*- */
/*
 * This file is part of the LibreOffice project.
 *
 * This Source Code Form is subject to the terms of the Mozilla Public
 * License, v. 2.0. If a copy of the MPL was not distributed with this
 * file, You can obtain one at http://mozilla.org/MPL/2.0/.
 *
 * This file incorporates work covered by the following license notice:
 *
 *   Licensed to the Apache Software Foundation (ASF) under one or more
 *   contributor license agreements. See the NOTICE file distributed
 *   with this work for additional information regarding copyright
 *   ownership. The ASF licenses this file to you under the Apache
 *   License, Version 2.0 (the "License"); you may not use this file
 *   except in compliance with the License. You may obtain a copy of
 *   the License at http://www.apache.org/licenses/LICENSE-2.0 .
 */
#ifndef __com_sun_star_frame_status_ItemState_idl__
#define __com_sun_star_frame_status_ItemState_idl__



module com {  module sun {  module star {  module frame { module status {


/** these constants describe a state of an ItemStatus.

    @see ItemStatus

    @since OOo 2.0
 */
constants ItemState
{
    /** specifies an unknown state.
     */
    const short UNKNOWN        = 0;

    /** specifies that the property is currently disabled.
     */
    const short DISABLED       = 1;

    /** specifies that the property is currently read-only.
     *
     * Deprecated: There is no equivalent in SfxItemState
     * anymore due to not being used, so remove for simplification
     * reasons and to prepare rework of Item/ItemSet/ItemPool stuff.
     *
     * There are only three usages of com::sun::star::frame::status::ItemState
     * in the code which all set the internal SfxItem to SfxVoidItem when
     * triggered, which is equivalent to state SfxItemState::DISABLED (see e.g.
     * SfxItemSet::GetItemState), so READ_ONLY gets not used in internal
     * handling, even when eventually existing UNO API usages hand it over the
     * office.
     */
    const short READ_ONLY      = 2;

    /** specifies that the property is currently in a don't care state.

        <p>
        This is normally used if a selection provides more than one state
        for a property at the same time.
        </p>
     */
    const short DONT_CARE      = 16;

    /** specifies that the property is currently in a default state.
    */
    const short DEFAULT_VALUE  = 32;

    /** specifies that the property is currently in a set state.
    */
    const short SET            = 64;
};


}; }; }; }; };

#endif

/* vim:set shiftwidth=4 softtabstop=4 expandtab: */