Adding upstream version 6.1.76.upstream/6.1.76upstream

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 50 insertions, 0 deletions

diff --git a/drivers/infiniband/ulp/ipoib/Kconfig b/drivers/infiniband/ulp/ipoib/Kconfig
new file mode 100644
index 000000000..254e31a90
--- /dev/null
+++ b/drivers/infiniband/ulp/ipoib/Kconfig
@@ -0,0 +1,50 @@
+# SPDX-License-Identifier: GPL-2.0-only
+config INFINIBAND_IPOIB
+	tristate "IP-over-InfiniBand"
+	depends on NETDEVICES && INET && (IPV6 || IPV6=n)
+	help
+	  Support for the IP-over-InfiniBand protocol (IPoIB). This
+	  transports IP packets over InfiniBand so you can use your IB
+	  device as a fancy NIC.
+
+	  See Documentation/infiniband/ipoib.rst for more information
+
+config INFINIBAND_IPOIB_CM
+	bool "IP-over-InfiniBand Connected Mode support"
+	depends on INFINIBAND_IPOIB
+	default n
+	help
+	  This option enables support for IPoIB connected mode.  After
+	  enabling this option, you need to switch to connected mode
+	  through /sys/class/net/ibXXX/mode to actually create
+	  connections, and then increase the interface MTU with
+	  e.g. ifconfig ib0 mtu 65520.
+
+	  WARNING: Enabling connected mode will trigger some packet
+	  drops for multicast and UD mode traffic from this interface,
+	  unless you limit mtu for these destinations to 2044.
+
+config INFINIBAND_IPOIB_DEBUG
+	bool "IP-over-InfiniBand debugging" if EXPERT
+	depends on INFINIBAND_IPOIB
+	default y
+	help
+	  This option causes debugging code to be compiled into the
+	  IPoIB driver.  The output can be turned on via the
+	  debug_level and mcast_debug_level module parameters (which
+	  can also be set after the driver is loaded through sysfs).
+
+	  This option also creates a directory tree under ipoib/ in
+	  debugfs, which contains files that expose debugging
+	  information about IB multicast groups used by the IPoIB
+	  driver.
+
+config INFINIBAND_IPOIB_DEBUG_DATA
+	bool "IP-over-InfiniBand data path debugging"
+	depends on INFINIBAND_IPOIB_DEBUG
+	help
+	  This option compiles debugging code into the data path
+	  of the IPoIB driver.  The output can be turned on via the
+	  data_debug_level module parameter; however, even with output
+	  turned off, this debugging code will have some performance
+	  impact.