From 2c3c1048746a4622d8c89a29670120dc8fab93c4 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sun, 7 Apr 2024 20:49:45 +0200 Subject: Adding upstream version 6.1.76. Signed-off-by: Daniel Baumann --- .../bindings/net/marvell-armada-370-neta.txt | 50 ++++++++++++++++++++++ 1 file changed, 50 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt (limited to 'Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt') diff --git a/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt b/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt new file mode 100644 index 000000000..2bf31572b --- /dev/null +++ b/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt @@ -0,0 +1,50 @@ +* Marvell Armada 370 / Armada XP / Armada 3700 Ethernet Controller (NETA) + +Required properties: +- compatible: could be one of the following: + "marvell,armada-370-neta" + "marvell,armada-xp-neta" + "marvell,armada-3700-neta" + "marvell,armada-ac5-neta" +- reg: address and length of the register set for the device. +- interrupts: interrupt for the device +- phy: See ethernet.txt file in the same directory. +- phy-mode: See ethernet.txt file in the same directory +- clocks: List of clocks for this device. At least one clock is + mandatory for the core clock. If several clocks are given, then the + clock-names property must be used to identify them. + +Optional properties: +- tx-csum-limit: maximum mtu supported by port that allow TX checksum. + Value is presented in bytes. If not used, by default 1600B is set for + "marvell,armada-370-neta" and 9800B for others. +- clock-names: List of names corresponding to clocks property; shall be + "core" for core clock and "bus" for the optional bus clock. +- phys: comphy for the ethernet port, see ../phy/phy-bindings.txt + +Optional properties (valid only for Armada XP/38x): + +- buffer-manager: a phandle to a buffer manager node. Please refer to + Documentation/devicetree/bindings/net/marvell-neta-bm.txt +- bm,pool-long: ID of a pool, that will accept all packets of a size + higher than 'short' pool's threshold (if set) and up to MTU value. + Obligatory, when the port is supposed to use hardware + buffer management. +- bm,pool-short: ID of a pool, that will be used for accepting + packets of a size lower than given threshold. If not set, the port + will use a single 'long' pool for all packets, as defined above. + +Example: + +ethernet@70000 { + compatible = "marvell,armada-370-neta"; + reg = <0x70000 0x2500>; + interrupts = <8>; + clocks = <&gate_clk 4>; + tx-csum-limit = <9800> + phy = <&phy0>; + phy-mode = "rgmii-id"; + buffer-manager = <&bm>; + bm,pool-long = <0>; + bm,pool-short = <1>; +}; -- cgit v1.2.3