From 2c3c1048746a4622d8c89a29670120dc8fab93c4 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sun, 7 Apr 2024 20:49:45 +0200 Subject: Adding upstream version 6.1.76. Signed-off-by: Daniel Baumann --- .../devicetree/bindings/sound/cs53l30.txt | 44 ++++++++++++++++++++++ 1 file changed, 44 insertions(+) create mode 100644 Documentation/devicetree/bindings/sound/cs53l30.txt (limited to 'Documentation/devicetree/bindings/sound/cs53l30.txt') diff --git a/Documentation/devicetree/bindings/sound/cs53l30.txt b/Documentation/devicetree/bindings/sound/cs53l30.txt new file mode 100644 index 000000000..4dbfb8274 --- /dev/null +++ b/Documentation/devicetree/bindings/sound/cs53l30.txt @@ -0,0 +1,44 @@ +CS53L30 audio CODEC + +Required properties: + + - compatible : "cirrus,cs53l30" + + - reg : the I2C address of the device + + - VA-supply, VP-supply : power supplies for the device, + as covered in Documentation/devicetree/bindings/regulator/regulator.txt. + +Optional properties: + + - reset-gpios : a GPIO spec for the reset pin. + + - mute-gpios : a GPIO spec for the MUTE pin. The active state can be either + GPIO_ACTIVE_HIGH or GPIO_ACTIVE_LOW, which would be handled + by the driver automatically. + + - cirrus,micbias-lvl : Set the output voltage level on the MICBIAS Pin. + 0 = Hi-Z + 1 = 1.80 V + 2 = 2.75 V + + - cirrus,use-sdout2 : This is a boolean property. If present, it indicates + the hardware design connects both SDOUT1 and SDOUT2 + pins to output data. Otherwise, it indicates that + only SDOUT1 is connected for data output. + * CS53l30 supports 4-channel data output in the same + * frame using two different ways: + * 1) Normal I2S mode on two data pins -- each SDOUT + * carries 2-channel data in the same time. + * 2) TDM mode on one signle data pin -- SDOUT1 carries + * 4-channel data per frame. + +Example: + +codec: cs53l30@48 { + compatible = "cirrus,cs53l30"; + reg = <0x48>; + reset-gpios = <&gpio 54 0>; + VA-supply = <&cs53l30_va>; + VP-supply = <&cs53l30_vp>; +}; -- cgit v1.2.3