From 2c3c1048746a4622d8c89a29670120dc8fab93c4 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sun, 7 Apr 2024 20:49:45 +0200 Subject: Adding upstream version 6.1.76. Signed-off-by: Daniel Baumann --- drivers/net/ethernet/qualcomm/Kconfig | 65 +++++++++++++++++++++++++++++++++++ 1 file changed, 65 insertions(+) create mode 100644 drivers/net/ethernet/qualcomm/Kconfig (limited to 'drivers/net/ethernet/qualcomm/Kconfig') diff --git a/drivers/net/ethernet/qualcomm/Kconfig b/drivers/net/ethernet/qualcomm/Kconfig new file mode 100644 index 000000000..a4434eb38 --- /dev/null +++ b/drivers/net/ethernet/qualcomm/Kconfig @@ -0,0 +1,65 @@ +# SPDX-License-Identifier: GPL-2.0-only +# +# Qualcomm network device configuration +# + +config NET_VENDOR_QUALCOMM + bool "Qualcomm devices" + default y + help + If you have a network (Ethernet) card belonging to this class, say Y. + + Note that the answer to this question doesn't directly affect the + kernel: saying N will just cause the configurator to skip all + the questions about Qualcomm cards. If you say Y, you will be asked + for your specific card in the following questions. + +if NET_VENDOR_QUALCOMM + +config QCA7000 + tristate + help + This enables support for the Qualcomm Atheros QCA7000. + +config QCA7000_SPI + tristate "Qualcomm Atheros QCA7000 SPI support" + select QCA7000 + depends on SPI_MASTER && OF + help + This SPI protocol driver supports the Qualcomm Atheros QCA7000. + + To compile this driver as a module, choose M here. The module + will be called qcaspi. + +config QCA7000_UART + tristate "Qualcomm Atheros QCA7000 UART support" + select QCA7000 + depends on SERIAL_DEV_BUS && OF + help + This UART protocol driver supports the Qualcomm Atheros QCA7000. + + Currently the driver assumes these device UART settings: + Data bits: 8 + Parity: None + Stop bits: 1 + Flow control: None + + To compile this driver as a module, choose M here. The module + will be called qcauart. + +config QCOM_EMAC + tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support" + depends on HAS_DMA && HAS_IOMEM + select CRC32 + select PHYLIB + help + This driver supports the Qualcomm Technologies, Inc. Gigabit + Ethernet Media Access Controller (EMAC). The controller + supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, + full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for + low power, Receive-Side Scaling (RSS), and IEEE 1588-2008 + Precision Clock Synchronization Protocol. + +source "drivers/net/ethernet/qualcomm/rmnet/Kconfig" + +endif # NET_VENDOR_QUALCOMM -- cgit v1.2.3