From 2c3c1048746a4622d8c89a29670120dc8fab93c4 Mon Sep 17 00:00:00 2001 From: Daniel Baumann Date: Sun, 7 Apr 2024 20:49:45 +0200 Subject: Adding upstream version 6.1.76. Signed-off-by: Daniel Baumann --- drivers/usb/common/Kconfig | 51 ++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 51 insertions(+) create mode 100644 drivers/usb/common/Kconfig (limited to 'drivers/usb/common/Kconfig') diff --git a/drivers/usb/common/Kconfig b/drivers/usb/common/Kconfig new file mode 100644 index 000000000..b85662243 --- /dev/null +++ b/drivers/usb/common/Kconfig @@ -0,0 +1,51 @@ +# SPDX-License-Identifier: GPL-2.0 + +config USB_COMMON + tristate + + +config USB_LED_TRIG + bool "USB LED Triggers" + depends on LEDS_CLASS && USB_COMMON && LEDS_TRIGGERS + help + This option adds LED triggers for USB host and/or gadget activity. + + Say Y here if you are working on a system with led-class supported + LEDs and you want to use them as activity indicators for USB host or + gadget. + +config USB_ULPI_BUS + tristate "USB ULPI PHY interface support" + select USB_COMMON + help + UTMI+ Low Pin Interface (ULPI) is specification for a commonly used + USB 2.0 PHY interface. The ULPI specification defines a standard set + of registers that can be used to detect the vendor and product which + allows ULPI to be handled as a bus. This module is the driver for that + bus. + + The ULPI interfaces (the buses) are registered by the drivers for USB + controllers which support ULPI register access and have ULPI PHY + attached to them. The ULPI PHY drivers themselves are normal PHY + drivers. + + ULPI PHYs provide often functions such as ADP sensing/probing (OTG + protocol) and USB charger detection. + + To compile this driver as a module, choose M here: the module will + be called ulpi. + +config USB_CONN_GPIO + tristate "USB GPIO Based Connection Detection Driver" + depends on GPIOLIB + select USB_ROLE_SWITCH + select POWER_SUPPLY + help + The driver supports USB role switch between host and device via GPIO + based USB cable detection, used typically if an input GPIO is used + to detect USB ID pin, and another input GPIO may be also used to detect + Vbus pin at the same time, it also can be used to enable/disable + device if an input GPIO is only used to detect Vbus pin. + + To compile the driver as a module, choose M here: the module will + be called usb-conn-gpio.ko -- cgit v1.2.3