Adding upstream version 1.6~pre2.upstream/1.6_pre2

Signed-off-by: Daniel Baumann <daniel@debian.org>

1 files changed, 8 insertions, 7 deletions

diff --git a/doc/lzip.texinfo b/doc/lzip.texinfo
index f29b29e..87e223f 100644
--- a/doc/lzip.texinfo
+++ b/doc/lzip.texinfo
@@ -5,8 +5,8 @@
 @finalout
 @c %**end of header
 
-@set UPDATED 27 April 2009
-@set VERSION 1.6-pre1
+@set UPDATED 21 May 2009
+@set VERSION 1.6-pre2
 
 @dircategory Data Compression
 @direntry
@@ -84,11 +84,12 @@ compressed output in volumes of a given size, even when reading from
 standard input. This allows the direct creation of multivolume
 compressed tar archives.
 
-The amount of memory required for compression is about 2 times the
-dictionary size limit plus 8 times the dictionary size really used. For
-decompression is a little more than the dictionary size really used.
-Lzip will automatically use the smallest possible dictionary size for
-each member without exceeding the given limit. It is important to
+The amount of memory required for compression is about 5 MiB plus 1 or 2
+times the dictionary size limit (1 if input file size is less than
+dictionary size limit, else 2) plus 8 times the dictionary size really
+used. For decompression is a little more than the dictionary size really
+used. Lzip will automatically use the smallest possible dictionary size
+for each member without exceeding the given limit. It is important to
 appreciate that the decompression memory requirement is affected at
 compression time by the choice of dictionary size limit.