diff options
Diffstat (limited to 'collectors/charts.d.plugin/ap')
| -rw-r--r-- | collectors/charts.d.plugin/ap/README.md | 46 |
1 files changed, 23 insertions, 23 deletions
diff --git a/collectors/charts.d.plugin/ap/README.md b/collectors/charts.d.plugin/ap/README.md index 962a8565..befe21ee 100644 --- a/collectors/charts.d.plugin/ap/README.md +++ b/collectors/charts.d.plugin/ap/README.md @@ -2,7 +2,7 @@ The `ap` collector visualizes data related to access points. -## Example netdata charts +## Example Netdata charts  @@ -10,11 +10,12 @@ The `ap` collector visualizes data related to access points. It does the following: -1. Runs `iw dev` searching for interfaces that have `type AP`. +1. Runs `iw dev` searching for interfaces that have `type AP`. - From the same output it collects the SSIDs each AP supports by looking for lines `ssid NAME`. + From the same output it collects the SSIDs each AP supports by looking for lines `ssid NAME`. + + Example: - Example: ```sh # iw dev phy#0 @@ -27,20 +28,19 @@ phy#0 channel 7 (2442 MHz), width: 20 MHz, center1: 2442 MHz ``` +2. For each interface found, it runs `iw INTERFACE station dump`. -2. For each interface found, it runs `iw INTERFACE station dump`. - - From the output is collects: + From the output is collects: - - rx/tx bytes - - rx/tx packets - - tx retries - - tx failed - - signal strength - - rx/tx bitrate - - expected throughput + - rx/tx bytes + - rx/tx packets + - tx retries + - tx failed + - signal strength + - rx/tx bitrate + - expected throughput - Example: + Example: ```sh # iw wlan0 station dump @@ -65,14 +65,14 @@ Station 40:b8:37:5a:ed:5e (on wlan0) TDLS peer: no ``` -3. For each interface found, it creates 6 charts: +3. For each interface found, it creates 6 charts: - - Number of Connected clients - - Bandwidth for all clients - - Packets for all clients - - Transmit Issues for all clients - - Average Signal among all clients - - Average Bitrate (including average expected throughput) among all clients + - Number of Connected clients + - Bandwidth for all clients + - Packets for all clients + - Transmit Issues for all clients + - Average Signal among all clients + - Average Bitrate (including average expected throughput) among all clients ## Configuration @@ -83,4 +83,4 @@ To edit this file on your system run `/etc/netdata/edit-config charts.d/ap.conf` The plugin is able to auto-detect if you are running access points on your linux box. -[]() +[](<>) |